Primary Coverage Contractor’s insurance shall apply as primary and shall not seek contribution from any insurance or self-insurance maintained by, or provided to, the additional insureds listed above including, at a minimum, the State of Washington and/or any Purchaser. All insurance or self-insurance of the State of Washington and/or Purchasers shall be excess of any insurance provided by Contractor or subcontractors.
Family Coverage The employee’s cost for family coverage will be nineteen and one-half percent (19.5%) of the family rate for the employee’s Base Medical Plan. If the employee chooses a plan other than the Base Medical Plan, the employee’s cost will be the standard employee’s family rate established for that plan (i.e. the rate applicable where it has not been modified to be a zone’s Base Medical Plan). The employer shall pay the rate over and above the employee’s cost for the Base Medical Plan.
Optional Life and Disability Coverages In order for coverage to become effective, the employee must be in active payroll status and not using sick leave on the first day following approval by the insurance company. If it is an open enrollment period, coverage may be applied for but will not become effective until the first day of the employee's return to work.
Coinsurance After the deductible is satisfied, seventy percent (70%) coverage up to the plan out-of-pocket maximum designated below.
Application of Excess Liability Coverage Contractors may use a combination of primary, and excess insurance policies which provide coverage as broad as (“follow form” over) the underlying primary policies, to satisfy the Required Insurance provisions.
Disability Coverage In the event a State employee goes on an extended medical disability, or is receiving Workers’ Compensation benefits, the Employer-policyholder shall continue at no cost to the employee the coverage of the group life insurance for such employee for the period of such extended leave, but not beyond two (2) years.
Liquidity Coverage Ratio The Seller shall not issue any LCR Security.
Automobile Liability Coverage Consultant shall maintain automobile liability insurance covering bodily injury and property damage for all activities of the Consultant arising out of or in connection with the work to be performed under this Agreement, including coverage for owned, hired and non- owned vehicles, in an amount of not less than one million dollars ($1,000,000) combined single limit for each occurrence.
General Liability Coverage The CONTRACTOR shall maintain commercial general liability insurance in an amount of not less than one million dollars ($1,000,000) per occurrence for bodily injury, personal injury, and property damage. If a commercial general liability insurance form or other form with a general aggregate limit is used, either the general aggregate limit shall apply separately to the work to be performed under this Agreement or the general aggregate limit shall be at least twice the required occurrence limit.
Liability Coverage For the benefit of System Agency, Grantee will at all times maintain liability insurance coverage, referred to in Tex. Gov. Code § 2261.102, as “director and officer liability coverage” or similar coverage for all persons in management or governing positions within Grantee’s organization or with management or governing authority over Grantee’s organization (collectively “responsible persons”). Grantee will:
1. maintain copies of liability policies on site for inspection by System Agency and will submit copies of policies to System Agency upon request.
2. maintain liability insurance coverage in an amount not less than the total value of this Contract and that is sufficient to protect the interests of System Agency in the event an actionable act or omission by a responsible person damages System Agency’s interests.
3. notify, and obtain prior approval from, the System Agency Contract Oversight and Support Section before settling a claim on the insurance.
