Installation of Drive Rings and J-Hooks Sample Clauses

Installation of Drive Rings and J-Hooks. Applicant may install drive rings and J- hooks on SWBT’s poles for the attachment of drop wires as specified in this section. (a) Drive rings and J-hooks may be installed as specified in pole attachment licenses issued to Applicant. (b) If attachment space has already been licensed to Applicant on a given SWBT pole, Applicant may install drive rings and J-hooks within the space assigned to Applicant (typically six inches above and six inches below Applicant’s point of attachment on the pole if the point of attachment is in the center of the space assigned to Applicant) without applying for or obtaining a new or amended license. No additional attachment charges shall apply with respect to drive rings and J-hooks installed in Applicant’s licensed attachment space. (c) Applicant’s first choice for placement of drive rings and J-hooks shall be the licensed attachment space assigned to Applicant as provided in subsection (b) above; provided, however, that if attachment space already licensed to Applicant on a given SWBT pole is not adequate for Applicant’s drive rings or J-hooks, Applicant may, when necessary, and without applying for or obtaining a new or amended license, install such drive rings and J-hooks above or below Applicant’s licensed attachment space as described in subsection (b) above. No additional attachment charges shall apply with respect to drive rings and J-hooks installed outside Applicant’s licensed attachment space as permitted in this subsection. (d) If Applicant has not already been licensed attachment space on a given SWBT pole, Applicant may, when necessary, install drive rings and J-hooks to unassigned space on such pole without first obtaining a license for such attachment and shall, promptly following such installation, notify SWBT of the attachment. Such notification shall be made on a form to be developed by SWBT for this purpose and shall constitute an application for a license. Such application may be conditionally granted without a pre-license survey or other inquiry by SWBT, and SWBT shall not be required to process the application, log the attachment as an assignment in its outside plant records, or issue a permanent license for the attachment unless specifically requested by Applicant to do so; provided, however, that a conditionally granted application under this subsection shall be subject to revocation if it is subsequently determined that such attachment has been made in violation of subsection (e) of this section or oth...
Sample 1Sample 2Sample 3See All (12)
AutoNDA by SimpleDocs
Installation of Drive Rings and J-Hooks. CLEC may install drive rings and J-hooks on SBC MISSOURI’s poles for the attachment of drop wires as specified in this section. (a) Drive rings and J-hooks may be installed as specified in pole attachment licenses issued to CLEC. (b) If attachment space has already been licensed to CLEC on a given SBC MISSOURI pole, CLEC may install drive rings and J-hooks within the space assigned to CLEC (e.g., typically six inches above and six inches below CLEC’s point of attachment on the pole if the point of attachment is in the center of the space assigned to CLEC) without applying for or obtaining a new or amended license. No additional attachment charges shall apply with respect to drive rings and J-hooks installed in CLEC’s licensed attachment space.
Sample 1Sample 2
Installation of Drive Rings and J-Hooks. AT&T may install drive rings and J-hooks on SBC NEVADA’s poles for the attachment of drop wires as specified in this section. (a) Drive rings and J-hooks may be installed as specified in pole attachment permits issued to AT&T. (b) If attachment space has already been permitted to AT&T on a given SBC NEVADA pole, AT&T may install drive rings and J-hooks within the space assigned to AT&T (e.g., typically six inches above and six inches below AT&T’s point of attachment on the pole if the point of attachment is in the center of the space assigned to AT&T) without applying for or obtaining a new or amended permit. No additional attachment charges shall apply with respect to drive rings and J-hooks installed in AT&T’s permitted attachment space.
Sample 1
Installation of Drive Rings and J-Hooks. CLEC may install drive rings and J-hooks on AT&T’s poles for the attachment of drop wires as specified in this section. (a) Drive rings and J-hooks may be installed as specified in pole attachment licenses issued to CLEC. (b) If attachment space has already been licensed to CLEC on a given AT&T pole, CLEC may install drive rings and J-hooks within the space assigned to CLEC (e.g., typically six inches above and six inches below CLEC’s point of attachment on the pole if the point of attachment is in the center of the space assigned to CLEC) without applying for or obtaining a new or amended license. No additional attachment charges shall apply with respect to drive rings and J-hooks installed in CLEC’s licensed attachment space. (c) CLEC's first choice for placement of drive rings and J-hooks shall be the licensed attachment space assigned to CLEC as provided in subsections (a) and (b) above; provided, however, that if attachment space already licensed to CLEC on a given AT&T pole is not adequate for CLEC's drive rings or J-hooks, CLEC may, when necessary, and without applying for or obtaining a new or amended license, install such drive rings and J-hooks assigned to AT&T or another joint user without the approval of AT&T or such other joint user and may not install drive rings and J-hooks in unassigned space in any manner which will block or preclude the subsequent occupancy or use of such space by AT&T or other joint users. If the presence of such CLEC facilities in space not assigned to CLEC will block or preclude the use of assigned or otherwise assignable space by AT&T or other joint users, CLEC shall, on AT&T’s request, promptly relocate the facilities in order to accommodate the facilities of other users and shall bear all expenses associated with such relocation. (d) AT&T may not install drive rings and J-hooks in space assigned to CLEC without CLEC’s approval and shall, at the CLEC’s request, promptly relocate the facilities in order to accommodate CLEC’s facilities and bear all expenses associated with such relocation. If AT&T drive above or below CLEC's licensed attachment space as described in subsection (b) above. No additional attachment charges shall apply with respect to drive rings and J-hooks installed outside CLEC's licensed attachment space as provided in this subsection. (e) If CLEC has not already been licensed attachment space on a given pole, CLEC may, when necessary, install drive rings and J-hooks on unassigned space on such pole w...
Sample 1

