Loss Leader; Recycled Products Contractor shall not sell or use any article or product as a “loss leader” as defined in Section 17030 of the Business and Professions Code. If Contractor will sell to the Judicial Council, or use in the performance of this Agreement, goods specified in PCC 12207 (for example, certain paper products, office supplies, mulch, glass products, lubricating oils, plastic products, paint, antifreeze, tires and tire-derived products, and metal products), then with respect to those goods: (i) Contractor shall use recycled products in the performance of this Agreement to the maximum extent doing so is economically feasible, and (ii) upon request, Contractor shall certify in writing under penalty of perjury, the minimum, if not exact, percentage of post consumer material as defined in the PCC 12200, in such goods regardless of whether the goods meet the requirements of PCC 12209.
Bidder Supplied Samples The Commissioner reserves the right to request from the Bidder/Contractor a representative sample(s) of the Product offered at any time prior to or after award of a contract. Unless otherwise instructed, samples shall be furnished within the time specified in the request. Untimely submission of a sample may constitute grounds for rejection of Bid or cancellation of the Contract. Samples must be submitted free of charge and be accompanied by the Bidder’s name and address, any descriptive literature relating to the Product and a statement indicating how and where the sample is to be returned. Where applicable, samples must be properly labeled with the appropriate Bid or Contract reference. A sample may be held by the Commissioner during the entire term of the Contract and for a reasonable period thereafter for comparison with deliveries. At the conclusion of the holding period the sample, where feasible, will be returned as instructed by the Bidder, at the Bidder’s expense and risk. Where the Bidder has failed to fully instruct the Commissioner as to the return of the sample (i.e., mode and place of return, etc.) or refuses to bear the cost of its return, the sample shall become the sole property of the receiving entity at the conclusion of the holding period.
REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.
Course Curriculum, Instruction, and Grading X. Xxxx College courses offered as dual credit, regardless of where they are taught, follow the same syllabus, course outline, textbook, grading method, and other academic policies as the courses outlined in the Hill College catalog.
B. Approved courses being taught for dual credit must follow the approved master syllabus of the discipline and of Hill College.
C. Textbooks should be identical to those approved for use by Hill College. Should an instructor propose an alternative textbook, the textbook must be approved in advance by the appropriate instructional department of Hill College and the Vice President of Instruction. Other instructional materials for dual credit/concurrent courses must be identical or at an equivalent level to materials used by Hill College.
D. Courses which result in college‐level credit will follow the standard grading practices of Hill College, as identified by college policy and as identified in the appropriately approved course syllabus. The grades used in college records are A (excellent), B (above average), C (average), D (below average), F (failure), I (incomplete), W (withdrawn), WC (withdrawn COVID). The lowest passing grade is D. Grade point averages are computed by assigning values to each grade as follows: A = 4 points, B = 3 points, C = 2 points, D = 1 point, and F = 0 points. Grading criteria may be devised by Hill College and the ISD to allow faculty the opportunity to award high school credit only or high school and college credit depending upon student performance.
E. Faculty, who are responsible for teaching dual credit/concurrent classes, are responsible for keeping appropriate records, certifying census date rosters, providing interim grade reports, certifying final grade reports at the end of the semester, certifying attendance, and providing other reports and information as may be required by Hill College and/or the School District.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.
a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract.
b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.
Equipment Cleaning (a) Areas, known by Forest Service prior to timber sale advertisement, that are infested with invasive species of concern are shown on Sale Area Map. A current list of invasive species of concern and a map showing the extent of known infestations is available at the Forest Supervisor’s Office. For purposes of this provision, “Off-Road Equipment” includes all logging and construction machinery, except for log trucks, chip vans, service vehicles, water trucks, pickup trucks, cars, and similar vehicles.
Equipment Procurement If responsibility for construction of the Connecting Transmission Owner’s Attachment Facilities or System Upgrade Facilities or System Deliverability Upgrades is to be borne by the Connecting Transmission Owner, then the Connecting Transmission Owner shall commence design of the Connecting Transmission Owner’s Attachment Facilities or System Upgrade Facilities or System Deliverability Upgrades and procure necessary equipment as soon as practicable after all of the following conditions are satisfied, unless the Developer and Connecting Transmission Owner otherwise agree in writing:
5.5.1 NYISO and Connecting Transmission Owner have completed the Interconnection Facilities Study pursuant to the Interconnection Facilities Study Agreement;
5.5.2 The NYISO has completed the required cost allocation analyses, and Developer has accepted his share of the costs for necessary System Upgrade Facilities and System Deliverability Upgrades in accordance with the provisions of Attachment S of the NYISO OATT;
5.5.3 The Connecting Transmission Owner has received written authorization to proceed with design and procurement from the Developer by the date specified in Appendix B hereto; and
5.5.4 The Developer has provided security to the Connecting Transmission Owner in accordance with Article 11.5 by the dates specified in Appendix B hereto.
