Common use of Revised City Network Design Clause in Contracts

Revised City Network Design. (a) For each City, during Contractor's performance of RF Engineering, Site Acquisition Services and Zoning for such City, Contractor shall collect additional data and perform additional analysis (including propagation testing from candidate Sites) to revise the Preliminary City Network Design in accordance with the Design Criteria. Based upon information obtained during the performance of RF Engineering, Site Acquisition Services and Zoning, the results of additional analysis and comments received from Owner, Contractor shall revise the Preliminary City Network Design as required to meet the Design Criteria. The revised Preliminary City Network Design shall be called the Revised City Network Design. (b) The Revised City Network Design will also identify those Sites to be constructed using a tower pursuant to the Master Tower Construction and Lease Agreement. (c) In developing the Revised City Network Design for each City, Contractor shall set up test transmitters at each Primary Candidate Site identified in the Preliminary City Network Design and measure the actual RF coverage from the Site along traffic routes agreed to by the Parties. For each Site, the deliverable shall be a Site/Cluster Test Report, including a signal strength plot showing the coverage provided by that Site. The coverage so measured shall be the basis for the design of further Sites within the relevant cluster. (d) For each City, Contractor shall provide Owner with a copy of a Revised City Network Design for Owner's review and acceptance. Owner will review the Revised City Network Design as submitted by Contractor. Owner will approve the Revised City Network Design as submitted by Contractor or direct Contractor to add Sites so as to satisfy the Design Criteria, revise the Defined Coverage Area (subject to the change order process set forth in Article 11 of the Terms and Conditions), revise any Exclusion Zones and/or delete Sites and declare further Exclusion Zones. Contractor shall revise the Revised City Network Design as directed by Owner and resubmit the same to Owner for review and written approval or direction by Owner in accordance with this Section. (e) In the event a Site requires isolation testing pursuant to Isolation Specifications attached hereto as Attachment 14, Contractor shall notify Owner through the Weekly Status Report and Contractor shall perform such isolation testing. (f) The foregoing may be accomplished on a Cluster-by-Cluster basis. In the event a Cluster design does not meet the Design Criteria or exceeds cost or schedule guidelines, Contractor shall report such matters as exceptions in the Weekly Status Report.

Revised City Network Design. (a) For each City, during Contractor's performance of RF Engineering, Site Acquisition Services and Zoning for such City, Contractor shall collect additional data and perform additional analysis (including propagation testing from candidate Sites) to revise the Preliminary City Network Design in accordance with the Design Criteria. Based upon information obtained during the performance of RF Engineering, Site Acquisition Services and Zoning, the results of additional analysis and comments received from Owner, Contractor shall revise the Preliminary City Network Design as required to meet the Design Criteria. The revised Preliminary City Network Design shall be called the Revised City Network Design. (b) The Revised City Network Design will also identify those Sites to be constructed using a tower pursuant to the Master Tower Construction and Lease Agreement. (c) In developing the Revised City Network Design for each City, Contractor shall set up test transmitters at each Primary Candidate Site identified in the Preliminary City Network Design and measure the actual RF coverage from the Site along traffic routes agreed to by the Parties. For each Site, the deliverable shall be a Site/Cluster Test Report, including a signal strength plot showing the coverage provided by that Site. The coverage so measured shall be the basis for the design of further Sites within the relevant cluster. (d) For each City, Contractor shall provide Owner with a copy of a Revised City Network Design for Owner's review and acceptance. Owner will review the Revised City Network Design as submitted by Contractor. Owner will approve the Revised City Network Design as submitted by Contractor or direct Contractor to add Sites so as to satisfy the Design Criteria, revise the Defined Coverage Area (subject to the change order process set forth in Article 11 of the Terms and Conditions), revise any Exclusion Zones and/or delete Sites and declare further Exclusion Zones. Contractor shall revise the Revised City Network Design as directed by Owner and Ownex xxx resubmit the same to Owner for review and written approval or direction by Owner in accordance with this Section. (e) In the event a Site requires isolation testing pursuant to Isolation Specifications attached hereto as Attachment 14, Contractor shall notify Owner through the Weekly Status Report and Contractor shall perform such isolation testing. (f) The foregoing may be accomplished on a Cluster-by-Cluster basis. In the event a Cluster design does not meet the Design Criteria or exceeds cost or schedule guidelines, Contractor shall report such matters as exceptions in the Weekly Status Report.