INTERACTION MATRIX Sample Clauses

INTERACTION MATRIX. ‌ Using these device descriptions and reference application set, an analysis was performed to determine, when two of these devices meet, which of the core safety functions are operational in each device? The resulting Interaction Matrix identifies which functions could be operational in the host vehicle for all possible combinations of installed device (Who I Am) and remote vehicle / device (What I Meet). The following additional assumptions regarding device capabilities were applied to perform this analysis. - It is assumed that all the devices fulfill the Minimum Performance Requirements for lane level applications as defined in the final SAE J2945 document. - The fact that the ASD-U is not connected to the vehicle network means that it will not be able to detect a turn signal on the host vehicle, which means that LCW will not work. - For VAD and ASD-U on the Remote Vehicle, the control loss warning information on the Remote Vehicle is not available. It is assumed, though, that a hard braking event can be detected through rapid deceleration, which enables the EEBL application. - It is assumed that the INT-S RSE can detect vehicles and send this information out to equipped vehicles within range. This will enable the blind merge and highway merge applications with an INT-S at the location and will also enable IMA due to the detection of non-equipped vehicles. - The Stop Sign Movement Warning was considered as a subset of the Intersection Movement Assist application. If this is to be considered separately, the question needs to be answered how the stop sign information will get to the vehicle (i.e. built in map, GID, etc.). The results of this analysis are contained in Figure 5 below. In each block of the analysis, the device listed in bold italic text in the upper left corner is the device installed in the remote vehicle, the devices listed below it are the possible devices installed in the host vehicle or the intersection on which the applications will work (or not). The number 1 in a cell signifies that the application will work on the host device. The number 0 in a cell means that the application will not work on that device.
Sample 1
AutoNDA by SimpleDocs

Related to INTERACTION MATRIX

  • PERFORMANCE MANAGEMENT SYSTEM 5.1 The Employee agrees to participate in the performance management system that the Employer adopts or introduces for the Employer, management and municipal staff of the Employer.

  • Statewide HUB Program Statewide Procurement Division Note: In order for State agencies and institutions of higher education (universities) to be credited for utilizing this business as a HUB, they must award payment under the Certificate/VID Number identified above. Agencies, universities and prime contractors are encouraged to verify the company’s HUB certification prior to issuing a notice of award by accessing the Internet (xxxxx://xxxxx.xxx.xxxxx.xx.xx/tpasscmblsearch/index.jsp) or by contacting the HUB Program at 000-000-0000 or toll-free in Texas at 0-000-000-0000.

  • STATEWIDE CONTRACT MANAGEMENT SYSTEM If the maximum amount payable to Contractor under this Contract is $100,000 or greater, either on the Effective Date or at any time thereafter, this section shall apply. Contractor agrees to be governed by and comply with the provisions of §§00-000-000, 00-000-000, 00-000-000, and 00- 000-000, C.R.S. regarding the monitoring of vendor performance and the reporting of contract information in the State’s contract management system (“Contract Management System” or “CMS”). Contractor’s performance shall be subject to evaluation and review in accordance with the terms and conditions of this Contract, Colorado statutes governing CMS, and State Fiscal Rules and State Controller policies.

  • Purchase Order Flip via Ariba Network (AN) The online process allows suppliers to submit invoices via the AN for catalog and non- catalog goods and services. Contractors have the ability to create an invoice directly from their Inbox in their AN account by simply “flipping” the purchase order into an invoice. This option does not require any special software or technical capabilities. For the purposes of this section, the Contractor warrants and represents that it is authorized and empowered to and hereby grants the State and the third-party provider of MFMP the right and license to use, reproduce, transmit, distribute, and publicly display within the system the information outlined above. In addition, the Contractor warrants and represents that it is authorized and empowered to and hereby grants the State and the third-party provider the right and license to reproduce and display within the system the Contractor’s trademarks, system marks, logos, trade dress, or other branding designation that identifies the products made available by the Contractor under the Contract.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where InterGlobe has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to InterGlobe. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for InterGlobe (e.g. hairpinning):

  • CUSTOMER SERVICE ACCESS The Competitive Supplier agrees to provide, or cause to be provided, certain customer services to Participating Consumers. Such services shall be reasonably accessible to all Participating Consumers, shall be available during normal working hours, shall allow Participating Consumers to transact business they may have with the Competitive Supplier, and shall serve as a communications liaison among the Competitive Supplier, the Town, and the Local Distributor. A toll-free telephone number will be established by Competitive Supplier and be available for Participating Consumers to contact Competitive Supplier during normal business hours (9:00 A.M. - 5:00 P.M. Eastern Standard Time, Monday through Friday) to resolve concerns, answer questions and transact business with respect to the service received from Competitive Supplier. The Town will post program-related information on the Town’s website which will be available to Participating Consumers for general information, product and service information, and other purposes.

  • Lead Customer Service Agent Baggage Addressed to Customer Service Agents, Central Baggage Performance Agents and Central Baggage Tracing Agents. Selection will be on the basis of basic classification seniority. NOTE: Secondary consideration to be given to Lead Station Attendants, Station Attendants, Cargo Communications Operators, Station Attendants – Part-Time, all Cabin Servicing & Cleaning Attendants (full time and part-time) at the point only.. Selection will be on the basis of the applicant’s seniority in basic classification.

  • Signaling protocol The Parties will interconnect their networks using SS7 signaling where Technically Feasible and available as defined in GR 905 Telcordia Standards including ISDN User Part (ISUP) for trunk signaling and TCAP for CCS-based features in the Interconnection of their networks. All Network Operations Forum (NOF) adopted standards shall be adhered to. Where available, CenturyLink signaling services to link its Signaling Transfer Points (STPs) for CLEC switches which connect to CenturyLink’s STPs via “A” links or for CLEC’s STPs to connect to CenturyLink’s STPs via “D” links which are dedicated to the transport of signaling for local Interconnection, may be ordered from the CenturyLink Tariff.

  • Contact Tracing While the employees are on the job site, Producers may require that employees participate in systems that enable contact tracing, such as use of a “punch card” system to record the employee’s location throughout the day or by means of electronic devices (e.g., phone “apps” or wearable electronic devices that track the movement or location of a person or which detect when a person wearing the device comes into close contact with another person wearing the device). Producers may require employees to sign documentation consenting to the use of such electronic devices in contact tracing. In the event that a Producer uses electronic devices for contact tracing, it may access information collected from those devices only for purposes of tracing individuals that the employee has been in contact with during working hours when there has been a COVID- 19-related event, or for purposes of managing and enforcing social distancing protocols.

Time is Money Join Law Insider Premium to draft better contracts faster.