Refrigerated Loads Sample Clauses

Refrigerated Loads. Motor Carrier’s drivers shall ensure paperwork received from Broker or its Shipper-Customer specifies a set temperature requirement, that the refrigeration unit is functional, that the temperature gauge is working accurately, and that the temperature gauge on the Equipment reflects the temperature noted on the Broker’s or its Shipper-Customer’s paperwork. Motor Carrier’s driver shall not depart from Shipper or Consignor’s facility until these requirements are met.
AutoNDA by SimpleDocs
Refrigerated Loads. Prior to loading, the driver must confirm that the reefer unit is working properly, and the trailer has been pre-cooled to the required temperature. The driver must also check for leaks in the door seals. Carrier Contract Addendum □ The driver is responsible for making sure adequate space is provided for air circulation in front, rear, top, bottom, and between the product units. □ Trailers hauling produce or live goods must have an air chute for proper circulation. No exceptions! It is the driver’s responsibility to make sure the chute is not damaged or blocked in any way. □ The driver must check the pulp temperature of the product to ensure that it has been pre-cooled. The driver should not accept any fresh product pulping over 2 degrees above the required temperature noted on the Carrier Rate Confirmation. If the temperature on the Carrier Rate Confirmation differs from that written on the Bill of Lading, call the brokerage office immediately at (000) 000-0000 before signing the bills at the shipper. The driver must make sure the pulp temperature of the product loaded is written on the original Bill of Lading. □ Driver must maintain “Continuous” temperature in-route as noted on the Carrier Rate Confirmation. FLATBED / STEP DECK LOADS □ Carriers must supply the appropriate chains, binders, straps, tarps, etc. required to move the load in a safe and efficient manner. □ Carriers are responsible for verification of all Dimensions, Weights and Serials Numbers of cargo prior to loading. Contact Brokerage if there is any discrepancies on BOL. OVER DIMENSIONAL / OVERWEIGHT LOADS □ Xxxxxxx is responsible for “All” permits, escorts, route surveys, bridge surveys, utility assistance and ancillary cost involving the movement of the load. Xxxxxxx certifies that all dimensions and weights are correct upon acceptance of freight.

Related to Refrigerated Loads

  • Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)

  • Garbage The Concessionaire will contract directly with the service provider for adequate dumpster capacity and wildlife resistance. The Department must pre- approve the location of dumpsters and frequency of pick-ups. The Concessionaire will provide recycle bins for use by Park visitors.

  • Heating The Hirer shall ensure that no unauthorised heating appliances shall be used on the premises when open to the public without the consent of the management committee. Portable Liquefied Propane Gas (LPG) heating appliances shall not be used.

  • Containers The marine and intermodal cargo containers either owned or leased by the Borrower and employed by the Borrower in the conduct of its business, including, without limitation, refrigerated, dry van, tank, open top and flat rack containers and refrigeration units and generator sets associated therewith, but excluding any chassis for such containers.

  • Trash Tenant shall not allow anything to be placed on the outside of the Building, nor shall anything be thrown by Tenant out of the windows or doors, or down the corridors or ventilating ducts or shafts, of the Building. All trash and refuse shall be placed in receptacles provided by Landlord for the Building or by Tenant for the Premises.

  • Ventilation Where noxious or poisonous gases may accumulate, the City shall provide proper protection and ventilation. Proper lighting and ventilation shall be provided for all enclosed working spaces. All work in enclosed and confined spaces shall be performed in accordance with applicable Federal, State and local regulations. Spray painting shall be done only by qualified painters.

  • Lighting A system of fixtures providing or controlling the light sources used on or near the airport or within the airport buildings. The field lighting includes all luminous signals, markers, floodlights, and illuminating devices used on or near the airport or to aid in the operation of aircraft landing at, taking off from, or taxiing on the airport surface.

  • Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.

  • Cleaning 8.1 CONTRACTOR shall, at his own expenses, at all times keep the premises free from accumulation of debris, waste materials, and rubbish, and at the completion of the work, he shall remove his tools and equipment and all surplus materials, debris, waste material, and rubbish and shall leave the premises in a neat and clean condition. If CONTRACTOR does not attend to such cleaning immediately upon request, OWNER shall have the right to have this work done by others and deduct the cost therefore from the payment due CONTRACTOR hereunder.

  • Generator Subject to the provisions of this Section 29.36, Tenant shall be entitled to install, operate and maintain a generator and any other equipment related thereto, including, without limitation, a fuel system, wiring and shaft space (“Generator”) next to the Building at Tenant’s sole cost and expense (without paying any additional fee or rental to Landlord for the use thereof). Prior to the installation of the Generator, Tenant shall inspect the proposed location to determine a suitable location for the Generator, and Tenant shall submit written plans and specifications relative to the type, size and proposed location (including any proposed screening) of the Generator to Landlord for its review and written approval. Tenant shall be solely responsible for the cost of acquisition, installation, operation, and maintenance of the Generator; and Tenant shall install, maintain and operate the Generator in accordance with all federal, state, and local laws, statutes, ordinances, rules and regulations, including without limitation, obtaining and maintaining any and all permits, approvals and licenses required to install and operate the Generator by any governmental authority having jurisdiction. Landlord and Tenant agree that, upon the expiration of earlier termination of the Lease Term, Tenant shall not be required to remove the Generator, any associated cabling, wiring and screening or other improvements. Tenant shall not be entitled to grant or assign to any third party (other than a permitted assignee of Tenant’s rights under the Lease or a permitted subtenant relative to the Premises (or a portion thereof)) the right to use the Generator without Landlord’s prior written consent (which consent may be granted or withheld in Landlord’s discretion). Upon reasonable advance notice to Tenant (and provided Landlord reasonably coordinates with Tenant and provides an alternate source of backup generator capacity during said transition), Landlord shall be entitled to cause the Generator to be moved to another location near the Building, at Landlord’s cost and expense. Tenant shall pay all personal property taxes on the Generator. Tenant shall also pay any increases in the real property taxes of the Building due to the installation of the Generator within thirty (30) days of receipt of notice from Landlord which includes proof of such increase in taxes. Tenant’s indemnity obligations under Section 5.4.1.5 of the Lease, relating to the use of Hazardous Materials, shall apply to the use and operation of the Generator. Finally, Tenant’s insurance obligations under Section 10.3 of the Lease shall apply to the Generator.

Time is Money Join Law Insider Premium to draft better contracts faster.