Tracking and Tracing Sample Clauses

Tracking and Tracing. Carrier, to the best of its capabilities, shall make available in-transit load position and related load delivery status and tracing information. For information provided by Carrier in response to Shipper's inquiry by telephone, e-mail, or other method requiring personal contact and response.
Sample 1Sample 2See All (4)
AutoNDA by SimpleDocs
Tracking and Tracing. Carrier shall maintain a system of communication whereby Broker is advised at least once a day of the location of a shipment in transit and any circumstances which might prevent Carrier from accomplishing timely and safe delivery.
Sample 1Sample 2Sample 3
Tracking and Tracing. Covid-19
Sample 1
Tracking and Tracing. Carrier, to the best of its capabilities, shall make available in-transit load position and related load delivery status and tracing information. For information provided by Carrier in response to Shipper's inquiry by telephone, e-mail, or other method requiring personal contact and response. While the responsible carrier will be tracking loads to help meet shipper requirements, forwarding such information upon individual request involves a cost to the carrier that may not be substantial on an occasional, individual inquiry basis, but can be substantial in the aggregate. Costs for multiple inquires generally are not contemplated in the pricing of service. Thus, a reasonable charge for excessive use of the service, which is by choice, appears appropriate. The parties may agree that the provisions of this Section shall not apply if a load is delayed beyond an agreed upon time.
Sample 1
Tracking and Tracing. Section 5.01 .
Sample 1
Tracking and Tracing. Carrier, to the best of its capabilities, shall make available in-transit load position and related load delivery status and tracing information.
Sample 1
Tracking and Tracing. To deal with the aftermath of a defective radio unit, Boing traces all other aircraft that use the same type of radio using the data’s semantic properties. While an improved tracking & tracing efficiency is not a contribution of our system, we argue that ReShare provides the needed reliability through LD. After outlining three distinct and common real-world scenarios, we now present ReShare’s DTC generation and verification mechanisms.
Sample 1
AutoNDA by SimpleDocs

Related to Tracking and Tracing

  • Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.

  • Secure Information Handling and Transfers 7.1 Physical and electronic handling, processing and transferring of DWP Data, including secure access to systems and the use of encryption where appropriate.

  • Packing and Marking All material and equipment to be furnished by the Contractor shall be packed, crated or otherwise suitably protected to withstand shipment undamaged to the destination. Each package, crate or part shall be marked plainly with the name of the consignee, shipping destination, the Owner's order number, and such other markings as are required. Complete packing lists, one copy with each package and two (2) copies by mail to the Owner at time of shipment, shall be supplied showing contents and identity of each package.

  • PACKING AND SHIPPING a. Seller shall pack the goods and materials to prevent damage and deterioration. Unless otherwise set forth in this Contract, Seller shall package the goods in accordance with the requirements of Boeing Document D37522-6 “Supplier Packaging”. Buyer may charge Seller for damage to or deterioration of any goods resulting from improper packing or packaging. b. If the Contract specifies FOB destination (place of delivery), then in addition to any other shipping instructions, Seller shall forward goods freight prepaid. Seller shall make the transportation arrangements, pay the shipping costs, and remain responsible for the goods and materials until the goods and materials are delivered and the Buyer takes possession at the destination. c. If the Contract specifies FOB origin (place of shipment), then in addition to any other shipping instructions, Seller shall forward goods collect. For goods shipped within the United States, Seller shall make no declaration concerning the value of the goods shipped except on goods where the tariff rating is dependent upon released or declared value. In such event, Seller shall release or declare such value at the maximum value within the lowest rating. Seller will ship the goods in accordance with the provisions set forth in the Boeing Domestic Shipment Routing Guide to be accessed through Buyer’s supplier portal at xxxxx://xxxxxx.xxxxxxx.xxx/. Sellers need a One Time Password (OTP) token to log into the Boeing Supplier Portal. Upon Xxxxx’s request, Seller will identify packaging charges showing material and labor costs for container fabrication. d. Seller shall provide with each container shipped under this Contract an Advanced Shipping Notice (“ASN”). For each container shipped, Seller shall provide two (2) readable copies of the ASN barcode as follows: one (1) copy is to be securely affixed to the outside of each container and one (1) copy is to be loose inside each container. Non- conforming shipments are subject to rejection and repackaging at Seller’s expense. Instructions and guidelines related to the ASN process can be found on the Boeing Supplier Portal. Seller shall access by selecting the “Enterprise ASN Instructions” hyper-link under the header “Exostar Resources”. A copy of these instructions can also be found at xxx.xxxxxxx.xxx.

  • Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers. 5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem. 5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.

  • Program Monitoring and Evaluation The Recipient shall prepare, or cause to be prepared, and furnish to the Association not later than six months after the Closing Date, a report of such scope and in such detail as the Association shall reasonably request, on the execution of the Program, the performance by the Recipient and the Association of their respective obligations under the Legal Agreements and the accomplishment of the purposes of the Financing.”

  • Points of Interconnection and Trunk Types 2.1 Point(s) of Interconnection. 2.1.1 Each Party, at its own expense, shall provide transport facilities to the technically feasible Point(s) of Interconnection on Verizon’s network in a LATA selected by PNG.

  • Monitoring and Evaluation a. The AGENCY shall expeditiously provide to the COUNTY upon request, all data needed for the purpose of monitoring, evaluating and/or auditing the program(s). This data shall include, but not be limited to, clients served, services provided, outcomes achieved, information on materials and services delivered, and any other data required, in the sole discretion of the COUNTY, that may be required to adequately monitor and evaluate the services provided under this Contract. Monitoring shall be performed in accordance with COUNTY’S established Noncompliance Standards, a copy of which is attached hereto and incorporated by reference as Attachment “C”. b. The AGENCY agrees to permit persons duly authorized by the COUNTY to interview any clients and all current and/or former employees of the AGENCY to be assured of the AGENCY’S satisfactory performance of the terms of this Contract. c. Following such evaluation, monitoring, and/or audit, the COUNTY will deliver a report of its findings and recommendations with regard to the AGENCY’S conformance with this Contract’s terms and conditions to the AGENCY and/or Board of Directors’ President, and members, whenever applicable. If deficiencies are noted, a written notice of corrective action will be issued to the AGENCY which will specify deficiencies and provide a timeline for correction of those deficiencies. Within the designated timeframe in the written notice of corrective action, the AGENCY shall submit to the COUNTY’S CCC manager (“Manager”), or their designee, a corrective action plan to rectify all deficiencies identified by the COUNTY. d. Failure by the AGENCY to correct noted deficiencies, as outlined in the written notice of corrective action, may result in the AGENCY being deemed in breach of the Contract terms. e. The AGENCY shall cooperate with the COUNTY on all reviews to ensure compliance with all applicable COUNTY guidelines and requirements for general fund recipients.

  • Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.

  • PACKING AND SHIPMENT (a) Unless otherwise specified, all Work is to be packed in accordance with good commercial practice. (b) A complete packing list shall be enclosed with all shipments. SELLER shall mark containers or packages with necessary lifting, loading, and shipping information, including the LOCKHEED XXXXXX Contract number, item number, dates of shipment, and the names and addresses of consignor and consignee. Bills of lading shall include this Contract number. (c) Unless otherwise specified, delivery shall be FOB Place of Shipment.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!