The flammability of Child Restraint Sample Clauses

The flammability of Child Restraint. Systems submitted for approval shall be assessed by one of the following methods : Deleted: CRS‐60‐01e.docx2¶ Formatted: English (U.K.) Formatted: English (U.K.) Deleted: Method 1 is applicable only to non-built-in Enhanced Child Restraint Systems and Method 2 is applicable only to vehicle specific built-in Enhanced Child Restraint Systems. Deleted: CRS‐60‐01e.docx2¶ Formatted: English (U.K.) Formatted: English (U.K.) Method 1 The Enhanced Child Restraint System manufacturer shall declare in writing that the flammability of materials used to manufacture the Child Restraint System is in conformity with the method of section 5.4 of EN 71-2:2011+A1:2014 with a maximum rate of spread of flame of 30 mm/s. Tests confirming the validity of the declaration may be carried out at the discretion of the Technical Service. Where fabrics are assembled together, these shall be tested as a composite. Method 2 The applicant shall declare in writing that when testing materials in accordance with Annex 23 of the regulation, the materials used shall not burn, nor transmit a flame front across its surface, at a rate of more the 100 mm per minutes. Each material used in an enhanced child restraint system shall conform to these requirements. However, the requirement concerning transmission of a flame front shall not apply to a surface created by cutting a test specimen for purposes of testing pursuant to Annex 23. The requirements shall be met in both the "in-use" and in the "stowed" positions of the built-in Enhanced Child Restraint System. If a material stops burning before it has burned for 60 seconds from the start of timing, and has not burned more than 51 mm from the point where the timing was started, it shall be considered to meet the burn-rate requirement specified above. Tests confirming the validity of the declaration may be carried out at the discretion of the Technical Service.
AutoNDA by SimpleDocs

Related to The flammability of Child Restraint

  • VISIBILITY OF FUNDING FROM THE OFFICIAL DEVELOPMENT ASSISTANCE Unless the SAIDC requests or agrees otherwise, any communication or publication made by the Final Beneficiary that relates to the action, including at conferences, seminars or in any information or promotional materials (such as brochures, leaflets, posters, presentations in electronic form, etc.), including tangible assets acquired from the project must: (a) indicate that the action has received funding from the Official Development Assistance, SlovakAid and (b) display the SlovakAid logo. When displayed in association with another logo, the SlovakAid logo must have appropriate prominence. The obligation to display the SlovakAid logo does not confer on the Final Beneficiary a right of exclusive use. The Final Beneficiary may not appropriate the SlovakAid logo or any similar trademark or logo, either by registration or by any other means. For the purposes of the first, second and third subparagraphs and under the conditions specified therein, the Final Beneficiary may use the SlovakAid logo without first obtaining permission from the SAIDC.

  • STABILITY OF AGREEMENT Section 1 No amendment, alteration or variation of the terms or provisions of this Agreement shall bind the parties hereto unless made and executed in writing.

  • Accessibility of Information Technology Contractor represents and warrants that any software/ hardware/ communications system/ equipment (collectively “technology”), if any, provided under this Agreement adheres to the standards and/or specifications as may be set forth in the Section 508 of the Rehabilitation Act of 1973 standards guide and is fully compliant with WCAG 2.0 AA standards for accessibility and compliant with any applicable FCC regulations. Technology that will be used on a mobile device must also be navigable with Voiceover on iOS devices in addition to meeting WCAG 2.0 level AA. If portions of the technology or user experience are alleged to be non-compliant or non- accessible at any point, District will provide Contractor with notice of such allegation and Contractor shall use its best efforts to make the technology compliant and accessible. If a state or federal department, office or regulatory agency, or if any other third party administrative agency or organization (“Claimants”), make a claim, allegation, initiates legal or regulatory process, or if a court finds or otherwise determines that technology is non-compliant or non-accessible, Contractor shall indemnify, defend and hold harmless the District from and against any and all such claims, allegations, liabilities, damages, penalties, fees, costs (including but not limited to reasonable attorneys’ fees), arising out of or related to Xxxxxxxxx’ claims. Contractor shall also fully indemnify District for the full cost of any user accommodation that is found to be necessary due to an identifiable lack of accessibility in the Contractor’s technology. If necessary, an independent 3rd party accessibility firm using POUR standards (Perceivable, Operable, Understandable and Robust) may be used to validate the accessibility of the technology.

