Construction and Maintenance There are on-going maintenance, renovation and construction projects taking place in and around the residences. The work typically takes place during regular business hours, but may begin earlier or extend into evenings or weekends. On-going construction or renovation projects will continue through midterm and final exam periods. The University will take measures to ensure that prudent construction practices are followed, but there may be noise, dust and temporary interruption of some services. Residents may be required to temporarily or permanently relocate to facilitate construction or renovation to their residence area. There will be no compensation or reduction to your residence fees due to disruption and/or relocation.
Operation and Maintenance 17.1 O&M obligations of the Concessionaire 17.1.1 During the Operation Period, the Concessionaire shall operate and maintain the Bus Terminal in accordance with this Agreement either by itself, or through the O&M Contractor and if required, modify, repair or otherwise make improvements to the Bus Terminal to comply with the provisions of this Agreement, Applicable Laws and Applicable Permits, and conform to Specifications and Standards and Good Industry Practice. The obligations of the Concessionaire hereunder shall include: (a) permitting safe, smooth and uninterrupted flow of traffic on the Bus Terminal during normal operating conditions. Buses of other state road transport corporations shall be parked inside the Bus Terminal for which no charges shall be payable to the Concessionaire and if any charges are applicable for such parking then it shall be realized by Authority only; (b) minimising incidents affecting the safety and use of the Bus Terminal by providing a rapid and effective response and maintaining liaison with emergency services of the State; (c) carrying out periodic preventive maintenance of the Bus Terminal; (d) undertaking routine maintenance including prompt repairs of ticket counters, Workshops, Authority's Office and other infrastructure as mentioned in the Operation and Maintenance Schedule; (e) undertaking major maintenance such as per the Maintenance Schedule of the major infrastructure in the Bus Terminal; (f) preventing, with the assistance of the concerned law enforcement agencies, any encroachments on the Bus Terminal; (g) protection of the environment and provision of equipment and materials therefor; (h) operation and maintenance of all communication, control and administrative systems necessary for the efficient operation of the Bus Terminal; (i) maintaining a public relations unit to interface with and attend to suggestions from the Users, passengers, government agencies, media and other agencies; (j) complying with Safety Requirements in accordance with Article 18; (k) operation and maintenance of all Project Assets diligently and efficiently and in accordance with Good Industry Practice; (l) maintaining punctuality and reliability in operating the Bus Terminal; and (m) maintaining a high standard of cleanliness and hygiene in the Bus Terminal. 17.1.2 The Concessionaire shall remove promptly from the Bus Terminal all surplus construction machinery and materials, waste materials (including hazardous materials and waste water), rubbish and other debris (including, without limitation, accident debris) and keep the Bus Terminal in a clean, tidy and orderly condition,
Installation and Maintenance Except for the bi‐directional and production metering equipment owned by the City, all equipment on Customer’s side of the delivery point, including the required disconnect device, shall be provided and maintained in satisfactory operating condition by Customer and shall remain the property and responsibility of the Customer. The City will bear no responsibility for the installation or maintenance of Customer’s equipment or for any damage to property as a result of any failure or malfunction thereof. The City shall not be liable, directly or indirectly for permitting or continuing to allow the interconnection of the Facility or for the acts or omissions of Customer or the failure or malfunction of any equipment of Customer that causes loss or injury, including death, to any party.
