General Operations Tenant covenants and agrees to furnish to Landlord, within thirty (30) days after receipt or modification thereof, copies of: (a) all licenses authorizing Tenant or any Manager to operate any Facility for its Primary Intended Use; (b) all Medicare and Medicaid certifications, together with provider agreements and all material correspondence relating thereto with respect to any Facility (excluding, however, correspondence which may be subject to any attorney client privilege); (c) if required under Applicable Law with respect to any Facility, a license for each individual employed as administrator with respect to such Facility; (d) all reports of surveys, statements of deficiencies, plans of correction, and all material correspondence relating thereto, including, without limitation, all reports and material correspondence concerning compliance with or enforcement of licensure, Medicare/Medicaid, and accreditation requirements, including physical environment and Life Safety Code survey reports (excluding, however, correspondence which may be subject to any attorney client privilege); and (e) with reasonable promptness, such other confirmation as to the licensure and Medicare and Medicaid participation of Tenant as Landlord may reasonably request from time to time.
General Overview 2.1.1 If DTI requires maintenance for its local service customers, DTI will initiate a request for repair (sometimes referred to as a "trouble report") by calling GTE's Customer Care Repair Center. During this call, GTE service representatives will verify that the end-user is DTI customer and will then obtain the necessary information from DTI to process the trouble report. While DTI representatives are still on the line, GTE personnel will perform an initial analysis of the problem and remote line testing for resale services. If engineered services are involved, the call will be made to the GTE SSCC for handling. If no engineering is required and the line testing reveals that the trouble can be repaired remotely, GTE personnel will correct the problem and close the trouble report while DTI representatives are still on the line. If on-line resolution is not possible, GTE personnel will provide DTI representatives a commitment time for repair, and the GTE personnel then will enter the trouble ticket into the GTE service dispatch queue. DTI's repair service commitment times will be within the same intervals as GTE provides to its own end users. Maintenance and repair of GTE facilities is the responsibility of GTE and will be performed at no incremental charge to DTI. If, as a result of DTI-initiated trouble report, trouble is found to be the responsibility of DTI (e.g., non-network cause) GTE will charge DTI for trouble isolation. DTI will have the ability to report trouble for its end users to appropriate trouble reporting centers 24 hours a day, 7 days a week. DTI will be assigned a customer contact center when initial service agreements are made.
Annual Operating Plan Purchaser may be required to submit a written annual operating plan, as specified by, and at the request of the Forest Officer.
Synchronization, Commissioning and Commercial Operation 4.1.1 The Power Producer shall give at least fifteen (15) days written notice to the SLDC / ALDC / DISCOM as the case may be, of the date on which it intends to synchronize the Power Project to the Grid System. 4.1.2 Subject to Article 4.1.1, the Power Project may be synchronized by the Power Producer to the Grid System when it meets all the connection conditions prescribed in the Grid Code and otherwise meets all other Indian legal requirements for synchronization to the Grid System. 4.1.3 The synchronization equipment and all necessary arrangements / equipment including Remote Terminal Unit (RTU) for scheduling of power generated from the Project and transmission of data to the concerned authority as per applicable regulation shall be installed by the Power Producer at its generation facility of the Power Project at its own cost. The Power Producer shall synchronize its system with the Grid System only after the approval of GETCO / SLDC / ALDC and GEDA. 4.1.4 The Power Producer shall immediately after each synchronization / tripping of generator, inform the sub-station of the Grid System to which the Power Project is electrically connected in accordance with applicable Grid Code. 4.1.5 The Power Producer shall commission the Project within SCOD. 4.1.6 The Power Producer shall be required to obtain Developer and/ or Transfer Permission, Key Plan drawing etc, if required, from GEDA. In cases of conversion of land from Agricultural to Non-Agriculture, the commissioning shall be taken up by GEDA only upon submission of N.A. permission by the Power Producer. 4.1.7 The Power Producer shall be required to follow the Forecasting and Scheduling procedures as per the Regulations issued by Hon’ble GERC from time to time. It is to clarify that in terms of GERC (Forecasting, Scheduling, Deviation Settlement and Related Matters of Solar and Wind Generation Sources) Regulations, 2019 the procedures for Forecasting, Scheduling & Deviation Settlment are applicable to all solar generators having combined installed capacity above 1 MW connected to the State Grid / Substation including those connected via pooling stations.
System Operations Each party, at its own expense, shall provide and maintain the equipment, software, services and testing necessary to transmit Data Communications to, and receive Data Communications from the parties’ respective Receipt Computers.
STATE MEAL MANDATE When CONTRACTOR is a nonpublic school, CONTRACTOR and LEA shall satisfy the State Meal Mandate under California Education Code sections 49530, 49530.5 and 49550.
Conduct of Local Church Operations From the date of this Disaffiliation Agreement through and until the Closing, the Local Church: (a) will conduct its operations substantially in accordance with past practice and will use commercially reasonable efforts, subject to the foregoing, to maintain and preserve its operations and organization consistent with past practice and efficient and economical management, (b) will not take any action that is inconsistent with its charitable purposes under Section 501(c)(3) of the Code or that otherwise adversely affects its tax-exempt status, and (c) will not take any action that would cause its representations and warranties in this Disaffiliation Agreement not to remain true and correct as of Closing, except with the prior written consent of the Annual Conference.
Verizon Operations Support Systems Verizon systems for pre- ordering, ordering, provisioning, maintenance and repair, and billing.
Maintenance and Operation Member-Generator agrees to maintain their system and facilities in accordance with applicable manufacturer's recommended maintenance schedule and standard prudent engineering practices. Member-Generator covenants and agrees to operate their system, facilities and equipment so as to minimize the likelihood for a malfunction or other disturbance, damaging or otherwise affecting or impairing Cooperative’s electrical system. Member-Generator shall comply with all applicable laws, regulations, zoning, building codes, safety rules and other environmental regulations or restrictions applicable to the design, installation, operation and maintenance of the Member-Generator's System.
Commercial Operation Date Testing and Modifications Prior to the Commercial Operation Date, the Connecting Transmission Owner shall test the Connecting Transmission Owner’s Attachment Facilities and System Upgrade Facilities and System Deliverability Upgrades and Developer shall test the Large Generating Facility and the Developer Attachment Facilities to ensure their safe and reliable operation. Similar testing may be required after initial operation. Developer and Connecting Transmission Owner shall each make any modifications to its facilities that are found to be necessary as a result of such testing. Developer shall bear the cost of all such testing and modifications. Developer shall generate test energy at the Large Generating Facility only if it has arranged for the injection of such test energy in accordance with NYISO procedures.