  • Restrictions on Use of Hazardous Substances Borrower will not cause or permit the presence, use, disposal, storage, or release of any Hazardous Substances, or threaten to release any Hazardous Substances, on or in the Property. Borrower will not do, nor allow anyone else to do, anything affecting the Property that: (i) violates Environmental Law; (ii) creates an Environmental Condition; or (iii) due to the presence, use, or release of a Hazardous Substance, creates a condition that adversely affects or could adversely affect the value of the Property. The preceding two sentences will not apply to the presence, use, or storage on the Property of small quantities of Hazardous Substances that are generally recognized to be appropriate to normal residential uses and to maintenance of the Property (including, but not limited to, hazardous substances in consumer products).

  • Staffing Levels to deal with Potential Violence The Employer agrees that, where there is a risk of violence, an adequate level of trained employees should be present. The Employer recognizes that workloads can lead to fatigue and a diminished ability both to identify and to subsequently deal with potentially violent situations.

  • Child safe environment 5.1 Catholic school communities have a moral, legal and mission-driven responsibility to create nurturing school environments where children are respected, their voices are heard, and where they are safe and feel safe.

  • Least Restrictive Environment The Board and the Association acknowledge that the policy of least restrictive environment is legally mandated and intended in the best educational interest of the student. Accordingly, the parties who would fit legal requirements which would involve the use of an Individual Educational Planning Team (IEPT) for placement in the regular classroom must be appropriate to the student’s unique needs as determined by an IEP on an individual basis. For the purpose of this section, such students shall be referred to as “mainstreamed students.”

  • GEOGRAPHIC AREA AND SECTOR SPECIFIC ALLOWANCES, CONDITIONS AND EXCEPTIONS The following allowances and conditions shall apply where relevant: Where the company does work which falls under the following headings, the company agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.

  • Prohibition Against Selecting and Installing Products Containing Hazardous Materials The Contractor shall not select, install or otherwise incorporate any products or materials containing Hazardous Materials within the boundaries of the Site. Should the Contractor or any Subcontractors have knowledge that, or believe that, an item, component, material, substance, or accessory within a product or assembly selected by the Contractor or any Subcontractor may contain Hazardous Materials it is the Contractor’s responsibility to secure a written certification from the manufacturer of any suspected material which identifies the specific Hazardous Material(s) contained, together with the Material Safety Data Sheets (MSDS) for such materials which shall be submitted to the Owner and Design Professional.

  • Convicted, Discriminatory, Antitrust Violator, and Suspended Vendor Lists In accordance with sections 287.133, 287.134, and 287.137, F.S., the Contractor is hereby informed of the provisions of sections 287.133(2)(a), 287.134(2)(a), and 287.137(2)(a), F.S. For purposes of this Contract, a person or affiliate who is on the Convicted Vendor List, the Discriminatory Vendor List, or the Antitrust Violator Vendor List may not perform work as a contractor, supplier, subcontractor, or consultant under the Contract. The Contractor must notify the Department if it or any of its suppliers, subcontractors, or consultants have been placed on the Convicted Vendor List, the Discriminatory Vendor List, or the Antitrust Violator Vendor List during the term of the Contract. In accordance with section 287.1351, F.S., a vendor placed on the Suspended Vendor List may not enter into or renew a contract to provide any goods or services to an agency after its placement on the Suspended Vendor List. A firm or individual placed on the Suspended Vendor List pursuant to section 287.1351, F.S., the Convicted Vendor List pursuant to section 287.133, F.S., the Antitrust Violator Vendor List pursuant to section 287.137, F.S., or the Discriminatory Vendor List pursuant to section 287.134, F.S., is immediately disqualified from Contract eligibility.

Time is Money Join Law Insider Premium to draft better contracts faster.