COUNTY’S QUALITY ASSURANCE PLAN The County or its agent will evaluate the Contractor’s performance under this Contract on not less than an annual basis. Such evaluation will include assessing the Contractor’s compliance with all Contract terms and conditions and performance standards. Contractor deficiencies which the County determines are severe or continuing and that may place performance of the Contract in jeopardy if not corrected will be reported to the Board of Supervisors. The report will include improvement/corrective action measures taken by the County and the Contractor. If improvement does not occur consistent with the corrective action measures, the County may terminate this Contract or impose other penalties as specified in this Contract.
Cultural Resources If a cultural resource is discovered, the Purchaser shall immediately suspend all operations in the vicinity of the cultural resource and notify the Forest Officer. Operations may only resume if authorized by the Forest Officer. Cultural resources identified and protected elsewhere in this contract are exempted from this clause. Cultural resources, once discovered or identified, are not to be disturbed by the Purchaser, or his, her or its employees and/or sub- contractors.
Cooperation on forestry matters and environmental protection 1. The aims of cooperation on forestry matters and environmental protection will be, but not limited to, as follows: (a) establishing bilateral cooperation relations in the forestry sector; (b) developing a training program and studies for sustainable management of forests; (c) improving the rehabilitation and sustainable management of forest with the aim of increasing carbon sinks and reduce the impact of climate change in the Asia-Pacific region; (d) cooperating on the execution of national projects, aimed at: improving the management of forest plantations for its transformation for industrial purposes and environmental protection; (e) elaborating studies on sustainable use of timber; (f) developing new technologies for the transformation and processing of timber and non-timber species; and (g) improving cooperation in agro-forestry technologies. 2. To achieve the objectives of the Article 149 (Objectives), the Parties may focus, as a means of cooperation and negotiations on concluding a bilateral agreement on forestry cooperation between the two Parties. Such collaboration will be as follows: (a) exchanges on science and technology as well as policies and laws relating the sustainable use of forest resources; (b) cooperation in training programs, internships, exchange of experts and projects advisory; (c) advice and technical assistance to public institutions and organizations of the Parties on sustainable use of forest resources and environmental protection; (d) facilitating forest policy dialogue and technical cooperation under the Network of Sustainable Forest Management and Forest Rehabilitation in Asia- Pacific Region, initiated at the 15th Asia Pacific Economic Cooperation (APEC) Meeting; (e) encouraging joint studies, working visits, exchange of experiences, among others; and (f) others activities mutually agreed.
Health and Safety Plan Consultant shall prepare and submit a Health and Safety Plan (“HASP”) for the portion of Consultant’s work that will involve field work, assessments, or investigations of certain Project elements. The HASP shall describe how Consultant plans to complete field work, assessments, and/or investigations at the RWF. Consultant’s HASP must comply with the CIP HASP and shall be updated as new conditions are encountered.
Health & Safety (a) The Employer and the Union agree that they mutually desire to maintain standards of safety and health in the Home, in order to prevent injury and illness and abide by the Occupational Health and Safety Act as amended from time to time. (b) A Joint Health and Safety Committee (JHSC) shall be constituted in accordance with the Act, which shall identify potential dangers, recommend means of improving the health and safety programs and obtaining information from the Employer or other persons respecting the identification of hazards and standards. The committee shall meet at least every three months or more frequently if the committee decides. The Employer agrees to accept as a member of its Joint Health and Safety Committee at least one (1) ONA representative selected or appointed by the Union from the Employer. Scheduled time spent in such meetings is to be considered time worked for which representative(s) shall be paid by the Employer at his or her regular or overtime rate. Minutes shall be taken of all meetings and copies shall be sent to the Committee members within two (2) weeks following the meeting, if possible. Minutes of the meetings shall be posted on the workplace health and safety bulletin board. (c) The Employer shall provide the time from work with pay and all related tuition costs and expenses necessary to certify the worker representative. Where an inspector makes an inspection of a workplace under the powers conferred upon him or her under the Occupational Health and Safety Act, the Employer shall afford a committee member representing workers the opportunity to accompany the inspector during his or her physical inspection of a workplace, or any part or parts thereof. Where a committee member is not available, the Employer shall afford a worker selected by a Union, because of knowledge, experience and training, to represent it, the opportunity to accompany the inspector during his or her physical inspection of a workplace, or any part or parts thereof. (d) Two (2) representatives of the Joint Health and Safety Committee, one (1) from management and one (1) from the employees, shall make monthly inspections of the work place and shall report to the health and safety committee the results of their inspection. The members of the Committee who represent the workers shall designate a member representing workers to inspect the workplace. Where possible that member shall be a certified member. The Employer shall provide the member with such information and assistance as the member may require for the purpose of carrying out an inspection of the workplace. Scheduled time spent in all such activities shall be considered as time worked. (e) The Joint Health and Safety Committee and the representatives thereof shall have access to Incident/Accident Report Form required in S.51, S.52 and S.53 of the Act and the annual summary of data from the WSIB relating to the number of work accident fatalities, the number of lost workday cases, the number of lost workdays, the number of non-fatal cases that required medical aid without lost workdays, the incidence of occupational injuries, and such other data as the WSIB may decide to disclose. It is understood and agreed that no information will be provided to the Committee which is confidential. This information shall be a