Standard, Airline Operation - Normal Wear and Tear Sample Clauses

Standard, Airline Operation - Normal Wear and Tear. The Buyer’s rights under this Clause 12.1 are subject to the Aircraft and each component, equipment, accessory and part thereof being maintained, overhauled, repaired and operated in accordance with standard commercial airline practice, all technical documentation and any other instructions issued by the Seller, the Suppliers or the manufacturer of the Propulsion Systems and all applicable rules, regulations and directives of the relevant Aviation Authorities. The Seller’s liability under this Clause 12.1 will not extend to normal wear and tear or to Spirit Airlines - A320 FAMILY – PA 40 (i) any Aircraft or component, equipment, accessory or part thereof that has been repaired, altered or modified after Delivery in a manner other than that approved by the Seller; (ii) any Aircraft or component, equipment, accessory or part thereof that has been operated in what the Buyer knew, or in the exercise of due care, should have known, was in a damaged state; or (iii) any component, equipment, accessory or part from which all identifying marks such as the trademark, trade name, part or serial number have been removed, such that the origin of the relevant part cannot reasonably be determined, except that if, in each case (other than in respect of (iii) above) the Buyer submits evidence reasonably acceptable to the Seller that the defect for which warranty coverage is sought did not arise as a result of, or was not materially worsened by, such causes.
Sample 1Sample 2
AutoNDA by SimpleDocs
Standard, Airline Operation - Normal Wear and Tear. The Buyers' rights under this Clause 12.1 are subject to the Aircraft and each component, equipment, accessory and part thereof being maintained, overhauled, repaired and operated in accordance with FAA regulations and the Buyers' FAA-approved maintenance program and operating procedures. The Seller's liability under this Clause 12.1 will not extend to normal wear and tear nor, to the extent caused by any of the following, to:
Sample 1Sample 2
Standard, Airline Operation - Normal Wear and Tear. The Buyer’s rights under this Clause 12.1 are subject to the Aircraft and each component, equipment, accessory and part thereof being maintained, overhauled, repaired and operated in accordance with FAA regulations ** The Seller’s liability under this Clause 12.1 will not extend to normal wear and tear nor, to the extent caused by any of the following: (i) any Aircraft or component, equipment, accessory or part thereof that has been repaired, altered or modified after Delivery in a manner inconsistent with the requirements of the applicable Aviation Authority or the aircraft repair manuals, as applicable; (ii) any component, equipment or accessory or part thereof that has been operated in a damaged state ** (iii) any component, equipment, accessory or part from which the trademark, trade name, part or serial number or other identification marks have been removed. The limitations of the Seller’s liability under this Clause 12.1.11 resulting from causes described in Clauses 12.1.11(i) and 12.1.11(ii) will apply only to the extent the Seller submits reasonable evidence that the defect arose from or was contributed to by such causes.
Sample 1

Related to Standard, Airline Operation - Normal Wear and Tear

  • PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS If any portion of work being Bid is subject to the prevailing wage rate provisions of the Labor Law, the following shall apply:

  • Quality Management Grantee will: 1. comply with quality management requirements as directed by the System Agency. 2. develop and implement a Quality Management Plan (QMP) that conforms with 25 TAC § 448.504 and make the QMP available to System Agency upon request. The QMP must be developed no later than the end of the first quarter of the Contract term. 3. update and revise the QMP each biennium or sooner, if necessary. Xxxxxxx’s governing body will review and approve the initial QMP, within the first quarter of the Contract term, and each updated and revised QMP thereafter. The QMP must describe Xxxxxxx’s methods to measure, assess, and improve - i. Implementation of evidence-based practices, programs and research-based approaches to service delivery; ii. Client/participant satisfaction with the services provided by Xxxxxxx; iii. Service capacity and access to services; iv. Client/participant continuum of care; and v. Accuracy of data reported to the state. 4. participate in continuous quality improvement (CQI) activities as defined and scheduled by the state including, but not limited to data verification, performing self-reviews; submitting self-review results and supporting documentation for the state’s desk reviews; and participating in the state’s onsite or desk reviews. 5. submit plan of improvement or corrective action plan and supporting documentation as requested by System Agency. 6. participate in and actively pursue CQI activities that support performance and outcomes improvement. 7. respond to consultation recommendations by System Agency, which may include, but are not limited to the following: i. Staff training; ii. Self-monitoring activities guided by System Agency, including use of quality management tools to self-identify compliance issues; and iii. Monitoring of performance reports in the System Agency electronic clinical management system.

  • Emergency Mode Operation Plan Contractor must establish a documented plan to enable continuation of critical business processes and protection of the security of electronic County PHI or PI in the event of an emergency. Emergency means any circumstance or situation that causes normal computer operations to become unavailable for use in performing the work required under this Agreement for more than twenty-four (24) hours.

  • Construction Phase Services 3.1.1 – Basic Construction Services

  • Configuration Management The Contractor shall maintain a configuration management program, which shall provide for the administrative and functional systems necessary for configuration identification, control, status accounting and reporting, to ensure configuration identity with the UCEU and associated cables produced by the Contractor. The Contractor shall maintain a Contractor approved Configuration Management Plan that complies with ANSI/EIA-649 2011. Notwithstanding ANSI/EIA-649 2011, the Contractor’s configuration management program shall comply with the VLS Configuration Management Plans, TL130-AD-PLN-010-VLS, and shall comply with the following:

  • Enterprise Information Management Standards Grantee shall conform to HHS standards for data management as described by the policies of the HHS Office of Data, Analytics, and Performance. These include, but are not limited to, standards for documentation and communication of data models, metadata, and other data definition methods that are required by HHS for ongoing data governance, strategic portfolio analysis, interoperability planning, and valuation of HHS System data assets.

  • Commercial Operation Date Testing and Modifications Prior to the Commercial Operation Date, the Connecting Transmission Owner shall test the Connecting Transmission Owner’s Attachment Facilities and System Upgrade Facilities and System Deliverability Upgrades and Developer shall test the Large Generating Facility and the Developer Attachment Facilities to ensure their safe and reliable operation. Similar testing may be required after initial operation. Developer and Connecting Transmission Owner shall each make any modifications to its facilities that are found to be necessary as a result of such testing. Developer shall bear the cost of all such testing and modifications. Developer shall generate test energy at the Large Generating Facility only if it has arranged for the injection of such test energy in accordance with NYISO procedures.

  • Switching System Hierarchy and Trunking Requirements For purposes of routing ECI traffic to Verizon, the subtending arrangements between Verizon Tandem Switches and Verizon End Office Switches shall be the same as the Tandem/End Office subtending arrangements Verizon maintains for the routing of its own or other carriers’ traffic (i.e., traffic will be routed to the appropriate Verizon Tandem subtended by the terminating End Office serving the Verizon Customer). For purposes of routing Verizon traffic to ECI, the subtending arrangements between ECI Tandem Switches and ECI End Office Switches shall be the same as the Tandem/End Office subtending arrangements that ECI maintains for the routing of its own or other carriers’ traffic.

  • Maintenance and Operation Member-Generator agrees to maintain their system and facilities in accordance with applicable manufacturer's recommended maintenance schedule and standard prudent engineering practices. Member-Generator covenants and agrees to operate their system, facilities and equipment so as to minimize the likelihood for a malfunction or other disturbance, damaging or otherwise affecting or impairing Cooperative’s electrical system. Member-Generator shall comply with all applicable laws, regulations, zoning, building codes, safety rules and other environmental regulations or restrictions applicable to the design, installation, operation and maintenance of the Member-Generator's System.

  • Use and Operation 3.1 Permitted Use ......................................................................................................

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!