Durable Medical Equipment (DME), Medical Supplies, Prosthetic Devices, Enteral Formula or Food, and Hair Prosthesis (Wigs) This plan covers durable medical equipment and supplies, prosthetic devices and enteral formula or food as described in this section. DME is equipment which: • can withstand repeated use; • is primarily and customarily used to serve a medical purpose; • is not useful to a person in the absence of an illness or injury; and • is for use in the home. DME includes supplies necessary for the effective use of the equipment. This plan covers the following DME: • wheelchairs, hospital beds, and other DME items used only for medical treatment; and • replacement of purchased equipment which is needed due to a change in your medical condition or if the device is not functional, no longer under warranty, or cannot be repaired. DME may be classified as a rental item or a purchased item. In most cases, this plan only pays for a rental DME up to our allowance for a purchased DME. Repairs and supplies for rental DME are included in the rental allowance. Medical supplies are consumable supplies that are disposable and not intended for re- use. Medical supplies require an order by a physician and must be essential for the care or treatment of an illness, injury, or congenital defect. Covered medical supplies include: • essential accessories such as hoses, tubes and mouthpieces for use with medically necessary DME (these accessories are included as part of the rental allowance for rented DME); • catheters, colostomy and ileostomy supplies, irrigation trays and surgical dressings; and • respiratory therapy equipment. This plan covers diabetic equipment and supplies for the treatment of diabetes in accordance with R.I. General Law §27-20-30. Covered diabetic equipment and supplies include: • therapeutic or molded shoes and inserts for custom-molded shoes for the prevention of amputation; • blood glucose monitors including those with special features for the legally blind, external insulin infusion pumps and accessories, insulin infusion devices and injection aids; and • lancets and test strips for glucose monitors including those with special features for the legally blind, and infusion sets for external insulin pumps. The amount you pay differs based on whether the equipment and supplies are bought from a durable medical equipment provider or from a pharmacy. See the Summary of Pharmacy Benefits and the Summary of Medical Benefits for details. Coverage for some diabetic equipment and supplies may only be available from either a DME provider or from a pharmacy. Visit our website to determine if this is applicable or call our Customer Service Department. Prosthetic devices replace or substitute all or part of an internal body part, including contiguous tissue, or replace all or part of the function of a permanently inoperative or malfunctioning body part and alleviate functional loss or impairment due to an illness, injury or congenital defect. Prosthetic devices do not include dental prosthetics. This plan covers the following prosthetic devices as required under R.I. General Law § 27-20-52: • prosthetic appliances such as artificial limbs, breasts, larynxes and eyes; • replacement or adjustment of prosthetic appliances if there is a change in your medical condition or if the device is not functional, no longer under warranty and cannot be repaired; • devices, accessories, batteries and supplies necessary for prosthetic devices; • orthopedic braces except corrective shoes and orthotic devices used in connection with footwear; and • breast prosthesis following a mastectomy, in accordance with the Women’s Health and Cancer Rights Act of 1998 and R.I. General Law 27-20-29. The prosthetic device must be ordered or provided by a physician, or by a provider under the direction of a physician. When you are prescribed a prosthetic device as an inpatient and it is billed by a provider other than the hospital where you are an inpatient, the outpatient benefit limit will apply. Enteral formula or food is nutrition that is absorbed through the intestinal tract, whether delivered through a feeding tube or taken orally. Enteral nutrition is covered when it is the sole source of nutrition and prescribed by the physician for home use. In accordance with R.I. General Law §27-20-56, this plan covers enteral formula taken orally for the treatment of: • malabsorption caused by Crohn’s Disease; • ulcerative colitis; • gastroesophageal reflux; • chronic intestinal pseudo obstruction; and • inherited diseases of amino acids and organic acids. Food products modified to be low protein are covered for the treatment of inherited diseases of amino acids and organic acids. Preauthorization may be required. The amount that you pay may differ depending on whether the nutrition is delivered through a feeding tube or taken orally. When enteral formula is delivered through a feeding tube, associated supplies are also covered. This plan covers hair prosthetics (wigs) worn for hair loss suffered as a result of cancer treatment in accordance with R.I. General Law § 27-20-54 and subject to the benefit limit and copayment listed in the Summary of Medical Benefits. This plan will reimburse the lesser of the provider’s charge or the benefit limit shown in the Summary of Medical Benefits. If the provider’s charge is more than the benefit limit, you are responsible for paying any difference. This plan covers Early Intervention Services in accordance with R.I. General Law §27- 20-50. Early Intervention Services are educational, developmental, health, and social services provided to children from birth to thirty-six (36) months. The child must be certified by the Rhode Island Department of Human Services (DHS) to enroll in an approved Early Intervention Services program. Services must be provided by a licensed Early Intervention provider and rendered to a Rhode Island resident. Members not living in Rhode Island may seek services from the state in which they reside; however, those services are not covered under this plan. Early Intervention Services as defined by DHS include but are not limited to the following: • speech and language therapy; • physical and occupational therapy; • evaluation; • case management; • nutrition; • service plan development and review; • nursing services; and • assistive technology services and devices.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning):
1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises.
2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated.
3. If capacity exists, provide "side-door" porting through the switch.
4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch).
2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases.
2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.
