Seals and Gaskets. Thrust Washers; Universal Joints; Viscous Coupling SUSPENSION (Front and Rear): Bushings/Bearings; Control Arm Shafts; Electronic Suspension Actuator/Motor and Compressor; Front and Rear Coil Springs; Front and Rear Stabilizer Bar; Front Leading Arm; Front Spring Assembly; Radius Arm; Spindle; Spindle Support; Suspension Spring Shackles; Steering Knuckle; Strut Rod; Sway Bar Link; Torsion Bar Spring; Upper and Lower Ball Joints; Upper and Lower Control Arms; Upper Arm Shaft STEERING Gear Box internal components and: Bushings/Bearings; Center Link; Horn Contact Ring; Hoses, Lines and Tubes; Idler Arm; Knuckle Stopper Cover; Xxxxxx Arm; Power Steering Pump; Power Steering Pump Pulley; Rack and Pinion; Seals and Gaskets; Steering Column; Steering Column Coupling; Steering Column Shaft; Steering Dampener; Steering Gear Box and Pump Housings; Tie Rod End FUEL SYSTEM Air Flow Meter; Carburetor; Charcoal Canister; Diesel Fuel Injection Pump; Electric Fuel Pump; Electronic Fuel Injection System; Fuel Filler Opening Lid Hinge Spring; Fuel Injectors; Fuel Pressure Regulator; Fuel Pump; Fuel Sending Unit; Fuel Sensors; Fuel Tank; Throttle Body COOLING SYSTEM Coolant Level Sensor/Tank; Cooling Fan Relay; Cooling Fan Sensor; Engine Coolant Temperature Switch or Sensor (at radiator); Engine Cooling Fan Motor; Engine Fan; Engine Fan Clutch; Engine Fan Motor; Engine Fan Shroud; Equipment Drive Pulley; Fan Bracket Subassembly; Radiator; Seals and Gaskets; Thermostat AIR CONDITIONING/HEATING
Seals and Gaskets. Coverage applies only for the covered components listed above. Minor loss of fluid or seepage is considered normal and is not considered a MECHANICAL BREAKDOWN.
Seals and Gaskets. Seals and gaskets are covered for those components covered by the Plan (except prop shaft seal).
Seals and Gaskets. Seals and Gaskets are covered only in conjunction with the repair or replacement of the covered parts listed in items 1-14 above. Leaking Seals and Gaskets as “stand alone” repairs are NOT covered by the CONTRACT. COMMERCIAL COVERAGE– A COMMERCIAL USE VEHICLE IS DEFINED AS A VEHICLE UP TO 1 TON REGISTERED TO A BUSINESS AND/OR BUSINESS PURPOSES. VEHICLES THAT ARE USED IN EXCESS OF MANUFACTURERS G.V.W. OR FOR EXCESSIVE HAULING AND PULLING ARE EXCLUDED FROM COVERAGE. TOW TRUCKS, VEHICLES WITH SNOWPLOWS, POLICE VEHICLES, AND TAXIS ARE SPECIFICALLY EXCLUDED FROM COVERAGE HEREUNDER.
Seals and Gaskets. Head gasket and intake manifold gaskets are covered for coolant leaks only on vehicles up to 100,000 miles.
Seals and Gaskets. Cylinder head gaskets. All other seals and gaskets are covered only in conjunction with covered listed components.
Seals and Gaskets. Seals and Gaskets are replaced only as part of repair or replacement of the above covered components. Leaking gaskets or seals are not covered.
Seals and Gaskets. Seals and gaskets are covered only as part of repair or replacement of the above Covered Parts. Leaking seals and gaskets are not Covered Parts.
Seals and Gaskets. Seals and Gaskets are covered only in conjunction with the repair or replacement of the covered parts listed in items 1-14 above. Leaking Seals and Gaskets as “stand alone” repairs are NOT covered by the CONTRACT. SAMPLE
Seals and Gaskets. Coverage is provided for the standalone failure of the cylinder head and/or intake manifold gaskets only. All other leaking and/or failed Seals and Gaskets are not covered as standalone failures and/or repairs and will be replaced only when required in connection with a covered repair, unless You purchased the Seals and Gaskets Option as shown on Your Identification Card and in the Options box on the Application Page of this Contract. (Seals and Gaskets Coverage will expire when the Vehicle reaches one hundred seventy-five thousand (175,000) miles as indicated on the odometer, after which Seals and Gaskets are covered only when required to be replaced in connection with a covered repair). ___________________
