Submitting and indexing job Sample Clauses

Submitting and indexing job. In order to enable searching, after successful DIP creation, the package has to be indexed. This can be accomplished by starting an indexing job for a specific package. The indexing job is started by issuing a POST call to the “/earkweb/earkcore/index_local_storage_ip” endpoint with the DIP identifier provided in a JSON message. Upon execution existing index information with the same identifier is removed. The response message after sending the indexing request only means that the job was successfully submitted. Querying for the job status can be done by using the same job status function as for the DIP creation functionality. curl -X POST -d '{"identifier": "urn:uuid:08e41ebb-bfa1-452c-ad05-7e4cd6809d82"}'40 xxxx://xxxxxxxxx:0000/xxxxxxx/xxxxxxxx/xxxxx_xxxxx_xxxxxxx_xx One of the following response messages is returned: ● 200 : OK - Job status request successful ● 400: Bad Request - Wrong request type ● 500: Internal Server Error - Some error occurred (see message) 40 This is the IP identifier. Response Body (success)
AutoNDA by SimpleDocs

Related to Submitting and indexing job

  • TESTING AND COMMISSIONING 24 Allow for a Lump Sum for testing and commissioning of the entire electrical installation, including the provision of Compliance Certificate. Item Carried to Collection R Section No. 4 Electrical Installation (Provisional) Bill No. 1 Electrical Installation COLLECTION Total Brought Forward from Page No. Carried to Final Summary 76 77 R Amount FINAL SUMMARY Section No Page No 1 Preliminaries 26 2 Alterations (Provisional) 30 3 External Works (Provisional) 73

  • Terminating Switched Access Detail Usage Data A category 1101XX record as defined in the EMI Telcordia Practice BR-010-200- 010.

  • Termination for Market Change (a) In the event of delay or interruption under B8.33, exceeding 90 days, and Contract has not been modified to include replacement timber, this contract may be terminated upon election and written notice by Purchaser, if (i) a rate redetermination for market change under B3.33 shows that the appraised weighted average Indicated Advertised Rate of all Included Timber remaining immediately prior to the delay or interruption has been reduced through a market change by an amount equal to or more than the the weighted average Current Contract Rate, or (ii) the appraised value of the remaining timber is insufficient to cover the adjusted base rates as determined under B3.33.

  • Log and Load Reporting Service This contract may at the States discretion, require the services of a State approved third party log and load reporting service. Purchaser shall ensure log volume measurement, weight, or scale and weight data for each load is received by the log and load reporting service within 1 business day of logs being measured or weighed. If during the term of this contract, the State discontinues use of the Log and Load Reporting Service, the State will notify the Purchaser in writing, and will approve an alternative log and load reporting process. L-080 Scaling Rules Determination of volume and grade of any forest products shall be conducted by a state approved third party scaling organization and in accordance with the Westside log scaling and grading rules and Xxxxxxxx Volume Table, revised July 1, 1972, contained in the Northwest Log Rules Eastside and Westside Log Scaling Handbook (developed and produced by the Northwest Log Rules Advisory Group) and in effect on the date of confirmation of this contract. Special scaling specifications shall be noted on the State’s Brand Designation form which is hereby incorporated to this contract by reference. X-000 Xxxxx Xxxxxxxx of Log Scaling and Weighing Locations Forest Product measurement and weighing facilities required by this contract must be approved by the State. Forest products sold under the contract which require log scaling shall be scaled, measured, or counted by a State approved third party log scaling organization. Forest products sold under the contract which require weighing shall be weighed at a location that meets Washington State Department of Agriculture approval. Prior to forest products being hauled, the Contract Administrator must authorize in writing the use of State approved measurement and/or weighing facilities that are at or en-route to final destinations. Forest products from this sale shall be measured or weighed at facilities, which are currently approved for use by the State and are currently authorized for this sale. The State reserves the right to verify load volume and weights with State employees or contractors at the State's own expense. The State reserves the right to revoke the authorization of previously approved measurement locations.

  • Presentation for Scaling Purchaser shall present products so that they may be Scaled in an eco- nomical and safe manner. If prior to Scaling, Included Timber is to be mixed with other timber, Purchaser shall, prior to mixing, provide for distinguishing, by means ap- proved by Forest Service, each product included in this contract. Trees or pieces presented for Scaling that have not been bucked to separate material meeting minimum piece standards from material not meeting minimum piece standards due to diameter, shall be Scaled as though such bucking had been done. Deductions made for rot, check, or other defects re- sulting from abnormal delay in Scaling caused by Pur- chaser shall be recorded separately and charged to Xxx- ber Sale Account under B3.47. Any timber that has been removed from Sale Area during the period of this contract, but remains unscaled after Termination Date, shall be Scaled at the earliest rea- sonable date.

  • Certification for Federal-Aid Contracts Lobbying Activities A. The CONSULTANT certifies, by signing and submitting this Contract, to the best of its knowledge and belief after diligent inquiry, and other than as disclosed in writing to the LPA prior to or contemporaneously with the execution and delivery of this Contract by the CONSULTANT, the CONSULTANT has complied with Section 1352, Title 31, U.S. Code, and specifically, that:

  • REPORTING AND CALL BACK TIME 11.1 Reporting time pay is contained in the Appendices attached to and forming part of this Agreement.

  • Using Student feedback in Educator Evaluation ESE will provide model contract language, direction and guidance on using student feedback in Educator Evaluation by June 30, 2013. Upon receiving this model contract language, direction and guidance, the parties agree to bargain with respect to this matter.

  • Petition for Annual Conference Session The Local Church acknowledges that pursuant to the governing standing rules of the Annual Conference, petitions for consideration of the legislative body must be submitted to the Secretary of the Annual Conference on or before April 1 of the current Annual Conference year. The Annual Conference will make reasonable efforts to assist the Local Church in completing the required petition, which will include this Disaffiliation Agreement as an attachment thereto making it subject to public review. If the petition is not filed in a timely manner, the Parties will make good faith efforts under the standing rules of the Annual Conference to cooperate to bring the petition to the legislative floor for consideration by appropriate motions to suspend the standing rules for the purposes of considering the petition.

  • Evaluation Cycle: Annual Orientation A) At the start of each school year, the superintendent, principal or designee shall conduct a meeting for Educators and Evaluators focused substantially on educator evaluation. The superintendent, principal or designee shall:

Time is Money Join Law Insider Premium to draft better contracts faster.