Related to Installation of Drive Rings and J-Hooks

  • Installation and Use Rights You may install and use any number of copies of the software on your devices.

  • Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.

  • Installation Waiver Company will waive the one-time installation charges associated with the implementation of Services within the 48 contiguous States of the U.S. provided under this Agreement except for the following services: (i) eDSL, (ii) VPN, (iii) Internet Dedicated OC3, OC12, OC48, Gig-E, (iv) PTT / third party services (including International Access and Company International), (v) Data Center, (vi) Paging, (vii) Managed Services, (viii) CPE, (ix) Enhanced Call Routing, (x) Local Disaster Recovery, (xi) Audio, Video and Net Conferencing, (xii) Voice over IP Services, (xiii) Security Services, (xiv) Non-Listing/Non-Published Service, (xv) Telecommunications Service Priority, and (xvi) Services provided by Company incumbent local exchange carriers (“ILECs”) or by Cellco Partnership and its affiliates d/b/a Company Wireless. Usage charges, monthly recurring charges, expedite charges, change charges, surcharges, charges for an unlisted or non-published number, any charges imposed by third parties (including access, egress, jack, or wiring charges), taxes or tax-like surcharges, or other Governmental Charges will not be waived.

  • Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.

  • Installation and Use You may install and use the Software only for the number of licenses acquired by you. In order to exercise your rights to the Software under this Agreement, you must activate your copy of the Software in the manner described during the launch sequence.

  • Installation of Equipment You represent that there are no legal, contractual or similar restrictions on the installation of the Equipment in the location(s) you have authorized. It is your responsibility to ensure compliance with all applicable building codes, zoning ordinances, homeowners’ association rules, covenants, conditions, and restrictions related to the Service, to pay any fees or other charges, and to obtain any permits or authorizations necessary for the installation or use of the Service (collectively "Legal Requirements"). You are solely responsible for any fines or similar charges for violation of any applicable Legal Requirements. You acknowledge and agree that Viasat or its designated service provider will be required to access your premises and computer to install and maintain the Equipment, including, without limitation, the antenna and its components. Standard Equipment installations performed by Viasat-authorized installers include: (i) installation of the antenna to an outside wall or sloped roof; (ii) travel to and from your Service location within 50 miles of the installer’s office; (iii) cable routed through one exterior wall and one interior wall or floor; (iv) connection of the antenna to the modem using up to 150 feet of cable; (v) connection of the modem to one computer using up to 7 feet of cable; and (vi) required mounting and cabling hardware. Any different or additional installation services or hardware are non-standard and may result in additional charges to be agreed upon between you and the installer. All installations include attaching the Equipment to your computer, installing software on your computer and configuring your computer to optimize the performance of the Internet Service. You confirm that you have reviewed the installation plan and agreed to any associated charges. If you approved a roof mount, you acknowledge the potential risks associated with this type of installation (including, without limitation, with respect to any warranty that applies to your roof or roof membrane). By signing this Agreement, scheduling one or more service or installation visits, and permitting us or our service provider to enter your home, you are authorizing Viasat and its service provider to perform all of the above actions. You are responsible for backing up the data on your computer and we highly recommend that you do so prior to permitting access to us or one of our designated service providers. NEITHER VIASAT NOR ITS SERVICE PROVIDER SHALL HAVE ANY LIABILITY WHATSOEVER FOR ANY LOSSES RESULTING FROM THE EQUIPMENT OR ANY INSTALLATION, REPAIR OR OTHER SERVICES ASSOCIATED WITH THE EQUIPMENT, INCLUDING WITHOUT LIMITATION, DAMAGE TO YOUR PREMISES OR LOSS OF SOFTWARE, DATA OR OTHER INFORMATION FROM YOUR COMPUTER. This limitation does not apply to any damages arising from the gross negligence or willful misconduct of us or one of our designated service providers. Time frames for installation, if any, are not guaranteed and may vary depending on the types of services requested and other factors.

