Sweep and damp mop floors Sample Clauses

Sweep and damp mop floors difficult to reach areas. Contractor shall thoroughly sweep and damp mop floors, including areas that daily sweeping and damp mopping does not reach, including wall edges, around furniture and cabinets, and under desks and all moveable office furniture.
AutoNDA by SimpleDocs
Sweep and damp mop floors. The floors should be swept so they are free of visible litter, dust, debris, then damp mop accessible areas. After mopping, floors should have a uniform appearance and be free of streaks, debris, or standing water, as well as free of stains and scuffs.

Related to Sweep and damp mop floors

  • Sanitary Facilities - Construction 5.1 Closets shall be soundly constructed and roofed with weatherproof material. The floor of each closet shall be well drained and constructed of concrete, bricks and cement, or of other approved materials which shall be impervious to water. Every closet shall be well lighted by natural or artificial light and shall be ventilated. Each closet shall have a hinged door, capable of being fastened on the inside, lift seats/flaps and toilet paper. If closets are of single unit construction (only to be used for the formwork process), not contained within a purpose built ablution block, privacy walls which shield the closet/s from outside view shall be installed. (Privacy walls are not required for purpose built ablution blocks eg ATCO huts)

  • DS3 Loop DS3 Loop is a two-point digital transmission path which provides for simultaneous two-way transmission of serial, bipolar, return-to-zero isochronous digital electrical signals at a transmission rate of 44.736 megabits per second (Mbps) that is dedicated to the use of the ordering CLEC in its provisioning of local exchange and associated exchange access services. It may provide transport for twenty-eight (28) DS1 channels, each of which provides the digital equivalent of twenty-four (24) analog voice grade channels. The interface to unbundled dedicated DS3 transport is a metallic-based electrical interface.

  • Elsevier Open Access Terms and Conditions You can publish open access with Elsevier in hundreds of open access journals or in nearly 2000 established subscription journals that support open access publishing. Permitted third party re-use of these open access articles is defined by the author's choice of Creative Commons user license. See our open access license policy for more information. Terms & Conditions applicable to all Open Access articles published with Elsevier: Any reuse of the article must not represent the author as endorsing the adaptation of the article nor should the article be modified in such a way as to damage the author's honour or reputation. If any changes have been made, such changes must be clearly indicated. The author(s) must be appropriately credited and we ask that you include the end user license and a DOI link to the formal publication on ScienceDirect. If any part of the material to be used (for example, figures) has appeared in our publication with credit or acknowledgement to another source it is the responsibility of the user to ensure their reuse complies with the terms and conditions determined by the rights holder. Additional Terms & Conditions applicable to each Creative Commons user license:

  • Gold Open Access Articles May be shared according to the author-selected end-user license and should contain a CrossMark logo, the end user license, and a DOI link to the formal publication on ScienceDirect. Please refer to Elsevier's posting policy for further information.

  • Provisioning of Line Sharing and Splitter Space 3.2.1 BellSouth will provide ONS with access to the High Frequency Spectrum as follows:

  • Additional Wet Weather Procedure 14.15.1 Remaining On Site Where, because of wet weather, the employees are prevented from working:

  • WILEY OPEN ACCESS TERMS AND CONDITIONS Wiley Publishes Open Access Articles in fully Open Access Journals and in Subscription journals offering Online Open. Although most of the fully Open Access journals publish open access articles under the terms of the Creative Commons Attribution (CC BY) License only, the subscription journals and a few of the Open Access Journals offer a choice of Creative Commons Licenses. The license type is clearly identified on the article.

  • Provisioning Line Splitting and Splitter Space 3.8.1 The Data LEC, Voice CLEC or BellSouth may provide the splitter. When EZ Phone or its authorized agent owns the splitter, Line Splitting requires the following: a non-designed analog Loop from the serving wire center to the NID at the End User’s location; a collocation cross connection connecting the Loop to the collocation space; a second collocation cross connection from the collocation space connected to a voice port; the high frequency spectrum line activation, and a splitter. The Loop and port cannot be a Loop and port combination (i.e. UNE-P), but must be individual stand-alone Network Elements. When BellSouth owns the splitter, Line Splitting requires the following: a non designed analog Loop from the serving wire center to the NID at the End User’s location with CFA and splitter port assignments, and a collocation cross connection from the collocation space connected to a voice port.

  • Completion of Concrete Pours and Emergency Work 24.14.1 Except as provided in this sub-clause an employee shall not work or be required to work in the rain.

  • DISTRIBUTION AND DEFAULT SERVICE TERMS AND CONDITIONS Capacity Pipeline Capacity, Underground Storage Withdrawal Capacity, Underground Storage Capacity and Peaking Capacity as defined in these Terms and Conditions. Capacity Allocators The proportion of the Customer’s Total Capacity Quantity that comprises Pipeline Capacity, Underground Storage Withdrawal Capacity and Peaking Capacity. City Gate The interconnection between a Delivering Pipeline and the Company’s distribution facilities. Company Eversource Gas Company of Massachusetts d/b/a Eversource Energy Company Gas Allowance The difference between the sum of all amounts of Gas received into the Company’s distribution system and the sum of all amounts of Gas delivered from the Company’s distribution system as calculated by the Company for the most recent twelve (12) month period ending July 31. Such difference shall include, but not be limited to, Gas consumed by the Company for its own purposes, line losses and Gas vented and lost as a result of an event of Force Majeure, excluding gas otherwise accounted for. Company-Managed Supplies Capacity contracts held and managed by the Company in accordance with governing tariffs, but made available to the Supplier pursuant to Section 13.9 of these Terms and Conditions, including supply-sharing contracts and load- management contracts. Consumption Algorithm A mathematical formula used to estimate a Customer’s daily consumption. Critical Day In accordance with Section 19.0 of these Terms and Conditions, a Day declared at any time by the Company in its reasonable discretion when unusual operating conditions may jeopardize operation of the Company’s distribution system.

Time is Money Join Law Insider Premium to draft better contracts faster.