Traffic Control The Surveyor shall control traffic in and near surveying operations adequately to comply with provisions of the latest edition of the Texas Manual on Uniform Traffic Control Devices – Part VI which can be found on the State’s internet site. In the event field crew personnel must divert traffic or close traveled lanes, a Traffic Control Plan based upon principles outlined in the latest edition of the Texas Manual on Uniform Traffic Control Devices – Part VI shall be prepared by the Surveyor and approved by the State prior to commencement of field work. A copy of the approved plan shall be in the possession of field crew personnel on the job site at all times and shall be made available to the State’s personnel for inspection upon request.
Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers.
5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem.
5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.
Export Control Compliance User acknowledges that Center is an open laboratory for fundamental research that has many foreign persons as its employees and students. User understands and agrees that under no circumstances will User bring export control-listed items, or unpublished software source code or technical information in the form of defense articles or technical data regulated by the International Traffic in Arms Regulations (ITAR), to Center. Use of Center or facilities for activity subject to the ITAR, including the development, assembly or fabrication of defense articles identified on the US Munitions List, is prohibited.
WORKPLACE HEALTH AND SAFETY The parties to this Agreement are committed to providing a safe and healthy workplace and work practices. The parties recognise that illness or injury at the workplace is costly to the employer and the employees and also disruptive to the respective parties. To facilitate healthy and safe work practices, the parties to the Agreement are committed to discussing health and safety issues as they apply to the operations of the employer as part of the consultative measures under this Agreement. The employer and employees under this agreement may refer to their respective industrial representatives for appropriate advice or expertise in enhancing performance with due regard to health and safety initiatives. The parties also recognise the importance of conducting regular audits of the employer's operations, policies and procedures including the employees' skills, knowledge, qualifications and application of healthy and safe work practices.
Export Control This Agreement is made subject to any restrictions concerning the export of products or technical information from the United States or other countries that may be imposed on the Parties from time to time. Each Party agrees that it will not export, directly or indirectly, any technical information acquired from the other Party under this Agreement or any products using such technical information to a location or in a manner that at the time of export requires an export license or other governmental approval, without first obtaining the written consent to do so from the appropriate agency or other governmental entity in accordance with Applicable Law.
Export Control Laws LICENSEE shall observe all applicable United States and foreign laws with respect to the transfer of Licensed Products and related technical data to foreign countries, including, without limitation, the International Traffic in Arms Regulations and the Export Administration Regulations.
Function of Joint Health and Safety Committee All incidents involving aggression or violence shall be brought to the attention of the Joint Health and Safety Committee. The Employer agrees that the Joint Health and Safety Committee shall concern itself with all matters relating to violence to staff.
Export Administration Each party agrees to comply with all export laws and regulations of the United States (“Export Laws”) to assure that no software deliverable, item, service, technical data or any direct product thereof arising out of or related to this Agreement is exported directly or indirectly (as a physical export or a deemed export) in violation of Export Laws.
Anti-slavery and human trafficking The Supplier shall: ensure that slavery and human trafficking is not taking place in any part of its business or in any part of its supply chain; implement due diligence procedures for its own suppliers, subcontractors and other participants in its supply chains, to ensure that there is no slavery or human trafficking in its supply chains; respond promptly to all slavery and human trafficking due diligence questionnaires issued to it by the British Council from time to time and ensure that its responses to all such questionnaires are complete and accurate; and notify the British Council as soon as it becomes aware of any actual or suspected slavery or human trafficking in any part of its business or in a supply chain which has a connection with this Agreement. If the Supplier fails to comply with any of its obligations under clause 13.1, without prejudice to any other rights or remedies which the British Council may have, the British Council shall be entitled to: terminate this Agreement without liability to the Supplier immediately on giving notice to the Supplier; and/or reduce, withhold or claim a repayment (in full or in part) of the charges payable under this Agreement; and/or share with third parties information about such non-compliance.
Erosion Prevention and Control Purchaser’s Operations shall be conducted reasonably to minimize soil erosion. Equipment shall not be operated when ground conditions are such that excessive damage will result. Purchaser shall adjust the kinds and intensity of erosion control work done to ground and weather condi- tions and the need for controlling runoff. Erosion control work shall be kept current immediately preceding ex- pected seasonal periods of precipitation or runoff.
