Interior Walls. Any non-load bearing walls constructed shall be of 20 or 25 gauge steel studs, 16" O.C., and 5/8" drywall taped and spackled with a minimum three-coat finish made ready to receive paint. Load bearing walls will need to be designed by a licensed engineer registered in the state of Pennsylvania. Toilet Room walls shall use Moisture Resistant board. All interior walls shall extend a minimum of six inches (6”) above the highest adjacent ceiling, unless otherwise dictated by Code.
Interior Walls. The Tenant shall not deface or xxxx any part of the Building and will not permit any hole to be drilled or made or nails, screws, hooks or spikes to be driven into the interior walls, doors, floors, stone or brick work of the Building or any appurtenances thereof without the prior written consent of the Landlord, which consent shall not be unreasonably withheld.
Interior Walls. All interior walls (including partitions and curtain walls other than partitions separating leased premises) shall be framed with metal studs covered with at least 5/8" gypsum board. The Tenant shall not construct any concrete block walls.
Interior Walls. The exposed interior face of exterior facing walls will be exposed studs with exterior insulation only.
Interior Walls. 1/2” Gypsum lightweight wallboard on walls on ceilings 1/2” Denshield board on shower/tub walls 5/8” Gypsum fire rated board beneath stairs, garage ceiling, garage common walls Texture finish on walls and ceilings with latex paint Rounded corners except at windows
Interior Walls. A. 2-1/2” metal stud with one layer 5/8” gypsum board each side taped and finished smooth; walls terminate underside of grid ceiling.
Interior Walls. The common area walls of the building will be finished with five-eighths inch (5/8") drywall. Drywall will be taped and sanded. The drywall will be finished with two (2) coats of paint in a color to be selected by the landlord's architect and a four inch (4") resilient base. MARLBOROUGH CORPORATE CENTER MARLBOROUGH, MASSACHUSETTS BASE BUILDING DESCRIPTION
Interior Walls. During the Warranty Period, interior walls will be free from cracks caused by structural failures. This does not include cracks that are characteristic and common to the materials used, such as plaster and paint applied over newly plastered interior walls.
Interior Walls. To be painted white.
Interior Walls. Remove bolts, tacks, etc., in all walls; repair wall coverings where necessary and touch-up paint all interior walls including covered walls where required.
