Open Lab. .5 hr. of load for each hour in the lab Internship: Will be defined as a co-operative work experience.
Open Lab Sample Clauses
Related to Open Lab
Open Listing The general non-exclusive right to sell, trade, convey, or exchange the Property during the Listing Period in accordance with the terms and conditions set forth in this Agreement. Seller hereby appoints Agency to represent the Seller as their client ONLY if a potential Buyer is produced by the Agency. Seller retains the right to sell the Property directly, on their own behalf, with no commission due to the Agency. In addition, Seller reserves the right to enter into similar arrangements with other real estate agents.
Open House The administration shall schedule, within each school year, an evening open house not to exceed three (3) hours. Each teacher shall attend this evening open house session. Fulfillment of this provision shall provide each teacher with a half day of compensatory time pursuant to this article.
OFFSET CREDIT/COOPERATION This Contract has been entered into in direct support of LOCKHEED XXXXXX'x international offset programs. All offset benefit credits resulting from this Contract are the sole property of LOCKHEED XXXXXX to be applied to the offset program of its choice. SELLER shall assist LOCKHEED XXXXXX in securing appropriate offset credits from the respective country government authorities.
Cash Basis and Budget Laws The right of the City to enter into this Agreement is subject to the provisions of the Cash Basis Law (K.S.A. 10-1112 and 10-1113), the Budget Law (K.S.A. 79-2935), and all other laws of the State of Kansas. This Agreement shall be construed and interpreted so as to ensure that the City shall at all times stay in conformity with such laws, and as a condition of this Agreement the City reserves the right to unilaterally sever, modify, or terminate this Agreement at any time if, in the opinion of its legal counsel, the Agreement may be deemed to violate the terms of such laws.
Earned Value Management System An earned value management system (EVMS) means a project management tool that effectively integrates the project scope of work with cost, schedule and performance elements for optimum project planning and control. The qualities and operating characteristics of EVMS are described in American National Standards Institute /Electronics Industries Alliance (ANSI/EIA) Standard-748. An EVMS is not mandatory; however, Contractors are encouraged to have an EVMS ANSI/EIA Standard-748 during the entire term of OASIS. The Contractor shall notify the OASIS CO, in writing, if there are any changes in the status of their EVMS and provide the reasons for the change and copies of audits by the Defense Contract Management Agency (DCMA) or other cognizant Government administration office, as applicable. If only part of a Contractor’s organization is EVMS ANSI/EIA Standard-748 certified, the Contractor shall make the distinction between which business units or sites and geographic locations have been certified.
TREE TRIMMING Grantee or its designee shall have the authority to trim trees on public property at its own expense as may be necessary to protect its wires and facilities.
Addressing Objections Raised During Public Comment Period The Parties agree that the procedure contemplated for public review of this Stipulated Order and the Regional Water Board’s or its delegate’s adoption of this Stipulated Order is lawful and adequate. The Parties understand that the Regional Water Board or its delegate has the authority to require a public hearing on this Stipulated Order. If procedural objections are raised or the Regional Water Board requires a public hearing prior to the Stipulated Order becoming effective, the Parties agree to meet and confer concerning any such objections, and may agree to revise or adjust the procedure and/or this Stipulated Order as necessary or advisable under the circumstances.
As-Built Plans Within thirty (30) days after completion of Tenant’s Changes requiring the submission of plans to Landlord, Tenant shall furnish to Landlord a complete set of “as-built” plans and specifications.
Measurements and arithmetic conventions All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.
