Vendor’s Conditions The Vendor shall not be obligated to complete the Transaction unless, at or before the Closing Time, each of the conditions listed below in this section has been satisfied, it being understood that the said conditions are included for the exclusive benefit of the Vendor: (a) The representations and warranties of YC in this Agreement shall be true and correct on the Closing Date. (b) YC shall have performed and complied with all of the terms and conditions in this Agreement and the Payment Undertaking on its part to be performed or complied with on or before the Closing Date. (c) As evidence of the satisfaction of the conditions in sections 7.1 (a) and (b), YC shall deliver to the Vendor at the Closing Time a certificate of YC confirming the matters in sections 7.1 (a) and (b) and to the effect that as of the Closing Time all other conditions set forth in this section have been satisfied. The certificate shall be signed by two senior executive officers of YC acceptable to the Vendor, acting reasonably. Notwithstanding the foregoing, the receipt of such certificate and the completion of the Transaction shall not constitute a waiver (in whole or in part) of, or have the effect of modifying or qualifying in any way, any of the representations and warranties of YC made in or pursuant to this Agreement, each of which shall survive the Closing and remain in full force and effect for the benefit of the Vendor as provided in Article 9. (d) YC and the Buyer shall have delivered to the Vendor a legal opinion from counsel acceptable to the Vendor, acting reasonably, and in form and content satisfactory to the Vendor subject to reasonable qualifications, as to the due incorporation and organization of YC and the Buyer, the corporate power and authority of YC and the Buyer, the receipt of all necessary approvals by YC and the Buyer and the enforceability of this Agreement, the Payment Undertaking and the Covenant Escrow Agreement as against YC and the Buyer and the non-conflict of this Agreement, the Payment Undertaking and the Covenant Escrow Agreement with respect to the constating documents of YC and the Buyer and any Applicable Laws. (e) The Vendor Regulatory Approval shall have been granted, obtained and received unconditionally or on terms satisfactory to the Vendor, acting reasonably. (f) No Order shall have been made and no Legal Proceeding shall have been commenced or shall be pending or threatened against the other Party or its affiliates or which enjoins, restricts or prohibits, or which asserts a claim or seeks a remedy that would have the effect of enjoining, restricting or prohibiting the completion of the Transaction. If any condition in this section has not been fulfilled on or before the Closing Date or if any such condition is or becomes impossible to satisfy, other than as a result of the failure of the Vendor to comply with its obligations under this Agreement, then the Vendor in its sole discretion may, without limiting any rights or remedies available to the Vendor at law or in equity, either terminate this Agreement by written notice to YC, in which case the provisions of sections 2.5(c)(iii), (iv) or (v) shall be applicable, or waive compliance with any such condition without prejudice to its right of termination in the event of non-fulfilment of any other condition.
Under-Frequency and Over Frequency Conditions The New York State Transmission System is designed to automatically activate a load- shed program as required by the NPCC in the event of an under-frequency system disturbance. Developer shall implement under-frequency and over-frequency relay set points for the Large Generating Facility as required by the NPCC to ensure “ride through” capability of the New York State Transmission System. Large Generating Facility response to frequency deviations of predetermined magnitudes, both under-frequency and over-frequency deviations, shall be studied and coordinated with the NYISO and Connecting Transmission Owner in accordance with Good Utility Practice. The term “ride through” as used herein shall mean the ability of a Generating Facility to stay connected to and synchronized with the New York State Transmission System during system disturbances within a range of under-frequency and over-frequency conditions, in accordance with Good Utility Practice and with NPCC Regional Reliability Reference Directory # 12, or its successor.
Service Conditions Customer acknowledges that in the event of a service issue, Customer is responsible for on-site cooperative testing with LightEdge Technical Support to assist in the diagnosis of the trouble. Customer agrees to be bound to current terms of LightEdge Acceptable Use Policy. Terms of the Acceptable Use Policy are subject to change without notice. Current Acceptable Use Policy can be found here: xxxx://xxx.xxxxxxxxx.xxx/legal Customer agrees that any service complaints including concerns regarding level of support, products, service reliability, or any other concerns related to LightEdge or Services being provided by LIghtEdge will be communicated to LightEdge by sending an email to xx@xxxxxxxxx.xxx.
