Trade in Services 1. The Parties shall aim at gradually liberalising and opening their markets for trade in services in accordance with the provisions of the General Agreement on Trade in Services (hereinafter referred to as the “GATS”), taking into account ongoing work under the auspices of the WTO. 2. If a Party grants to a non-Party, after the entry into force of this Agreement, additional benefits with regard to the access to its services markets, it shall agree to enter into negotiations with a view to extending these benefits to another Party on a reciprocal basis. 3. The Parties undertake to keep under review paragraphs 1 and 2 with a view to establishing an agreement liberalising trade in services between them in accordance with Article V of the GATS.
– ORIENTATION AND IN SERVICE 20.01 An orientation and in service program will be provided to all employees. These programs shall be reviewed and discussed from time to time by members of the Union-Management Committee. 20.02 A newly employed employee shall not be placed in charge, until she has been fully oriented to the home. 20.03 The following minimums shall be observed in the orientation/familiarization of a newly hired employee: (a) She is to be familiarized with the physical aspects of the building, the applicable policies and procedures of the Employer, and the daily routine of employees in the Home. (b) The period of orientation/familiarization shall be for a minimum of five (5) days or such greater period that the Employer deems necessary. (c) She shall be an additional employee to the usual staffing pattern. (d) The employee or employees involved in the orientation/familiarization will confirm that it has been completed, and this will be noted on the newly hired employee's personnel file, which will be reviewed with such employee, and the employee shall also be able to comment. (e) The employee may request up to three (3) additional days of paid orientation. When making her request, the employee will specify her learning needs and discuss with the Director of Care the development of the orientation learning plan. This request will not be unreasonably denied. (f) Notwithstanding the above, orientation/familiarization when an employee is transferred to a new unit/shift will be provided as required. (g) The Employer may, at its discretion, provide orientation in other circumstances. 20.04 Both the Employer and the Union recognize the joint responsibility and commitment to provide, and participate in, in-service education. The Union supports the principle of its members' responsibility for their own professional development and the Employer will endeavour to provide programmes related to the requirements of the Home. Programmes will be publicized and related material will be made readily accessible to staff in a timely manner. Any problems in accessing this information will be reported to the Union- Management Committee for resolution. (a) When an employee is required by the Employer to attend any in-service program or e-learning within the Home during her or his regularly scheduled working hours the employee shall suffer no loss of regular pay. (b) When an employee is required by the Employer to prepare for in service or to attend meetings, in service and other work related functions outside her regularly scheduled working hours, and the employee does attend same, she shall be paid for all time spent on such attendance at her regular straight time hourly rate of pay or at the employee's option, she shall receive equivalent time off. When an employee is required by the Employer to complete an e-learning programme outside her regularly scheduled working hours, she shall be paid for all time spent completing such learning at her regular straight time hourly rate of pay or at the employee's option, she shall receive equivalent time off. Part-time employees will be credited with seniority and service for all such hours paid as provided above while in attendance at in-services, meetings, and completing e-learning. (c) The Employer will endeavour where practical to schedule in-services at times which will facilitate the attendance of employees working outside the day shift. 20.06 When required by a certifying body to update an employee's qualifications, except where this matter is covered by another provision of the collective agreement, the Employer shall grant leave of absence without pay which shall include the time required to write any examinations. 20.07 The Employer undertakes to notify the Union in advance, so far as practicable, of any technological changes which the Employer has decided to introduce which will significantly change the employment status of the employee(s) within the bargaining unit. The Employer agrees to discuss with the Union the effect of such technological changes on the employment status of the employee(s) and to consider practical ways and means of minimizing the adverse effect, if any, on the employee(s) concerned. Employees who are subject to layoff due to technological change will then be given notice of such layoff at the earliest reasonable time and in keeping with the requirements of the applicable legislation and the provisions of Article 9.11 to
one Your signing of this Agreement confirms that your employment with the Company shall terminate at the close of business on ___________,or earlier upon our mutual agreement.
Underground Utilities Any required ground digging or subsurface work shall be done in accordance with Chapter 556, Florida Statutes. It shall be the responsibility of CONTRACTOR to have all underground utilities located before any work begins (Sunshine State One Call 0-000-000-0000). The repairs of any damaged underground utilities as a result of the work being performed by CONTRACTOR shall be the responsibility of CONTRACTOR. The proper utility company shall be contacted immediately to expedite the repairs, if damage has occurred. CONTRACTOR will notify the COUNTY and provide a written explanation of the incident within two (2) days of the damage to any underground utilities.
Emergency Service If you are unable to reach Administrator at 877.634.0964 and you require emergency repair, you may contact any manufacturer authorized service repair facility listed in Your phone book or online. Mail Administrator Your original repair bill along with the technician’s report and a copy of the Agreement to the address at the top of this Agreement for reimbursement. All coverage and exclusions in this Agreement will apply.
Emergency Services The parties recognize that in the event of a strike or lockout, situations may arise of an emergency nature. To this end, the Employer and the Union will agree to provide services of an emergency nature.
Sidewalks doorways, vestibules, halls, stairways and other similar areas shall not be obstructed by Tenant or used by Tenant for any purpose other than ingress and egress to and from the Premises. No rubbish, litter, trash, or material shall be placed, emptied, or thrown in those areas. At no time shall Tenant permit Tenant’s employees to loiter in Common Areas or elsewhere about the Building or Property.
Roads The Purchaser is required to construct the roads shown in Table B-1 per the schedules stated, as shown on the Sale Map, Attachment A, and to the specifications and drawings in Attachment B and other applicable attachments.
Access to the Service Subject to the rights and limitations set out in this Agreement and your payment of all Subscription Fees when due, we grant you a limited, non- exclusive, non-sublicensable, non-transferable (except as expressly permitted herein) right to permit Users to access and use the Service during the Subscription Term: (i) solely for your internal business purposes; and (ii) for the scope of use set out in your Order and/or the Documentation. You shall not permit any unauthorized access to or use of the Service and shall notify us immediately in the event that you become aware of any unauthorized access or use.
Loop A transmission path that extends from a Main Distribution Frame or functionally comparable piece of equipment in a Customer's serving End Office, to the Rate Demarcation Point (or NID if installed at the Rate Demarcation Point) in or at the Customer's premises. The actual transmission facilities used to provide a Loop may utilize any of several technologies.