of this Regulation This Enhanced Child Restraint System shall be dynamically tested in one of the following ways: 6.6.4.1.2.1. Enhanced Child Restraint Systems according to paragraph 2.7. and in conformity with paragraph 6.3. of this Regulation and which fit in at least an envelope defined in UN Regulation No. 16, Annex 17, Appendix 2, on the test bench prescribed in Annex 6 and in conformity with paragraph 7.1. 3.1. of this Regulation or in a vehicle body shell in conformity with paragraph 7.1.3.2. of this Regulation. 6.6.4.1.2.2. For Enhanced Child Restraint Systems which are in conformity with paragraph 6.3. of this Regulation (for example ECRS using no anti-rotation device or using additional anchorages) or do not fit in any envelope defined in UN Regulation No. 16, Annex 17, Appendix 2 on the test trolley in a vehicle body shell in conformity with paragraph 7.1.3.2. or in a complete vehicle in conformity with paragraph 7.1.3.3. of this Regulation. 6.6.4.1.2.3. Using sufficient parts of the vehicle body shell to be representative of the vehicle structure and impact surfaces. If the Enhanced Child Restraint System is intended for use in the rear seat, these shall include the back of the front seat, the rear seat, the floor pan, the B and C pillars and the roof. If the Enhanced Child Restraint System is intended for use in the front seat, the parts shall include the dashboard, the A pillars, the windscreen, any levers or knobs installed in the floor or on a console, the front seat, the floor pan and the roof. The Technical Service responsible for conducting the test may permit items to be excluded if they are found to be superfluous. Testing shall be as prescribed in paragraph 7.1.3.2. of this Regulation, except for lateral impact. 6.6.4.1.3. The dynamic test shall be performed on Child Restraint Systems which have not previously been under load. The Enhanced Child Restraint System of the i-Size booster seat category shall be tested on the test bench described in Annex 6, and in conformity with paragraph 7.1.3.1. below. 6.6.4.1.4. If an "Specific vehicle ISOFIX" Enhanced Child Restraint System is installed in the area behind the rearmost forward facing adult seat positions (for example, the luggage area), one test with the largest dummy/dummies, as allowed by the Enhanced Child Restraint System, on a complete vehicle as prescribed in paragraph 7.1.3.
of this Agreement If the State elects to accept the defective or nonconforming Work, a Change Order will be issued to reflect a reduction in the Contract Sum. The Architect will recommend to the State the value of diminishment of the defective or nonconforming Work. Such adjustment shall be effected whether or not final payment has been made.
FAIR LABOR STANDARDS The Contractor shall comply with all applicable provisions of the Federal Fair Labor Standards Act and shall indemnify, defend, and hold harmless the County and its agents, officers, and employees from any and all liability, including, but not limited to, wages, overtime pay, liquidated damages, penalties, court costs, and attorneys' fees arising under any wage and hour law, including, but not limited to, the Federal Fair Labor Standards Act, for work performed by the Contractor’s employees for which the County may be found jointly or solely liable.
FAIR LABOR STANDARDS ACT 314. To the extent that the Agreement fails to afford employees the overtime or compensatory time off benefits to which they are entitled under the Fair Labor Standards Act, the Agreement is amended to authorize and direct all City Departments to ensure that their employees receive, at a minimum, such Fair Labor Standards Act Benefits.
Export Regulation You acknowledge that the Licensed Software and related technical data and services (collectively "Controlled Technology") are subject to the import and export laws of the United States, specifically the U.S. Export Administration Regulations (EAR), and the laws of any country where Controlled Technology is imported or re-exported. You agree to comply with all relevant laws and will not to export any Controlled Technology in contravention to U.S. law nor to any prohibited country, entity, or person for which an export license or other governmental approval is required. All Symantec products, including the Controlled Technology are prohibited for export or re-export to Cuba, North Korea, Iran, Syria and Sudan and to any country subject to relevant trade sanctions. You hereby agree that You will not export or sell any Controlled Technology for use in connection with chemical, biological, or nuclear weapons, or missiles, drones or space launch vehicles capable of delivering such weapons.
