Gas Measurement for Fuel Gas. The onboard gas measurement system of the FSRU shall be used to measure the Internal Use for the FSRU. Each consumer has volume flow or mass-flow measurement installed. The energy content for the flow will be estimated and corresponding mass flow will be calculated based on the assumptions in Table 1 of Schedule 9 (Internal Use Limit). Flow accuracy of gas flow meters to the consumers are within plus or minus three percent (+/-3%). The Gas flow meters are calibrated from newbuilding shipyard and will be validated and verified by a third party company within two (2) months after the date on which the certificate of acceptance of the FSRU has been signed by Operator and the FSRU Owner. SCHEDULE 4 GAS NOMINATION PROCEDURES Time required to cool down a spare booster pump/train, including preparation time is twelve plus two (12+2) hours. In case a standby train is maintained in cold condition, time required to bring a cold train to service is one (1) hour.
Gas Measurement for Fuel Gas. 2.1. The onboard gas measurement system of the FSRU shall be used to measure the fuel consumption for the FSRU. Each consumer has volume flow or mass-flow measurement installed. The energy content for the flow will be reasonably estimated and corresponding mass flow will be calculated based on the assumptions in Schedule 9 (Internal Use Limit). The Gas flow meters are calibrated from the newbuilding shipyard and the Operator shall cause them to be validated and verified by a third party company. SCHEDULE 4
