Replacing Tools Sample Clauses

Replacing Tools. The Company will replace all required tools which become unserviceable provided the unserviceable tools are turned in. It is understood that any tools lost or stolen due to the negligence; or damaged due to abuse of any employee, will be replaced by the employee and not the Company. Any tool or equipment purchased as a capital expense shall be replaced at the depreciated value of the tool or equipment at the time of loss. Reimbursement may be by payroll deduction at the employee’s option. In no case shall bi-weekly payments exceed 10% of employee’s base pay except by voluntary waiver.
AutoNDA by SimpleDocs

Related to Replacing Tools

  • Maintenance of Rating Since the execution of this Agreement, there shall not have been any decrease in or withdrawal of the rating of any securities of the Company or any of its subsidiaries (including the Bank) by any “nationally recognized statistical rating organization” (as defined for purposes of Section 3(a)(62) of the 0000 Xxx) or any notice given of any intended or potential decrease in or withdrawal of any such rating or of a possible change in any such rating that does not indicate the direction of the possible change.

  • Maintenance of Equipment The Equipment shall be maintained in good operating condition and repair (reasonable wear and tear excepted) and all necessary replacements of and repairs thereto shall be made so that the value and operating efficiency of the Equipment shall be maintained and preserved. No Borrower shall use or operate the Equipment in violation of any law, statute, ordinance, code, rule or regulation. Each Borrower shall have the right to sell Equipment to the extent set forth in Section 4.3 hereof.

  • Maintenance of Listing The Company will use commercially reasonable efforts to effect and maintain the listing of (x) the Units and Warrants on the NYSE (or another national securities exchange) until the consummation of the Business Combination or until such earlier time at which the Liquidation occurs, and (y) the Common Stock on the NYSE (or another national securities exchange) until five years from the date of the consummation of the Business Combination or until such earlier time at which Liquidation occurs.

  • Margin Maintenance (a) If at any time the aggregate Market Value of all Purchased Securities subject to all Transactions in which a particular party hereto is acting as Buyer is less than the aggregate Buyer’s Margin Amount for all such Transactions (a “Margin Deficit”), then Buyer may by notice to Seller require Seller in such Transactions, at Seller’s option, to transfer to Buyer cash or additional Securities reasonably acceptable to Buyer (“Additional Purchased Securities”), so that the cash and aggregate Market Value of the Purchased Securities, including any such Additional Purchased Securities, will thereupon equal or exceed such aggregate Buyer’s Margin Amount (decreased by the amount of any Margin Deficit as of such date arising from any Transactions in which such Buyer is acting as Seller). (b) If at any time the aggregate Market Value of all Purchased Securities subject to all Transactions in which a particular party hereto is acting as Seller exceeds the aggregate Seller’s Margin Amount for all such Transactions at such time (a “Margin Excess”), then Seller may by notice to Buyer require Buyer in such Transactions, at Buyer’s option, to transfer cash or Purchased Securities to Seller, so that the aggregate Market Value of the Purchased Securities, after deduction of any such cash or any Purchased Securities so transferred, will thereupon not exceed such aggregate Seller’s Margin Amount (increased by the amount of any Margin Excess as of such date arising from any Transactions in which such Seller is acting as Buyer). (c) If any notice is given by Buyer or Seller under subparagraph (a) or (b) of this Paragraph at or before the Margin Notice Deadline on any business day, the party receiving such notice shall transfer cash or Additional Purchased Securities as provided in such subparagraph no later than the close of business in the relevant market on such day. If any such notice is given after the Margin Notice Deadline, the party receiving such notice shall transfer such cash or Securities no later than the close of business in the relevant market on the next business day following such notice. (d) Any cash transferred pursuant to this Paragraph shall be attributed to such Transactions as shall be agreed upon by Buyer and Seller. (e) Seller and Buyer may agree, with respect to any or all Transactions hereunder, that the respective rights of Buyer or Seller (or both) under subparagraphs (a) and (b) of this Paragraph may be exercised only where a Margin Deficit or Margin Excess, as the case may be, exceeds a specified dollar amount or a specified percentage of the Repurchase Prices for such Transactions (which amount or percentage shall be agreed to by Buyer and Seller prior to entering into any such Transactions). (f) Seller and Buyer may agree, with respect to any or all Transactions hereunder, that the respective rights of Buyer and Seller under subparagraphs (a) and (b) of this Paragraph to require the elimination of a Margin Deficit or a Margin Excess, as the case may be, may be exercised whenever such a Margin Deficit or Margin Excess exists with respect to any single Transaction hereunder (calculated without regard to any other Transaction outstanding under this Agreement).