Partial Disposal During Term of Service Agreement Throughout the Term of the Service Agreement, LEA may request partial disposal of Student Data obtained under the Service Agreement that is no longer needed. Partial disposal of data shall be subject to LEA’s request to transfer data to a separate account, pursuant to Article II, section 3, above.
Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.
Outage Repair Standard In the event of an outage or trouble in any Service being provided by a Party hereunder, the Providing Party will follow Verizon’s standard procedures for isolating and clearing the outage or trouble.
Electrical Service Electrical service for new construction or a renovated existing building shall be 480/277-volt, 3-phase, 4-wire or approved equal. Service shall be sized for HVAC and other mechanical system(s) loads, lighting, general building services, and dedicated computer based office equipment loads. 5 xxxxx per square foot shall be provided for lighting and general service receptacles. Size of neutral conductor of 3- phase circuits shall be twice that of phase conductor to accommodate potential harmonic currents associated with computer system electronic power supplies and fluorescent lighting fixtures electronic ballasts.
Provisioning Line Splitting and Splitter Space 3.8.1 The Data LEC, Voice CLEC or BellSouth may provide the splitter. When Southern Telecom or its authorized agent owns the splitter, Line Splitting requires the following: a non-designed analog Loop from the serving wire center to the NID at the End User’s location; a collocation cross connection connecting the Loop to the collocation space; a second collocation cross connection from the collocation space connected to a voice port; the high frequency spectrum line activation, and a splitter. The Loop and port cannot be a Loop and port combination (i.e. UNE-P), but must be individual stand-alone Network Elements. When BellSouth owns the splitter, Line Splitting requires the following: a non designed analog Loop from the serving wire center to the NID at the End User’s location with CFA and splitter port assignments, and a collocation cross connection from the collocation space connected to a voice port. 3.8.2 An unloaded 2-wire copper Loop must serve the End User. The meet point for the Voice CLEC and the Data LEC is the point of termination on the MDF for the Data LEC's cable and pairs. 3.8.3 The foregoing procedures are applicable to migration to Line Splitting Service from a UNE-P arrangement, BellSouth Retail Voice Service, BellSouth High Frequency Spectrum (CO Based) Line Sharing. 3.8.4 For other migration scenarios to line splitting, BellSouth will work cooperatively with CLECs to develop methods and procedures to develop a process whereby a Voice CLEC and a Data LEC may provide services over the same Loop.
Delivery Condition Subtenant acknowledges that it takes possession of the Subleased Premises in its “as is” condition, and further acknowledges that Sublandlord has made no representations or warranties of any kind or nature, whether express or implied, with respect to the Subleased Premises, the remainder of the Premises, the common areas, or the Building, nor has Sublandlord agreed to undertake or perform any modifications, alterations, or improvements to the Subleased Premises, the remainder of the Premises, the common areas or the Building which would inure to Subtenant’s benefit.
Delivery Conditions (a) The Delivery Conditions are as follows: (i) At Seller’s expense, Seller shall have secured all Governmental and grid operations approvals as are necessary for the safe and lawful operation and maintenance of the Project and to enable Seller to deliver Distribution Services at the Initial Contract Capacity to Buyer. (ii) Seller shall have posted collateral as required by Section 10.4(a)(ii). (iii) Seller shall have submitted for Buyer’s review a Project Safety Plan incorporating the elements described in Appendix XII, which must demonstrate Seller’s ability to comply with the Safety Requirements on the IDD and for the Delivery Term. (iv) Seller shall have delivered to Buyer the Safety Attestation in accordance with Section 2(a) of Appendix XIV. (v) As of the IDD, no Seller’s Event of Default shall have occurred and remain uncured. (vi) At Seller’s expense, Seller or Contractor shall have constructed or caused to be constructed the Project as of the IDD and submitted the Certification for Commercial Operation in Appendix VII-A to enable (A) Seller to satisfy the obligations of the Seller herein and (B) the Project to deliver Distribution Services at the Contract Capacity to Buyer. (vii) At Seller’s expense, Seller shall have installed any necessary metering to deliver the applicable Distribution Services in accordance with Section 4.1 and any applicable tariffs of the Utility Distribution Company. (viii) Seller shall have met each Critical Milestone set forth in Appendix VI pursuant to Section 2.3.
