Please see the current Washtenaw Community College catalog for up-to-date program requirements Secondary / Post-Secondary Program Alignment Welding HIGH SCHOOL COURSE SEQUENCE 9th Grade 10th Grade 11th Grade 12th Grade English 9 Algebra I World History/Geography Biology World Language Phys Ed/Health English 10 Geometry U.S. History/Geography Physics or Chemistry World Language Visual/Performing/Applied Arts English 11 Algebra II Civics/Economics Welding English 12 Math Credit Science Credit Welding WASHTENAW COMMUNITY COLLEGE Welding Associate in Applied Science Semester 1 Math Elective(s)* 3 WAF 105 Introduction to Welding Processes 2 WAF 111 Oxy-fuel Welding 4 WAF 112 Shielded Metal Arc Welding 4 Semester Total 13 Semester 2 Speech Elective(s) 3 WAF 106 Blueprint Reading for Welders 3 WAF 123 Advanced Oxy-fuel Welding 4 WAF 124 Advanced Shielded Metal Arc Welding 4 Semester Total 14 Semester 3 Arts/Human. Elective(s) 3 Computer Lit. Elective(s) 3 WAF 215 Advanced Gas Tungsten Arc Welding 4 WAF 288 Gas Metal Arc Welding 4 Semester Total 14 Semester 4 WAF 200 Layout Theory Welding 3 WAF 210 Welding Metallurgy 3 Soc. Sci. Elective(s) 3 WAF 226 Specialized Welding Procedures 4 Semester Total 13 Semester 5 Nat. Sci. Elective(s) 4 WAF 227 Basic Fabrication 3 WAF 229 Shape Cutting Operations 3 Writing Elective(s) 3 Semester Total 13 Program Totals 67
Formation of Agreement A. No agreement between the Parties is formed until all applicable actions have been completed to the satisfaction of Valley Water. Valley Water Project Manager will not issue a Notice to Proceed until all required documents have been submitted and accepted by Valley Water.
Declaration of Trust The Owner Trustee hereby declares that it will hold the Owner Trust Estate in trust upon and subject to the conditions set forth herein for the use and benefit of the Certificateholders, subject to the obligations of the Trust under the Basic Documents. It is the intention of the parties hereto that the Trust constitute a statutory trust under the Statutory Trust Act and that this Agreement constitute the governing instrument of such statutory trust. The Trust is not intended to be a business trust within the meaning of Section 101(9)(A)(v) of the Bankruptcy Code. It is also the intention of the parties hereto that, solely for Federal, state and local income and franchise tax purposes, on and after the Closing Date, (a) so long as the Trust has only one Certificateholder, the Trust shall be disregarded as a separate entity and (b) at such time as the Trust has more than one Certificateholder, the Trust will be treated as a partnership, with the assets of the partnership being the Receivables and other assets held by the Trust, the partners of the partnership being the Certificateholders, and the Notes being non-recourse debt of the partnership. The Depositor (and any future Certificateholder by the purchase of the Trust Certificate will be deemed to have agreed) and the Owner Trustee agree to take no action inconsistent with such tax treatment. The Trust shall not elect to be treated as an association under Treasury Regulations Section 301.7701-3(a). The parties agree that, unless otherwise required by appropriate tax authorities, the sole Certificateholder or the Trust, as applicable, will file or cause to be filed annual or other necessary returns, reports and other forms consistent with the foregoing characterization of the Trust for such tax purposes. Effective as of the date hereof, the Owner Trustee, shall have all rights, powers and duties set forth herein and, to the extent not inconsistent herewith, in the Statutory Trust Act with respect to accomplishing the purposes of the Trust. Any action taken on behalf of the Trust prior to the date hereof with respect to the filing of financing statements, the Certificate of Trust, a qualification to do business in the State of Alabama or any other similar qualification or license in any other state or jurisdiction, if applicable, is hereby ratified.
Creation and Designation There is hereby created a Tranche of Class A Notes to be issued pursuant to this Terms Document, the Indenture and the Indenture Supplement to be known as the “DiscoverSeries Class A(2018-6) Notes.”
Limitation on Out-of-State Litigation - Texas Business and Commerce Code § 272 This is a requirement of the TIPS Contract and is non-negotiable. Texas Business and Commerce Code § 272 prohibits a construction contract, or an agreement collateral to or affecting the construction contract, from containing a provision making the contract or agreement, or any conflict arising under the contract or agreement, subject to another state’s law, litigation in the courts of another state, or arbitration in another state. If included in Texas construction contracts, such provisions are voidable by a party obligated by the contract or agreement to perform the work. By submission of this proposal, Vendor acknowledges this law and if Vendor enters into a construction contract with a Texas TIPS Member under this procurement, Vendor certifies compliance.
CFR Part 200 or Federal Provision - Xxxx Anti-Lobbying Amendment - Continued If you answered "No, Vendor does not certify - Lobbying to Report" to the above attribute question, you must download, read, execute, and upload the attachment entitled "Disclosure of Lobbying Activities - Standard Form - LLL", as instructed, to report the lobbying activities you performed or paid others to perform. 2 CFR Part 200 or Federal Provision - Federal Rule Compliance with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. 1857(h)), section 508 of the Clean Water Act (33 U.S.C. 1368), Executive Order 11738, and Environmental Protection Agency regulations (40 CFR part 15). (Contracts, subcontracts, and subgrants of amounts in excess of $100,000) Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, ESC Region 8 and TIPS Members requires the proposer certify that in performance of the contracts, subcontracts, and subgrants of amounts in excess of $250,000, the vendor will be in compliance with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. 1857(h)), section 508 of the Clean Water Act (33 U.S.C. 1368), Executive Order 11738, and Environmental Protection Agency regulations (40 CFR part 15). Does vendor certify compliance? Yes
Limited Guaranty of the Corporation The Corporation hereby guarantees performance of the Receiver's obligation to indemnify the Assuming Institution as set forth in this Article XII. It is a condition to the Corporation's obligation hereunder that the Assuming Institution shall comply in all respects with the applicable provisions of this Article XII. The Corporation shall be liable hereunder only for such amounts, if any, as the Receiver is obligated to pay under the terms of this Article XII but shall fail to pay. Except as otherwise provided above in this Section 12.7, nothing in this Article XII is intended or shall be construed to create any liability or obligation on the part of the Corporation, the United States of America or any department or agency thereof under or with respect to this Article XII, or any provision hereof, it being the intention of the parties hereto that the obligations undertaken by the Receiver under this Article XII are the sole and exclusive responsibility of the Receiver and no other Person or entity.
SUBORDINATION OF AGREEMENT 18.1 The parties hereto and the employees of the City are governed by the provisions of applicable Federal Law, State Law, and the City Charter. When any provisions thereof are in conflict with the provisions of this Agreement, the provisions of said Federal Law, State Law, or City Charter are paramount and shall prevail.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
Mandatory national law Nothing in this Consortium Agreement shall be deemed to require a Party to breach any mandatory statutory law under which the Party is operating.
