Steel Light and Signal Standards Sample Clauses

Steel Light and Signal Standards. 38 In the second paragraph, “AASHTO M232” is revised to read “ASTM F 2329”. 39 40 The first sentence of the last paragraph is revised to read: 41 42 Steel used for light and signal standards shall have a controlled silicon content of either 43 0.00 to 0.06 percent or 0.15 to 0.25 percent. 44 45 9-29.6(5) Foundation Hardware 46 In the last paragraph, “AASHTO M232” is revised to read “ASTM F 2329”. 47
AutoNDA by SimpleDocs

Related to Steel Light and Signal Standards

  • International Standards 1. Each Party shall use relevant international standards, to the extent provided in Article 2.4 of the TBT Agreement, as a basis for its technical regulations.

  • Operational Standards Customer shall furnish, install, operate and maintain in good order and repair, all without cost to the City, all equipment required for the safe operation of the Facility in parallel with the City’s electric distribution system. This includes, but is not limited to, equipment necessary to:

  • Technical Standards The Generation System shall be installed and operated by the Interconnection Customer consistent with the requirements of this Agreement; the Technical Requirements; the applicable requirements located in the National Electrical Code (NEC); the applicable standards published by the American National Standards Institute (ANSI) and the Institute of Electrical and Electronic Engineers (IEEE); and local building and other applicable ordinances in effect at the time of the installation of the Generation System.

  • General Standards An Assistant Professor will be competent to teach in a particular field, will be current in the literature of that field, and will seek to meet student needs in both the classroom and in non-classroom environments. However, an Assistant may be a junior member of the academic community, with little professional and/or teaching experience. Furthermore, an Assistant may have little experience in curriculum development, committee work, governance, professional and/or community service, etc. In short, an Assistant Professor generally will be new to tenure-track college teaching. For eligibility for promotion from Assistant to Associate Professor, the candidate must have served a minimum of four (4) years at the rank of Assistant Professor, and must show evidence that he/she has grown professionally and consistently has sought to meet student needs, in both the classroom and in non-classroom environments. A successful candidate for the rank of Associate Professor will have remained current in the field, and will have improved his/her teaching in some demonstrable way. He/she also will have demonstrated professional growth in one or more of the following ways: completion of additional appropriate course work (if applicable), attendance at professional conferences, service on campus and/or District committees, professional and/or community service, or, the production of some creative work. Evidence of professional growth will be drawn from a careful analysis of student evaluations and peer evaluations over a period of time, and from a critical reading of materials submitted by the candidate. For promotion from Associate to Professor, the candidate must have served a minimum of four (4) years at the rank of Associate Professor, and must show evidence that he/she has grown professionally to a point where he/she has mastered both a particular field of knowledge and the teaching of that knowledge. A successful candidate must show evidence that he/she consistently has sought to meet student needs, in both the classroom and non-classroom environments. A Professor should be a senior member of the faculty, one who has such substantial experience, knowledge, and skill that he/she could mentor junior faculty in his/her area of expertise. A Professor will have demonstrated all the same kinds of achievements and attributes necessary for promotion to the Associate Professor rank, but in addition will demonstrate that he/she is a leader in some appropriate sense. Evidence of professional growth and leadership will be drawn from a careful analysis of student evaluations and peer evaluations over a period of time, and from a critical reading of materials submitted by the candidate.

  • NATIONAL STANDARDS This Agreement will not operate so as to cause any employee to suffer a reduction in ordinary time earnings or in national standards, such as national standard hours of work (38), annual leave or long service leave or any other standard which has been established by the Australian Industrial Relations Commission (AIRC).

  • Applicable Technical Standards The Applicable Technical Requirements and Standards that apply to the Customer Facility and the Interconnection Facilities are identified in Schedule D to this ISA.

  • Professional Standards The Contractor agrees to maintain the professional standards applicable to its profession and to Contractors doing business in the United States Virgin Islands.

  • Environmental Standards If the contract amount set forth in this Contract is in excess of $100,000, the Contractor shall comply with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. § 7606), section 508 of the Clean Water Act (33 U.S.C. § 1368), Executive Order 11738, and Environmental Protection Agency regulations (2 C.F.R. Part 1532), which prohibit the use under non-exempt Federal contracts of facilities included on the EPA List of Violating Facilities. The Contractor shall report any violations of this paragraph to the State of Indiana and to the United States Environmental Protection Agency Assistant Administrator for Enforcement.

  • OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.

  • Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!