Timber Designations Timber designated for cutting shall be confined to Sale Area, except as provided in B2.131, B2.14, B2.15, B2.32, and B5.1. Sale Area Map indicates subdivisions, if any, where Marking under B2.35 is to be done after timber sale advertisement, except for construction clearing under B2.32, minor changes under B2.37, and damaged timber. The boundaries of Clearcutting Units, Overstory Re- moval Units, and Understory Removal Units were plainly Marked on ground before timber sale advertisement and are shown on Sale Area Map. Boundary trees shall not be cut. The number of units and approximate acreage of timber designations are stated in A3.
Written Designation The Owner shall designate, in writing, a representative authorized to act on the Owner's behalf with respect to the Project. The Owner hereby designates the party identified in the Contract as its initial authorized representative and reserves the right to designate additional or replacement representatives by written notice to the Contractor.
Filing Designation The City Department Director will designate each individual who will be providing services to the City pursuant to the Agreement as full disclosure, limited disclosure, or excluded from disclosure, based on an analysis of the services the Consultant will provide. Notwithstanding this designation or anything in the Agreement, the Consultant is ultimately responsible for complying with FPPC regulations and filing requirements. If you have any questions regarding filing requirements, please do not hesitate to contact the City Clerk at (000)000-0000, or the FPPC at 0-000-XXX-XXXX, or (000) 000-0000 *2. Pursuant to the duly adopted City of Chula Vista Conflict of Interest Code, this document shall serve as the written determination of the consultant’s requirement to comply with the disclosure requirements set forth in the Code.
Project Administration Designation Pursuant to Paragraph (B) of Rule 164-1-21 of the Administrative Code, the Recipient shall designate its Chief Executive Officer, Chief Fiscal Officer and Project Manager in Appendix B of this Agreement. Changes in these designations must be made in writing.
Leave, Board of Directors A nurse who is elected to the Board of Directors of the Ontario Nurses' Association, other than to the office of President, shall be granted upon request such leave(s) of absence as she or he may require to fulfill the duties of the position. Reasonable notice - sufficient to adequately allow the Hospital to minimize disruption of its services shall be given to the Hospital for such leave of absence. Notwithstanding Article 10.04, there shall be no loss of seniority or service for a nurse during such leave of absence. Leave of absence under this provision shall be in addition to the Union leave provided in Article 11.02
Teachers with Principal Designations (Effective October 22, 2019, the following repeals and replaces clause 4.4. above)
School Official Designation Pursuant to Article I, Paragraph 1 of the DPA Standard Clauses, and in accordance with FERPA, ISSRA and SOPPA, in performing its obligations under the DPA, the Provider is acting as a school official with legitimate educational interest; is performing an institutional service or function for which the LEA would otherwise use its own employees; is under the direct control of the LEA with respect to the use and maintenance of Student Data; and is using Student Data only for an authorized purpose and in furtherance of such legitimate educational interest.
Governing Board 1. The Centre shall be guided and overseen by a Governing Board renewed every 3 years and include:
Agency Head or Designee If the grievance is not resolved at Step 1, the Association may move it to Step 2 by filing the written grievance with the agency head, with a copy to the Human Resources Office, within fifteen (15) days of the Association’s receipt of the Step 1 decision. Upon agreement of the parties, the agency head or designee will meet or confer by telephone with an Association xxxxxxx and/or staff representative and the grievant within fifteen (15) days of receipt of the Step 1 decision. Management will provide a written response to the Association within fifteen (15) days after the meeting and if the remedies are denied the response will include an explanation.
Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from BellSouth’s Main Distribution Frame (MDF) to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (DAMLs), and may have up to 6,000 feet of bridged tap between the End User’s premises and the serving wire center. The UCL-ND typically will be 1300 Ohms resistance and in most cases will not exceed 18,000 feet in length, although the UCL-ND will not have a specific length limitation. For Loops less than 18,000 feet and with less than 1300 Ohms resistance, the Loop will provide a voice grade transmission channel suitable for Loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point.