standing item recorded in the minutes of each meeting. (f) The Union will use its best efforts to obtain the full co-operation of its membership in the compliance of all safety rules and practices. (g) The Employer will use its best efforts to make all affected direct care employees aware of residents who have serious infectious diseases. The nature of the disease need not be disclosed. Employees will be made aware of special procedures required of them to deal with these circumstances. The parties agree that all employees are aware of the requirement to practice universal precautions in all circumstances. (h) The parties further agree that suitable subjects for discussion at the Union-Management Committee and Joint Health and Safety Committee will include aggressive residents. The Employer will review with the Joint Health and Safety Committee written policies to address the management of violent behaviour. Such policies will include but not be limited to: i) Designing safe procedures for employees, ii) Providing training appropriate to these policies, iii) Reporting all incidents of workplace violence. (i) The Employer shall: i) Inform employees of any situation relating to their work which may endanger their health and safety, as soon as it learns of the said situation, ii) Inform employees regarding the risks relating to their work and provide training and supervision so that employees have the skills and knowledge necessary to safely perform the work assigned to them, When faced with occupational health and safety decisions, the Home will not await full scientific or absolute certainty before taking reasonable action(s) that reduces risk and protects employees. iii) Ensure that the applicable measures and procedures prescribed in the Occupational Health and Safety Act are carried out in the workplace. (j) A worker shall, i) Work in compliance with the provisions of the Occupational Health and Safety Act and the regulations, ii) Use or wear the equipment, protective devices or clothing that the worker's Employer requires to be used or worn, iii) Report to his or her Employer or supervisor the absence of or defect in any equipment or protective device of which the worker is aware and which may endanger himself, herself or another worker, and iv) Report to his or her Employer or supervisor any contravention of the Occupational Health and Safety Act or the regulations or the existence of any hazard of which he or she knows.
Electric Storage Resources Developer interconnecting an electric storage resource shall establish an operating range in Appendix C of its LGIA that specifies a minimum state of charge and a maximum state of charge between which the electric storage resource will be required to provide primary frequency response consistent with the conditions set forth in Articles 9.5.5, 9.5.5.1, 9.5.5.2, and 9.5.5.3 of this Agreement. Appendix C shall specify whether the operating range is static or dynamic, and shall consider (1) the expected magnitude of frequency deviations in the interconnection; (2) the expected duration that system frequency will remain outside of the deadband parameter in the interconnection; (3) the expected incidence of frequency deviations outside of the deadband parameter in the interconnection; (4) the physical capabilities of the electric storage resource; (5) operational limitations of the electric storage resources due to manufacturer specification; and (6) any other relevant factors agreed to by the NYISO, Connecting Transmission Owner, and Developer. If the operating range is dynamic, then Appendix C must establish how frequently the operating range will be reevaluated and the factors that may be considered during its reevaluation. Developer’s electric storage resource is required to provide timely and sustained primary frequency response consistent with Article 9.5.5.2 of this Agreement when it is online and dispatched to inject electricity to the New York State Transmission System and/or receive electricity from the New York State Transmission System. This excludes circumstances when the electric storage resource is not dispatched to inject electricity to the New York State Transmission System and/or dispatched to receive electricity from the New York State Transmission System. If Developer’s electric storage resource is charging at the time of a frequency deviation outside of its deadband parameter, it is to increase (for over-frequency deviations) or decrease (for under-frequency deviations) the rate at which it is charging in accordance with its droop parameter. Developer’s electric storage resource is not required to change from charging to discharging, or vice versa, unless the response necessitated by the droop and deadband settings requires it to do so and it is technically capable of making such a transition.
Human and Financial Resources to Implement Safeguards Requirements The Borrower shall make available necessary budgetary and human resources to fully implement the EMP and the RP.
Energy Cooperation shall focus on: (a) renewable energy; (b) promoting the saving of energy; (c) applied research relating to networks of databases linking the two Parties' economic and social operators; (d) backing efforts to modernise and develop energy networks and the interconnection of such networks with Community networks.
Energy Conservation The Contractor agrees to comply with mandatory standards and policies relating to energy efficiency which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act.
CERTIFICATION REGARDING BOYCOTTING CERTAIN ENERGY COMPANIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has ten (10) or more full-time employees; and (c) this contract has a value of $100,000 or more that is to be paid wholly or partly from public funds, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 13 (87th session), the company hereby certifies and verifies that the company, or any wholly owned subsidiary, majority-owned subsidiary, parent company, or affiliate of these entities or business associations, if any, does not boycott energy companies and will not boycott energy companies during the term of the contract. For purposes of this contract, the term “company” shall mean an organization, association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, that exists to make a profit. The term “boycott energy company” shall mean “without an ordinary business purpose, refusing to deal with, terminating business activities with, or otherwise taking any action intended to penalize, inflict economic harm on, or limit commercial relations with a company because the company (a) engages in the exploration, production, utilization, transportation, sale, or manufacturing of fossil fuel-based energy and does not commit or pledge to meet environmental standards beyond applicable federal and state law, or (b) does business with a company described by paragraph (a).” See Tex. Gov’t Code § 809.001(1).
