Minimum Trench Width
Minimum Trench Width Sample Clauses
Related to Minimum Trench Width
Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.
Trench Rock Trench rock is defined as any material that must be removed from a trench that cannot be excavated with a hydraulic excavator having a bucket curling force rated at not less than 18,300 pounds (Caterpillar Model 215 or equivalent) and occupies an original volume of at least one-half cubic yard.
MINIMUM ORDER QUANTITY The State makes no commitment to purchase any minimum or maximum quantity, or dollar volume of products from the selected suppliers. Utilization of this agreement will be on an as needed basis by State Agencies and/or Cooperative Participants, Cities, Counties, Schools K-12, Colleges and Universities. The State will award to multiple suppliers; however, the State reserves the right to purchase like and similar products from other suppliers as necessary to meet operational requirements. Note: Issuance of an award does not guarantee an order.
MINIMUM SHIFT 10.01 No employee shall be scheduled to work for less than three (3) hours in any one (1) shift. If no work or insufficient work is available, said employee shall nevertheless be paid for the full three (3) hours at their appropriate hourly rate of pay.
Width 6.7.4.1.1. The minimum width at the child-restraint straps which contact the dummy shall be 25 mm. These dimensions shall be measured during the strap strength test prescribed in paragraph 7.2.5.1. below, without stopping the machine and under a load equal to 75 per cent of the breaking load of the strap.
Shift Rotation Routine shift rotation is not an approach to staffing endorsed by the Employer. Except for emergency situations where it may be necessary to provide safe patient care, shift rotation will not be utilized without mutual consent. If such an occasion should ever occur, volunteers will be sought first. If no one volunteers, the Employer will rotate shifts on an inverse seniority basis until the staff vacancies are filled.
Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.
Minimum Term Each Service will continue for its specified Minimum Term and thereafter for any Renewal Term(s) unless notice to terminate the Service is given in accordance with this Agreement.
Minimum Terms This Agreement contains the minimum terms and conditions of employment or purchase to which the Writer is entitled. Except for credits for screen authorship, the Writer and Company are free to negotiate and contract for more favorable terms and conditions of employment than the minimum terms provided in this Agreement or the MBA. Only the WGA has the right to waive any of the provisions of this Agreement or the MBA.
Minimum Order When the Government requires supplies or services covered by this contract in an amount of less than one each, the Government is not obligated to purchase, nor is the Contractor obligated to furnish those supplies or services under the contract.
