Front and Rear Suspension Sample Clauses

Front and Rear Suspension. Upper and Lower Control Arms; Control Arm Shafts, Bearings or Bushings; Upper and Lower Ball Joints; Radius Arm and Bushings; Torsion Bars and Mounts or Bushings; Stabilizer Bar, Links and Bushings; Spindle and Spindle Support.
Sample 1
AutoNDA by SimpleDocs
Front and Rear Suspension. Upper and Lower Control Arms, Control Arm Shafts and Bearings, Bushings, Torsion Bars, Mounts and Bushings, Upper and Lower Ball Joints, Strut Bearing Plates, Radius Arms and Bushings, Stabilizer Bar, Links and Bushings, Spindle and Spindle Support, Wheel Bearings, Variable Dampening Suspension, Compressor, Control Module, Dampening Actuator, Solenoid, Strut Height Sensor, Mode Selector Switch, Seals and Gaskets, Rear Wheel Steering, Rear Steering Shaft and Couplings, Power Cylinder and Pump, Electronic Control Unit/Solenoid, Phase Control Unit, Stepper Motor, Steering Box, Control Valve and Rack and Tie Rod Ends.
Sample 1
Front and Rear Suspension. MacPherson Struts; Shackle and Eye Shafts and Bushings; Torsion Bars and Bushings; Wheel Bearings and Seals; Automatic Leveling Unit Compressor, Sensor and Limiting Valve.
Sample 1
Front and Rear Suspension. Steering knuckles, stabilizer shaft and bushings, king pins and bushings, spindles and spindle supports, NO CLAIM WILL BE PAID WITHOUT PRIOR AUTHORIZATION shackle and eye bushings, wheel bearings, torsion bars and stabilizer linkage.
Sample 1
Front and Rear Suspension. Loss of fluid or pressure or mechanical failure of the springs. Excluding damage to the seals following pitting or corrosion.
Sample 1
Front and Rear Suspension. MacPherson struts, upper and lower control arms (links/transverse links) and bushings, tension/compression rods and xxxx- xxxx, stabilizer bars and bushings, rear arm assembly, torsion bars, upper and lower ball joints, wheel bearings and seals, knuck- le spindle, hubs, coil and leaf springs, and rear axle beam. STEERING: Steering gear/rack and pinion internal components. The following are also covered: power steering pump and reservoir, steer- ing column main and upper shafts, steering linkages and couplings, tilt wheel mechanism/actuator, power cylinder assembly, seals and gaskets. Note: steering gear and rack and pinion housings are only covered if damaged by the failure of a steering internal part.
Sample 1

Related to Front and Rear Suspension

  • Effective Date; Termination; Cancellation and Suspension Section 5.01. This Agreement shall come into force and effect on the date upon which the Development Credit Agreement becomes effective.

  • Effective Date, Suspension and Termination Section 6.01. This Agreement shall become effective upon its execution by the parties.

  • Termination and Suspension Customer is entitled to suspend the performance of its obligations in whole or in part or terminate the Agreement with immediate effect, without prejudice to its right to claim damages and without any compensation to or indemnification of Supplier (i) in case Supplier has been declared bankrupt, is in a state of liquidation, has ceased or suspended whole or a substantial part of its business, is subject of a court order or preventative legal scheme of settlement, (ii) in case of non- compliance with the Compliance Requirements or the provisions of safety, health, environment and security or (iii) in case of not approved changes pursuant to article 10. After such termination Customer may return received Goods and/or Services in whole or partly against repayment and retransfer of ownership therein to Supplier.

  • Term Termination and Suspension 18.1 This Agreement shall be effective from the Effective Date for the Term. The Service shall commence on the Commencement Date and continue until the Completion Date, whereupon this Agreement shall expire unless terminated earlier in accordance with its terms.

  • Debarment and Suspension A. The Contractor certifies by entering into this Contract that neither it nor its principals nor any of its subcontractors are presently debarred, suspended, proposed for debarment, declared ineligible or voluntarily excluded from entering into this Contract by any federal agency or by any department, agency or political subdivision of the State of Indiana. The term “principal” for purposes of this Contract means an officer, director, owner, partner, key employee or other person with primary management or supervisory responsibilities, or a person who has a critical influence on or substantive control over the operations of the Contractor.

  • PROJECT TERMINATION AND SUSPENSION 15.1 This Agreement may be terminated during the Pre-Construction Phase by either party upon fifteen (15) days written notice should the other party fail substantially to perform in accordance with its terms through no fault of the party initiating the termination and the breach is not cured or a plan to cure the breach acceptable to the non-breaching party is not established within the fifteen (15) day period.

  • TERM, TERMINATION & SUSPENSION The Company may terminate this Agreement with You at any time for any reason, with or without cause. The Company specifically reserves the right to terminate this Agreement if You violate any of the terms outlined herein, including, but not limited to, violating the intellectual property rights of the Company or a third party, failing to comply with applicable laws or other legal obligations, and/or publishing or distributing illegal material. If You have registered for an account with Us, You may also terminate this Agreement at any time by contacting Us and requesting termination. At the termination of this Agreement, any provisions that would be expected to survive termination by their nature shall remain in full force and effect.

  • CERTIFICATION REGARDING DEBARMENT AND SUSPENSION The undersigned (authorized official signing for the contracting organization) certifies to the best of his or her knowledge and belief, that the contractor, defined as the primary participant in accordance with 45 CFR Part 76, and its principals:

  • Term Suspension and Termination 9.1. Term of this MSA. This MSA comes into force on the date you first accept it by whatever means and continues until all Subscriptions expire or have been terminated.

  • EFFECTIVE DATE, TERMINATION, AND RENEWAL 17.1 This Agreement shall become effective on the first day of May, AD., 2019, and shall continue in full force and effect until the thirtieth (30th) day of April, AD., 2022 and thereafter from year to year unless terminated upon written notice of either party within one hundred and twenty (120) days prior to any anniversary of the terminal date.

Time is Money Join Law Insider Premium to draft better contracts faster.