Load Customer’s System Design and Protection Requirements Sample Clauses

Load Customer’s System Design and Protection Requirements. The Customer shall ensure that its electrical system design meets Horizon Utilities‟ design requirements for the particular voltage at which it is to be connected to the Distribution System. The Customer shall consider these and other requirements mentioned in Section 1 of this Schedule in the design, installation, operation and maintenance of Customer Equipment. The Customer is responsible for designing, installing, maintaining and protecting Customer Equipment against all internal electrical faults (in Customer Equipment) and other external conditions imposed by the Distribution System such as over voltages, voltage unbalances, open phase(s) and re-closings of the feeder breaker or re-closer. The Customer shall take reasonable steps to ensure that the operation or failure of Customer Equipment does not cause an outage or disturbance to the Distribution System. To this end, the Customer shall ensure that the application and settings of protective device(s) at the operational Demarcation Point are properly chosen and that the devices are duly coordinated. The complexity of the protection used at an interface point will vary depending upon the voltage level, system configuration, the type and amount of Customer load. Some large Customers may be supplied from more than one feeder. These feeders may have different fault levels and originate from different distribution or transformer stations or transformers within the same distribution or transformer station. The protection scheme and protection coordination shall account for these possibilities. The protective device(s), at the interface point should: i) have suitable ratings, characteristics and setting ranges so that proper coordination with the upstream feeder protective devices is achieved; and ii) be designed and selected so as to provide the required safety, selectivity, reliability and speed of operation; and iii) protect the downstream equipment, such as transformer, bus bar, etc., against faults and other abnormal conditions; and iv) provide backup protection for the downstream equipment protective devices.
AutoNDA by SimpleDocs

Related to Load Customer’s System Design and Protection Requirements

  • System Upgrade Facilities and System Deliverability Upgrades Connecting Transmission Owner shall design, procure, construct, install, and own the System Upgrade Facilities and System Deliverability Upgrades described in Appendix A hereto. The responsibility of the Developer for costs related to System Upgrade Facilities and System Deliverability Upgrades shall be determined in accordance with the provisions of Attachment S to the NYISO OATT.

  • Customer Requirements Customer will be required to maintain complex passwords for their User accounts where applicable. For any such passwords LightEdge will provide a secure URL that any User can access to change passwords. All User passwords are set to a ninety (90) day password expiration schedule by default. LightEdge is not responsible for unexpected use of Services whether by ex-employees, compromised User passwords or any other misuse of Customer accounts. Customer shall be responsible for all costs incurred by such unexpected use of Service. Customer shall be fully responsible for providing to LightEdge at Customer’s own expense and in a timely manner the following: - All security for its Services and systems used or accessible in connection with Service; - Cooperative testing of all Customer-provided hardware, software, and Services for compatibility with Service; - Designating an Authorized Contact(s) to be the point of contact to interface with LightEdge Technical Support; - All cabling necessary to support Service; and - Physical and remote management access to any and all Servers onto which Service is installed.

  • Contracting Information Requirements Contractor represents and warrants that it will comply with the requirements of Section 552.372(a) of the Texas Government Code. Except as provided by Section 552.374(c) of the Texas Government Code, the requirements of Subchapter J (Additional Provisions Related to Contracting Information), Chapter 552 of the Government Code, may apply to the Contract and the Contractor agrees that the Contract can be terminated if the Contractor knowingly or intentionally fails to comply with a requirement of that subchapter.

  • Compliance with Safeguarding Customer Information Requirements The Servicer has implemented and will maintain security measures designed to meet the objectives of the Interagency Guidelines Establishing Standards for Safeguarding Customer Information published in final form on February 1, 2001, 66 Fed. Reg. 8616, and the rules promulgated thereunder, as amended from time to time (the “Guidelines”). The Servicer shall promptly provide the Seller information regarding the implementation of such security measures upon the reasonable request of the Seller.

  • Proposed Policies and Procedures Regarding New Online Content and Functionality By October 31, 2017, the School will submit to OCR for its review and approval proposed policies and procedures (“the Plan for New Content”) to ensure that all new, newly-added, or modified online content and functionality will be accessible to people with disabilities as measured by conformance to the Benchmarks for Measuring Accessibility set forth above, except where doing so would impose a fundamental alteration or undue burden. a) When fundamental alteration or undue burden defenses apply, the Plan for New Content will require the School to provide equally effective alternative access. The Plan for New Content will require the School, in providing equally effective alternate access, to take any actions that do not result in a fundamental alteration or undue financial and administrative burdens, but nevertheless ensure that, to the maximum extent possible, individuals with disabilities receive the same benefits or services as their nondisabled peers. To provide equally effective alternate access, alternates are not required to produce the identical result or level of achievement for persons with and without disabilities, but must afford persons with disabilities equal opportunity to obtain the same result, to gain the same benefit, or to reach the same level of achievement, in the most integrated setting appropriate to the person’s needs. b) The Plan for New Content must include sufficient quality assurance procedures, backed by adequate personnel and financial resources, for full implementation. This provision also applies to the School’s online content and functionality developed by, maintained by, or offered through a third-party vendor or by using open sources. c) Within thirty (30) days of receiving OCR’s approval of the Plan for New Content, the School will officially adopt, and fully implement the amended policies and procedures.

  • Solicitations for Subcontracts, Including Procurements of Materials and Equipment In all solicitations either by competitive bidding or negotiation made by the Engineer for work to be performed under a subcontract, including procurements of materials or leases of equipment, each potential subcontractor or supplier shall be notified by the Engineer of the Engineer's obligations under this contract and the Regulations relative to nondiscrimination on the grounds of race, color, or national origin.

  • Solicitations for Subcontracts, Including Procurement of Materials and Equipment In all solicitations either by competitive bidding or negotiation made by the Local Government for work to be performed under a subcontract, including procurement of materials or leases of equipment, each potential subcontractor or supplier will be notified by the Local Government of the Local Government’s obligations under this Agreement and the Acts and Regulations relative to Nondiscrimination on the grounds of race, color, or national origin.

  • Compliance Policies and Procedures To assist the Fund in complying with Rule 38a-1 of the 1940 Act, BBH&Co. represents that it has adopted written policies and procedures reasonably designed to prevent violation of the federal securities laws in fulfilling its obligations under the Agreement and that it has in place a compliance program to monitor its compliance with those policies and procedures. BBH&Co will upon request provide the Fund with information about our compliance program as mutually agreed.

  • System Requirements Apple Software is supported only on Apple-branded hardware that meets specified system requirements as indicated by Apple.

  • Changes in Equipment, Systems, Etc USBFS reserves the right to make changes from time to time, as it deems advisable, relating to its systems, programs, rules, operating schedules and equipment, so long as such changes do not adversely affect the services provided to the Trust under this Agreement.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!