  • Equipment Maintenance If this Contract involves computer or telecommunications hardware or other mechanical or electrical Equipment maintenance (use of the word "Equipment" means all the foregoing) as a Deliverable, then, during the warranty period and during any period covered by annual maintenance, the Contractor will provide Equipment maintenance to keep the Equipment in or restore the Equipment to good working order. This maintenance will include preventative and remedial maintenance, installation of safety changes, and installation of engineering changes based upon the specific needs of the individual item of Equipment. This maintenance will also include the repair, replacement, or exchange deemed necessary to keep the Equipment in good working order. For purposes of this Contract, Equipment restored to good working condition means Equipment that performs in accordance with the manufacturer's published specifications. The Contractor will exert its best efforts to perform all fault isolation and problem determination attributed to the Equipment covered under this Contract. The following services are outside the scope of this Contract: 1. Repair and replacement work or increase in maintenance time as a result of damage or loss resulting from accident, casualty, neglect, misuse, or abuse if such is the State's fault (and beyond normal wear and tear), damage resulting from improper packing or failure to follow prescribed shipping instruction (If such is done by the State), failure of electrical power, air conditioning or humidity control, use of supplies not approved by the original manufacturer of the Equipment as describe or included in the Contractor's proposal, or causes other than ordinary use of Equipment. 2. All information necessary for the State to perform the maintenance, including but not limited to logic diagrams, maintenance manuals and system and unit schematics with all changes noted. 3. A listing of spare parts and their recommended replacement schedule that will enable the State to create a centralized inventory of spare parts.

  • Supply and Maintenance of Equipment It is the responsibility of the Employer to furnish and maintain all equipment, machinery and supplies required by employees in the performance of their duties. Employees shall not suffer any loss in salary in the event that they cannot carry out their normal duties by reason of the Employer failing to properly maintain equipment, machinery or supplies or by reason of power failures or other circumstances not attributable to the employees.

  • Ordering and Provisioning 53.3.1 CenturyLink will provide necessary ordering and provisioning business process support as well as those technical and systems interfaces as may be required to enable CLEC to provide resale services, including the functions, features, and capabilities of such services, and Unbundled Network Elements. If CenturyLink deploys any enhanced electronic capability CenturyLink will notify CLEC of availability and CLEC shall use the processes for performing transaction(s) to the extent practicable and the use of any other interface or process will be discontinued. 53.3.2 The Parties agree that orders for services under this Agreement will not be submitted or accepted until thirty (30) Days after the completion of all account establishment activities, including but not limited to, the documents and information subscribed in Section 45.1, unless the Parties mutually agree upon a different date based on the specific circumstances of the Parties’ relationship. 53.3.3 Except as specifically provided otherwise in this Agreement, pre- ordering, ordering and provisioning of resold services shall be governed in accordance with CenturyLink’s Standard Practices. 53.3.4 CenturyLink will provide provisioning intervals and procedures for design and complex services on a nondiscriminatory basis. Complex Service Order charges pursuant to Tariff terms may apply. 53.3.5 Where Technically Feasible, the NEAC will coordinate support for all designed and/or complex services provided to CLEC. 53.3.6 To the extent required by Applicable Law, and upon request from CLEC, employing CenturyLink’s LSR, CenturyLink will provide blocking of 700, 900, and 976 services, or other services of similar type as may now exist or be developed in the future, and shall provide Billed Number Screening (BNS), including required LIDB updates, or equivalent service for blocking completion of bill-to-third party and collect calls, on a line, PBX, or individual service basis. Blocking shall be provided to the extent (a) it is an available option for the Telecommunications Service resold by CLEC, or (b) it is Technically Feasible when requested by CLEC as a function of Unbundled Network Elements. 53.3.7 When ordering a resale service via an LSR Service Order, CLEC may order separate interLATA and IintraLATA service providers (i.e., two PICs) on a line or trunk basis, and CLEC agrees to pay the applicable Service Order and PIC charges associated with such order. CenturyLink will accept PIC change orders for IntraLATA toll and long distance services through the service provisioning process. 53.3.8 The standard Service Order charges as listed in the Table 1 of this Agreement shall apply to all orders.

  • Maintenance of Ratings At all times, Borrower shall use commercially reasonable efforts to maintain (x) a corporate family rating issued by Xxxxx’x and a corporate credit rating issued by S&P and (y) public ratings issued by Xxxxx’x and S&P with respect to its senior secured debt.

  • MAINTENANCE & REPAIR Tenant agrees that if there is any delay in maintenance or repairs for reasons beyond Landlord's control, this shall have no effect on Tenant's obligations under this lease.

  • Modification of the Small Generating Facility The Interconnection Customer must receive written authorization from the NYISO and Connecting Transmission Owner before making any change to the Small Generating Facility that may have a material impact on the safety or reliability of the New York State Transmission System or the Distribution System. Such authorization shall not be unreasonably withheld. Modifications shall be done in accordance with Good Utility Practice. If the Interconnection Customer makes such modification without the prior written authorization of the NYISO and Connecting Transmission Owner, the Connecting Transmission Owner shall have the right to temporarily disconnect the Small Generating Facility. If disconnected, the Small Generating Facility will not be reconnected until the unauthorized modifications are authorized or removed.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!