Classification Definitions Note: The following classification definitions should be read in conjunction with: • the stream and field definitions in subclause 1.4.3 and 1.4.75 respectively: • the definitions of “or equivalent”, “work within the scope of this level” and “Engineering Associate” at the end of this Schedule; • the National Metal and Engineering Competency Standards Implementation Guide especially Table 2 of that Guide which shows the alignment between old and new titles under the Australian Qualifications Framework. For example Advanced Certificates are now known as National Diplomas and Associate Diplomas as National Advanced Diplomas; • Clause 5.1.3 (f) Points. Trainer/Supervisor/Coordinator - Level 1 A Trainer/Supervisor/Coordinator - Level I is an employee who is responsible for the work of other employees and/or provision of structured on-the-job training. Such an employee has completed a qualification at AQFIII level or above, of which at least one third of the competencies are related to supervision/training, or equivalent. Notwithstanding the above definition an employee who is mainly engaged to perform work supervising or coordinating the work of other employees and who has sufficient additional training beyond that of those coordinated or supervised so as to enable the employee to perform work within the scope of this level shall be classified at this level. Trainer/Supervisor/Coordinator - Level II A Trainer/Supervisor/Coordinator - Level II is an employee who is responsible for the supervision and/or training of Trainers/Supervisors/Coordinators - Level I. Such an employee has completed an AQF IV or V qualification or equivalent of which at least 50% of the competencies are in supervision/training. WAGE GROUP: C14 Engineering/Production Employee - Level I As Engineering/Production Employee - Level I is an employee who is undertaking up to 38 hours induction training which may include information on the enterprise, conditions of employment, introduction to supervisors and fellow workers, training and career path opportunities, plant layout, work and documentation procedures, occupational health and safety, equal employment opportunity and quality control/assurance. An employee at this level performs routine duties essentially of a manual nature and to the level of his/her training:
Specific Definitions The following terms used in this Agreement shall have the following meanings:
PROJECT DEFINITIONS The following capitalized terms have the meanings assigned below for purposes of Exhibits A and B.
– SCOPE & DEFINITIONS 2.01 The Employer recognizes the Ontario Nurses’ Association as the bargaining agent for all registered nurses and registered nurses with a temporary certificate of registration engaged in a nursing capacity at St. Gabriel’s Villa in Sudbury, Ontario save and except Director of Care and those persons above the rank of Director of Care.
SECTION I - DEFINITIONS As used in this Agreement, the following terms shall have the meanings ascribed herein unless otherwise stated or reasonably required by the Agreement, and other forms of any defined words shall have a meaning parallel thereto.
Basic Definitions 1.1.9.1 Addenda. Written or graphic instruments issued prior to the opening of bids that clarify, correct, or change any of the component parts of the Bidding documents.
Interpretation Definitions Unless the context shall otherwise require: words in the singular shall also include the plural, and vice versa; any pronoun shall include the corresponding masculine, feminine and neuter forms; the words “include”, “includes” and “including” shall be deemed to be followed by the phrase “without limitation”; the words “herein”, “hereof” and “hereunder” and words of similar import refer to this Agreement in its entirety and not to any part hereof; all references herein to Sections or clauses shall be deemed references to Sections or clauses of this Agreement; any references to any agreement or other instrument or law, statute or regulation are to it as amended, supplemented or restated, from time to time (and, in the case of any law, to any successor provisions or re-enactment or modification thereof being in force at the time); any reference to “law” shall include any supranational, national, federal, state, local, or foreign statute or law and all rules and regulations promulgated thereunder; any reference to a “day” or a number of “days” (without any explicit reference otherwise, such as to business days) shall be interpreted as a reference to a calendar day or number of calendar days; reference to month or year means according to the Gregorian calendar; reference to a “