Prosecution and Maintenance DOV shall be responsible, at its own expense, for the preparation, filing, prosecution and maintenance (including, without limitation, any interferences, oppositions, reissue proceedings and reexaminations) of the DOV Patents. Wyeth shall reasonably consult with DOV with respect to the preparation, filing, prosecution and maintenance of the DOV Patents. DOV shall keep Wyeth advised of the status of such activities and shall also inform Wyeth in a timely manner of any material communications DOV receives from the relevant patent office with respect to such activities. DOV shall give notice to Wyeth of any desire to cease preparation, filing, prosecution or maintenance of any DOV Patent on a country-by-country basis, and in such case, to the extent not in conflict with DOV’s obligations under any agreement under which DOV has licensed such DOV Patent to a third party for use in the Field (as of the Signature Date or thereafter), Wyeth shall have the right to elect to continue preparation, filing, prosecution and maintenance of such DOV Patent. In the event that Wyeth elects to continue any such activities for such DOV Patent, Wyeth shall reasonably consult with DOV with respect thereto and shall consider in good xxxxx Xxxxx’x reasonable views with respect to such activities, and DOV agrees to transfer to Wyeth all information reasonably requested by Wyeth for Wyeth to conduct such activities and to otherwise reasonably cooperate with Wyeth in such actions. Wyeth shall keep DOV advised of the status of such actions and shall also inform DOV in a timely manner of any material communications Wyeth receives from the relevant patent office with respect to such activities. Each party shall bear its own costs with respect to any preparation, filing, prosecution and maintenance of any DOV Patent for which it is responsible.
USE AND MAINTENANCE Except as may be otherwise specified on any Schedule, (a) Lessee shall (1) use the Equipment solely in the continental United States and in the conduct of its business, for the purpose for which the Equipment was designed, in a careful and proper manner, and shall not permanently discontinue use of the Equipment; (2) operate, maintain, service and repair the Equipment, and maintain all records and other materials relating thereto, (A) in accordance and consistent with (i) all maintenance and operating manuals or service agreements, whenever furnished or entered into, including any subsequent amendments or replacements thereof, issued by the supplier or service provider, (ii) the requirements of all applicable insurance policies, (iii) manufacturer’s recommendations, (iv) the original purchase agreement under which such Equipment was acquired, so as to preserve all of Lessee’s and Lessor’s rights thereunder, including all rights to any warranties, indemnities or other rights or remedies, as and if applicable, (v) all applicable laws, and (vi) the prudent practice of other similar companies in the same business as Lessee, but in any event, to no lesser standard than that employed by Lessee for comparable equipment owned or leased by it; and (B) without limiting the foregoing, so as to cause the Equipment to be in good repair and operating condition and in at least the same condition as when delivered to Lessee hereunder, except for ordinary wear and tear resulting despite Lessee's full compliance with the terms hereof; (3) provide written notice to Lessor not less than thirty (30) days after any change of the location of any Equipment (or the location of the principal garage of any Equipment, to the extent that such Equipment is mobile equipment) as specified in the Schedule; and (4) not attach or incorporate the Equipment into any property except for other Equipment in such a manner that the Equipment may be deemed to have become an accession to or a part of such other property.
Supply and Maintenance of Equipment It is the responsibility of the Employer to furnish and maintain all equipment, machinery and supplies required by employees in the performance of their duties. Employees shall not suffer any loss in salary in the event that they cannot carry out their normal duties by reason of the Employer failing to properly maintain equipment, machinery or supplies or by reason of power failures or other circumstances not attributable to the employees.
Operation and Maintenance of Properties The Borrower will, and will cause each of its Subsidiaries to: (a) operate its Oil and Gas Properties and other material Properties or cause such Oil and Gas Properties and other material Properties to be operated in a careful and efficient manner in accordance with the practices of the industry and in compliance with all applicable contracts and agreements and in compliance with all Governmental Requirements, including, without limitation, applicable proration requirements and Environmental Laws, and all applicable laws, rules and regulations of every other Governmental Authority from time to time constituted to regulate the development and operation of its Oil and Gas Properties and the production and sale of Hydrocarbons and other minerals therefrom, except, in each case, where the failure to comply could not reasonably be expected to have a Material Adverse Effect. (b) keep and maintain all Property material to the conduct of its business in good working order and condition, ordinary wear and tear excepted preserve, maintain and keep in good repair, working order and efficiency (ordinary wear and tear excepted) all of its material Oil and Gas Properties and other material Properties, including, without limitation, all material equipment, machinery and facilities. (c) promptly pay and discharge, or make reasonable and customary efforts to cause to be paid and discharged, all delay rentals, royalties, expenses and indebtedness accruing under the leases or other agreements affecting or pertaining to its Oil and Gas Properties and will do all other things necessary to keep unimpaired their rights with respect thereto and prevent any forfeiture thereof or default thereunder. (d) promptly perform or make reasonable and customary efforts to cause to be performed, in accordance with industry standards and in all material respects, the obligations required by each and all of the assignments, deeds, leases, sub-leases, contracts and agreements affecting its interests in its Oil and Gas Properties and other material Properties. (e) to the extent the Borrower or one of its Subsidiaries is not the operator of any Property, the Borrower shall use reasonable efforts to cause the operator to comply with this Section 8.06.
