Inspection of Equipment The Contractor’s equipment is inspected by an authorised Eskom employee on arrival at the site. The following documentation is required to accompany the equipment where applicable: copies of all test certificates and maintenance records. Lifting equipment and electrical equipment must be marked with a unique number, code or colour code for identification. If the equipment is found to be in an unsatisfactory condition or if insufficient maintenance has been carried out on the equipment then it will not be approved for use on Site. A list of all lifting equipment and electrical equipment must be submitted to the Employer at least 2 days prior to the occupation date. This list must indicate the unique number and description of the equipment. Training requirements must comply with the Works Information and statutory requirements.
INSPECTION OF SITE 1) The Contractor shall be deemed to have inspected the Site prior to the submission of his tender and to have satisfied himself as to the nature of the ground, the access to the Site, the availability of water, electricity and labour and all other factors affecting the execution and completion of the Works and to have allowed for all these factors in preparing his tender.
Inspections The Servicer shall inspect the Mortgaged Property as often as deemed necessary by the Servicer in accordance with Accepted Servicing Practices to assure itself that the value of the Mortgaged Property is being preserved. In addition, if any Mortgage Loan is more than 45 days delinquent, the Servicer promptly shall inspect the Mortgaged Property and shall conduct subsequent inspections in accordance with Accepted Servicing Practices or as may be required by the primary mortgage guaranty insurer. Upon request, the Servicer shall produce an electronic report of each such inspection.
INSPECTION/TESTING All Products sold pursuant to this Agreement will be subject to inspection/testing by or at the direction of H- GAC and/or the ordering Customer, either at the delivery destination or the place of manufacture. In the event a Product fails to meet or exceed all requirements of this Agreement, and unless otherwise agreed in advance, the cost of any inspection and/or testing, will be the responsibility of the Contractor.
Inspection Period Buyer shall be under no obligation to purchase the Property or otherwise perform under this Agreement unless Buyer determines the Property to be, in all respects, suitable for its intended purposes. The decision as to whether the Property is suitable for its intended purposes shall be the sole decision of Buyer, determined in the absolute discretion of Buyer, with Buyer’s decision being final and binding upon both Parties. Buyer shall have until , 20 , at : ☐ AM ☐ PM to notify Seller of its termination of this Agreement due to Buyer's determination that the Property is unsuitable for its intended purpose ("Inspection Period"). In the event Buyer elects to terminate this Agreement, Buyer shall provide written notice of termination to Seller prior to the expiration of the Inspection Period. In the event Buyer provides said notice of termination, Seller and any Escrow Agent shall be obligated to return the Escrow Money to the Buyer as provided in Section V hereof, and neither party shall have any further rights or obligations under this Agreement. In the event Buyer does not submit written notice of termination prior to the expiration of the Inspection Period, the Buyer shall be deemed to be satisfied with its inspections of the Property and this contingency shall be deemed to be fulfilled. The Seller, at no expense, shall fully cooperate with Buyer in obtaining any and all approvals required from any Federal, State, or Local Government ("Governmental Approvals") necessary for Buyer to satisfy their needs during the Inspection Period for the suitability of the Property. Said Governmental Approvals shall be obtained during the Inspection Period unless the Parties agree otherwise. Any additional agreements related to this Section must be done in writing and attached to this Agreement.
Inspection The Issuer shall, with reasonable prior notice, permit any representative of the Indenture Trustee, during the Issuer’s normal business hours, to examine the books of account, records, reports and other papers of the Issuer, to make copies and extracts therefrom, to cause such books to be audited by Independent certified public accountants, and to discuss the Issuer’s affairs, finances and accounts with the Issuer’s officers, employees, and Independent certified public accountants, all at such reasonable times and as often as may be reasonably requested. The Indenture Trustee shall and shall cause its representatives to hold in confidence all such information except to the extent disclosure may be required by law (and all reasonable applications for confidential treatment are unavailing) and except to the extent that the Indenture Trustee may reasonably determine that such disclosure is consistent with its obligations hereunder.
Equipment Testing and Inspection 2.1.1 The Interconnection Customer shall test and inspect its Small Generating Facility and Interconnection Facilities prior to interconnection. The Interconnection Customer shall notify the NYISO and the Connecting Transmission Owner of such activities no fewer than five Business Days (or as may be agreed to by the Parties) prior to such testing and inspection. Testing and inspection shall occur on a Business Day. The Connecting Transmission Owner may, at its own expense, send qualified personnel to the Small Generating Facility site to inspect the interconnection and observe the testing. The Interconnection Customer shall provide the NYISO and Connecting Transmission Owner a written test report when such testing and inspection is completed. The Small Generating Facility may not commence parallel operations if the NYISO, in consultation with the Connecting Transmission Owner, finds that the Small Generating Facility has not been installed as agreed upon or may not be operated in a safe and reliable manner.
SITE INSPECTION Where a site inspection is required by the Bid Specifications or Project Definition, Bidder shall be required to inspect the site, including environmental or other conditions for pre-existing deficiencies that may affect the installed Product, equipment, or environment or services to be provided and, which may affect Bidder’s ability to properly deliver, install or otherwise provide the required Product. All inquiries regarding such conditions shall be made in writing. Bidder shall be deemed to have knowledge of any deficiencies or conditions which such inspection or inquiry might have disclosed. Bidder must provide a detailed explanation with its Bid if additional work is required under this clause in order to properly complete the delivery and installation of the required Product or provide the requested service.
Inspection Report The Client and the Company agree that the Company, and its inspector(s), will prepare a written home inspection report which shall:
Inspection Reports A "full inspection report" comprises a Site Master File (compiled by the manufacturer or by the inspectorate) and a narrative report by the inspectorate. A "detailed report" responds to specific queries about a firm by the other Party.