Governmental Regulations, Etc (a) No part of the proceeds of the Loans will be used, directly or indirectly, for the purpose of purchasing or carrying any “margin stock” in violation of Regulation U. If requested by any Lender or the Administrative Agent, the Borrower will furnish to the Administrative Agent and each Lender a statement to the foregoing effect in conformity with the requirements of FR Form U-1 referred to in said Regulation U. No indebtedness being reduced or retired out of the proceeds of the Loans was or will be incurred for the purpose of purchasing or carrying any margin stock within the meaning and in violation of Regulation U or any “margin security” within the meaning and in violation of Regulation T. “Margin stock” within the meanings of Regulation U does not constitute more than 25% of the value of the consolidated assets of the Borrower and its Subsidiaries. None of the transactions contemplated by this Credit Agreement (including, without limitation, the direct or indirect use of the proceeds of the Loans) will violate or result in a violation of the Securities Act of 1933, as amended, or the Securities Exchange Act of 1934, as amended, or regulations issued pursuant thereto, or Regulation T, U or X. (b) Neither the Borrower nor any of its Subsidiaries is subject to regulation under the Federal Power Act or the Investment Company Act of 1940, each as amended. In addition, neither the Borrower nor any of its Subsidiaries is an “investment company” registered or required to be registered under the Investment Company Act of 1940, as amended, and is not controlled by such a company. (c) Each of the Borrower and its Subsidiaries has obtained all licenses, permits, franchises or other governmental authorizations necessary to the ownership of its respective Property and to the conduct of its business, except where such failure could not reasonably be expected to have a Material Adverse Effect. (d) Neither the Borrower nor any of its Subsidiaries is in violation of any applicable statute, regulation or ordinance of the United States of America, or of any state, city, town, municipality, county or any other jurisdiction, or of any agency thereof (including without limitation, environmental laws and regulations), except where such violation could not reasonably be expected to have a Material Adverse Effect. (e) Each of the Borrower and its Subsidiaries is current with all material reports and documents, if any, required to be filed with any state or federal securities commission or similar agency and is in full compliance in all material respects with all applicable rules and regulations of such commissions, except where such failure could not reasonably be expected to have a Material Adverse Effect.
Compliance with Statutes, Regulations, Etc The Borrower will, and will cause each Subsidiary to, comply with all applicable laws, rules, regulations and orders applicable to it or its property, including all governmental approvals or authorizations required to conduct its business, and to maintain all such governmental approvals or authorizations in full force and effect, in each case except where the failure to do so could not reasonably be expected to have a Material Adverse Effect.
References to Statutes, Public Acts, Regulations, Codes and Executive Orders All references in this Contract to any statute, public act, regulation, code or executive order shall mean such statute, public act, regulation, code or executive order, respectively, as it has been amended, replaced or superseded at any time. Notwithstanding any language in this Contract that relates to such statute, public act, regulation, code or executive order, and notwithstanding a lack of a formal amendment to this Contract, this Contract shall always be read and interpreted as if it contained the most current and applicable wording and requirements of such statute, public act, regulation, code or executive order as if their most current language had been used in and requirements incorporated into this Contract at the time of its execution.
Operation of this Agreement This Agreement shall take effect on and from the date of this Agreement. The parties must execute and enter into this Agreement as soon as possible after the Development Consent is granted and prior to the issue of any Construction Certificate that relates to any building work, other than demolition, excavation, piling, shoring and ancillary work for construction purposes including site hoardings and temporary site sheds that relates to works contained in DA-152/2021/B.
Contractor Standards Contractor shall comply with Contractor Standards provisions codified in the SDMC. Contractor understands and agrees that violation of Contractor Standards may be considered a material breach of the Contract and may result in Contract termination, debarment, and other sanctions.