  • Routine Maintenance, Construction, and Repair The NYISO or Connecting Transmission Owner may interrupt interconnection service or curtail the output of the Small Generating Facility and temporarily disconnect the Small Generating Facility from the New York State Transmission System or Distribution System when necessary for routine maintenance, construction, and repairs on the New York State Transmission System or Distribution System. The NYISO or the Connecting Transmission Owner shall provide the Interconnection Customer with five Business Days notice prior to such interruption. The NYISO and Connecting Transmission Owner shall use Reasonable Efforts to coordinate such reduction or temporary disconnection with the Interconnection Customer.

  • Installation Services The Bitstream 2a Service includes a Standard Install as set out below (in each case to the extent that the relevant provisioning works are not already complete for the relevant Service Order).1

  • Alterations, Additions, and Improvements Subject to the provisions of this Article IV, Lessee may make any alterations, additions, improvements or other changes to the Premises and the Relevant Assets as may be necessary or useful in connection with the operation of the Relevant Assets (collectively, the “Additional Improvements”). If such Additional Improvements require alterations, additions or improvements to the Premises or any of the Shared Access Facilities, Lessee shall notify Lessor in writing in advance and the parties shall negotiate in good faith any increase to the fees paid by Lessee under the Site Services Agreement by Lessee or otherwise provide for reimbursement of any material increase in cost (if any) to Lessor under the Site Services Agreement that results from any modifications to the Premises or the Shared Access Facilities necessary to accommodate the Additional Improvements, or as otherwise mutually agreed by the parties. Any alteration, addition, improvement or other change to the Premises, Relevant Assets or Additional Improvements (and, if agreed by Lessee and Lessor, to the Shared Access Facilities) by Lessee shall be made in a good and workmanlike manner and in accordance with all applicable Laws. The Relevant Assets and all Additional Improvements shall remain the property of Lessee and shall be removed by Lessee within one (1) year after termination of this Lease (provided that such can be removed by Lessee without unreasonable damage or harm to the Premises) or, at Lessee’s option exercisable by notice to Lessor, surrendered to Lessor upon the termination of this Lease. Lessee shall not have the right or power to create or permit any lien of any kind or character on the Premises by reason of repair or construction or other work. In the event any such lien is filed against the Premises, Lessee shall cause such lien to be discharged or bonded within thirty (30) days of the date of filing thereof.

  • REMOVAL OF RECORDS FROM PREMISES Where performance of the Contract involves use by the Contractor (or the Contractor’s subsidiaries, affiliates, partners, agents or subcontractors) of Authorized User owned or licensed papers, files, computer disks or other electronic storage devices, data or records at Authorized User facilities or offices, or via remote access, the Contractor (or the Contractor’s subsidiaries, affiliates, partners, agents or subcontractors) shall not remotely access, modify, delete, copy or remove such Records without the prior written approval of the Authorized User. In no case, with or without the written approval of the Authorized User, can the Authorized User data be accessed, moved or sent outside the continental United States.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!