Maintenance of Services A. Reseller will adopt and adhere to the standards contained in the applicable BellSouth Work Center Interface Agreement regarding maintenance and installation of service. B. Services resold under the Company’s Tariffs and facilities and equipment provided by the Company shall be maintained by the Company. C. Reseller or its end users may not rearrange, move, disconnect, remove or attempt to repair any facilities owned by the Company, other than by connection or disconnection to any interface means used, except with the written consent of the Company. D. Reseller accepts responsibility to notify the Company of situations that arise that may result in a service problem. E. Reseller will be the Company's single point of contact for all repair calls on behalf of Reseller’s end users. The parties agree to provide one another with toll-free contact numbers for such purposes. F. Reseller will contact the appropriate repair centers in accordance with procedures established by the Company. G. For all repair requests, Reseller accepts responsibility for adhering to the Company's prescreening guidelines prior to referring the trouble to the Company. H. The Company will xxxx Reseller for handling troubles that are found not to be in the Company's network pursuant to its standard time and material charges. The standard time and material charges will be no more than what BellSouth charges to its retail customers for the same services. I. The Company reserves the right to contact Reseller’s customers, if deemed necessary, for maintenance purposes.
Prosecution and Maintenance of Patents (a) Subject to any Adolor third party agreements, Adolor shall prepare, file prosecute and maintain in the Territory and at its own costs, upon consultation with Santen, the Adolor Patents and any jointly owned patents. Adolor shall notify Santen of the status of all patent filings (including, without limitation, the grant of any Adolor Patents) and, upon the request of Santen, shall provide advance copies of any papers relating to the filing, prosecution, or maintenance of such Adolor Patents. For Adolor Patents and patent applications, and for jointly owned patents and patent applications, Santen shall reimburse Adolor for one-half of any and all costs for the filing, prosecution, or maintenance of such patents and patent applications incurred by Adolor. Adolor shall submit an invoice for reimbursement of such patent costs to Santen and Santen shall pay such invoice within thirty (30) days of submission by Adolor. Santen shall have the right to audit the patent costs subject to reimbursement once per year. Such audit rights shall expire twenty- four (24) months after an invoice is submitted by Adolor for payment. (b) Subject to Section 8.04 (b), all amounts for patent applications paid by Santen under Section 8.02 (a) for each country of the Territory shall be creditable on a country-by-country basis against future Royalties payable to Adolor by Santen for each such country; provided, however, that no more than **% of the Royalties payable for any period in such country shall be paid by crediting amounts paid by Santen under Section 8.02(a), and further **=Certain information on this page has been omitted and filed separately with the Commission. Confidential treatment has been requested with respect to the omitted portions. provided that Santen may carry forward all amounts paid under Section 8.02(a) for crediting against future Royalties in such country under this Section 8.02(b) until such amounts are exhausted.
Support and Maintenance Where Licensee purchases support and/or maintenance services, Licensee’s initial support and/or maintenance term will begin upon delivery to Licensee of the Licensed Software and continue for one (1) year thereafter (or the length of the term if less than a year for any subscription/term license) unless otherwise specified in the applicable annual support and/or maintenance agreement, Product Order, or other written agreement executed between Licensor and Licensee. Where Licensee purchases support and/or maintenance for any Licensed Software, Licensee hereby agrees that it shall purchase such support and/or maintenance services for all of Licensee’s licensed units of such Licensed Software product. Support and/or maintenance services provided by Licensor will be subject to Licensor’s then current applicable standard annual support and/or maintenance agreement unless otherwise agreed by the parties in writing.
