Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
SHIPPING AND AIR TRANSPORT 1. Profits of an enterprise of a Contracting State from the operation of ships or aircraft in international traffic shall be taxable only in that State. 2. The provisions of paragraph 1 shall also apply to profits from the participation in a pool, a joint business or an international operating agency.
SMHS Governance, Safety and Quality Requirements 4.1 Participates in the maintenance of a safe work environment. 4.2 Participates in an annual performance development review. 4.3 Supports the delivery of safe patient care and the consumers’ experience including participation in continuous quality improvement activities in accordance with the requirements of the National Safety and Quality Health Service Standards and other recognised health standards. 4.4 Completes mandatory training (including safety and quality training) as relevant to role. 4.5 Performs duties in accordance with Government, WA Health, South Metropolitan Health Service and Departmental / Program specific policies and procedures. 4.6 Abides by the WA Health Code of Conduct, Occupational Safety and Health legislation, the Disability Services Act and the Equal Opportunity Act.
EMHS Governance, Safety and Quality Requirements 4.1 Participates in the maintenance of a safe work environment. 4.2 Actively participates in the Peak Performance program. 4.3 Supports the delivery of safe patient care and the consumers’ experience including participation in continuous quality improvement activities in accordance with the requirements of the National Safety and Quality Health Service Standards and other recognised health standards. 4.4 Completes mandatory training (including safety and quality training) as relevant to role. 4.5 Performs duties in accordance with the EMHS Vision and Values, WA Health Code of Conduct, Occupational Safety and Health legislation, the Disability Services Act and the Equal Opportunity Act and Government, WA Health, EMHS and Departmental / Program specific policies and procedures.
NMHS Governance, Safety and Quality Requirements 2.1 Participates in the maintenance of a safe work environment. 2.2 Participates in an annual performance development review. 2.3 Supports the delivery of safe patient care and the consumers’ experience including participation in continuous quality improvement activities in accordance with the requirements of the National Safety and Quality Health Service Standards and other recognised health standards. 2.4 Completes mandatory training (including safety and quality training) as relevant to role. 2.5 Performs duties in accordance with Government, WA Health, North Metropolitan Health Service and Departmental / Program specific policies and procedures. 2.6 Abides by the WA Health Code of Conduct, Occupational Safety and Health legislation, the Disability Services Act and the Equal Opportunity Act.
Gaming, betting and lotteries The Hirer shall ensure that nothing is done on or in relation to the premises in contravention of the law relating to gaming, betting and lotteries.
Marketing and Sales Provide a detailed plan beginning from award date of the Master Agreement describing the strategy to immediately implement the Master Agreement as supplier’s primary go to market strategy for Public Agencies to supplier’s teams, to include, but not limited to:
MARKETING AND REPRESENTATIONS 8.1 The Fund or its underwriter shall periodically furnish Insurance Company with the following documents, in quantities as Insurance Company may reasonably request: a. Current Prospectus and any supplements thereto; b. other marketing materials. Expenses for the production of such documents shall be borne by Insurance Company in accordance with Section 5.2 of this Agreement. 8.2 Insurance Company shall designate certain persons or entities which shall have the requisite licenses to solicit applications for the sale of Contracts. No representation is made as to the number or amount of Contracts that are to be sold by Insurance Company. Insurance Company shall make reasonable efforts to market the Contracts and shall comply with all applicable federal and state laws in connection therewith. 8.3 Insurance Company shall furnish, or shall cause to be furnished, to the Fund, each piece of sales literature or other promotional material in which the Fund, its investment adviser or the administrator is named, at least fifteen Business Days prior to its use. No such material shall be used unless the Fund approves such material. Such approval (if given) must be in writing and shall be presumed not given if not received within ten Business Days after receipt of such material. The Fund shall use all reasonable efforts to respond within ten days of receipt. 8.4 Insurance Company shall not give any information or make any representations or statements on behalf of the Fund or concerning the Fund or any Series in connection with the sale of the Contracts other than the information or representations contained in the registration statement or Prospectus, as may be amended or supplemented from time to time, or in reports or proxy statements for the Fund, or in sales literature or other promotional material approved by the Fund. 8.5 Fund shall furnish, or shall cause to be furnished, to Insurance Company, each piece of the Fund's sales literature or other promotional material in which Insurance Company or the Separate Account is named, at least fifteen Business Days prior to its use. No such material shall be used unless Insurance Company approves such material. Such approval (if given) must be in writing and shall be presumed not given if not received within ten Business Days after receipt of such material. Insurance Company shall use all reasonable efforts to respond within ten days of receipt. 8.6 Fund shall not, in connection with the sale of Series shares, give any information or make any representations on behalf of Insurance Company or concerning Insurance Company, the Separate Account, or the Contracts other than the information or representations contained in a registration statement or prospectus for the Contracts, as may be amended or supplemented from time to time, or in published reports for the Separate Account which are in the public domain or approved by Insurance Company for distribution to Contractholders or Participants, or in sales literature or other promotional material approved by Insurance Company. 8.7 For purposes of this Agreement, the phrase "sales literature or other promotional material" or words of similar import include, without limitation, advertisements (such as material published, or designed for use, in a newspaper, magazine or other periodical, radio, television, telephone or tape recording, videotape display, signs or billboards, motion pictures or other public media), sales literature (such as any written communication distributed or made generally available to customers or the public, including brochures, circulars, research reports, market letters, form letters, seminar texts, or reprints or excerpts of any other advertisement, sales literature, or published article), educational or training materials or other communications distributed or made generally available to some or all agents or employees, registration statements, prospectuses, statements of additional information, shareholder reports and proxy materials, and any other material constituting sales literature or advertising under National Association of Securities Dealers, Inc. rules, the Act or the 1933 Act.
Member Access to Vendor Proposal Notwithstanding any other information provided in this solicitation or Vendor designation of certain documentation as confidential or proprietary, Vendor’s acceptance of this TIPS Contract constitutes Vendor’s consent to the disclosure of Vendor’s comprehensive proposal, including any information deemed confidential or proprietary, to TIPS Members. The proposing Vendor agrees that TIPS shall not be responsible or liable for any use or distribution of information or documentation by TIPS Members or any other party. By submitting this proposal, Vendor certifies the foregoing. If the vendor is awarded a contract with TIPS under this solicitation, the vendor agrees to make any Choice of Law clauses in any contract or agreement entered into between the awarded vendor and with a TIPS member entity to read as follows: "Choice of law shall be the laws of the state where the customer resides" or words to that effect. Agreed In the event of litigation or use of any dispute resolution model when resolving disputes with a TIPS member entity as a result of a transaction between the vendor and TIPS or the TIPS member entity, the Venue for any litigation or other agreed upon model shall be in the state and county where the customer resides unless otherwise agreed by the parties at the time the dispute resolution model is decided by the parties. Agreed Texas and other states restrict by law or state Constitution the ability of a governmental entity to indemnify others. TIPS requires that any contract entered into between a vendor and TIPS or a TIPS Member as a result of an award under this Solicitation limit the requirement that the Customer indemnify the Vendor by either eliminating any such indemnity requirement clauses in any agreements, contracts or other binding documents OR by prefacing all indemnity clauses required of TIPS or the TIPS Member entity with the following: "To the extent permitted by the laws or the Constitution of the state where the customer resides, ". Agreed
