Mechanical Changeover. 2. Minor Lubrication
Mechanical Changeover Sample Clauses
Related to Mechanical Changeover
Technical changes The parties agree to make any technical changes that are mutually agreed prior to the going out for ratification. The parties on signing this document acknowledge, subject to any subsequent agreed editorial and technical changes, that this reflects the agreements reached in the settlement of the Primary Principals’ Collective Agreement 2019-2022. Signed in Wellington on 9 August 2019: Xxxxx Xxxxxx Advocate for NZEI Te Riu Roa Xxxx Xxxxxxxxxx Advocate for the Secretary for Education Witnessed: for NZSTA Annex 1
Mechanical Breakdowns 15.1 Any mechanical problems associated with the Vehicle must be reported to Apollo as soon as possible in order to give Apollo the opportunity to rectify the problem during the rental period. Equipment failure must also be reported to Apollo.
Mechanical a. Heating and cooling load calculations as required and major duct or pipe runs sized to interface with structural.
TECHNOLOGICAL CHANGE During the term of this Agreement any disputes arising in relation to adjustment to technological change shall be discussed between the Bargaining Representatives of the two parties to this Collective Agreement.
TECHNICAL EVALUATION (a) Detailed technical evaluation shall be carried out by Purchase Committee pursuant to conditions in the tender document to determine the substantial responsiveness of each tender. For this clause, the substantially responsive bid is one that conforms to all the eligibility and terms and condition of the tender without any material deviation. The Institute’s determination of bid’s responsiveness is to be based on the contents of the bid itself without recourse to extrinsic evidence. The Institute shall evaluate the technical bids also to determine whether they are complete, whether required sureties have been furnished, whether the documents have been properly signed and whether the bids are in order.
Start-Up and Synchronization Consistent with the mutually acceptable procedures of the Developer and Connecting Transmission Owner, the Developer is responsible for the proper synchronization of the Large Generating Facility to the New York State Transmission System in accordance with NYISO and Connecting Transmission Owner procedures and requirements.
TECHNOLOGICAL CHANGES 18.07.01 The intent and purpose of the following Articles is to ensure that ample consideration is given to the effect technological change will have upon the job security and conditions of employment of employees as well as the continuing effectiveness of the Company.
Maintenance and Testing 54.5.1. Sprint is only responsible for maintaining the facilities that it owns.
Installation and Maintenance Except for the bi‐directional and production metering equipment owned by the City, all equipment on Customer’s side of the delivery point, including the required disconnect device, shall be provided and maintained in satisfactory operating condition by Customer and shall remain the property and responsibility of the Customer. The City will bear no responsibility for the installation or maintenance of Customer’s equipment or for any damage to property as a result of any failure or malfunction thereof. The City shall not be liable, directly or indirectly for permitting or continuing to allow the interconnection of the Facility or for the acts or omissions of Customer or the failure or malfunction of any equipment of Customer that causes loss or injury, including death, to any party.
Electrical appliance safety The Hirer shall ensure that any electrical appliances brought by them to the premises and used there shall be safe, in good working order, and used in a safe manner in accordance with the Electricity at Work Regulations 1989. Where a residual circuit breaker is provided the hirer must make use of it in the interests of public safety.
