Vehicle Dimensions and Regulations Sample Clauses

Vehicle Dimensions and Regulations. The Regulations on Characteristics, Weight and Dimensions, Lights and Exhaust Gas Emissions of Motor Vehicles, Trailers and Semi-Trailers, determines the dimensions of vehicles as follows (Decreto Presidencial n.º 185/13 - Presidente da República Diário da República Iª Série n.º 215 de 7 de Novembro de 2013)):
AutoNDA by SimpleDocs
Vehicle Dimensions and Regulations. Maximum Length:  Truck body length-with or without trailer: 12m  Truck tractor with semi- trailer: 17m  Truck with draw bar trailer: 18m Note: At a meeting with the officials, it was indicated that car-carriers are allowed a length of 29 m and that the maximum length for all other vehicles is 19m and not 18m as indicated on the website of the ERA. Maximum width of vehicles:  2.5m Maximum Height of vehicles:  4.2m

Related to Vehicle Dimensions and Regulations

  • Policies and Regulations 34 In addition to the Federal Acquisition Regulation (FAR) clauses referred to 35 and listed herein of this Request for Proposal (RFP), the contractor shall 36 comply with the Federal Regulations, Acts, Executive Orders, Special 37 Publications, Guidelines, NOAA Directives and Policies and standards listed 38 below. This listing is not all-inclusive and is not intended to relieve the 39 contractor of its responsibilities for identification of applicable statutes, 40 regulations and procedures and compliance therewith, when performing work 41 under this SOW. 42  Xxxxxxxx-Xxxxxxx Xxxxxxx, Management, and Conservation Act (MSA) 43  Marine Mammal Protection Act (MMPA) 44  Endangered Species Act (ESA) 45  Data Quality Control Act (P.L. 106-514) 46  Information Technology Security Policy 47  Fisheries Management Plans (FMP) 48  Biological Opinions (BO) 49  Take Reduction Team (TRT) 50  NOAA Safety Standards 1  Fair Labor Standards Act (FLSA) 2  Service Contract Act (SCA) 3  Department of Labor Wage Determinations 4  Applicable Federal and State labor laws 5  At-Sea Monitor Health and Safety regulations 6  Federal, state, and local safety regulations 7  Merchant Marine Act (Xxxxx Act) and General Maritime Law 8  U.S. Xxxxxxxxx and Harbor Worker’s Compensation Act

  • CODES AND REGULATIONS The Contractor shall strictly comply with all Federal, State and local codes and regulations.

  • Fire, Life Safety, and Accessibility Codes The following codes, in the versions approved by the Georgia State Fire Marshal/Fire Safety Commissioner and Department of Human Resources, shall be used. The Design Professional will designate any additional codes or special modifications in the Supplementary General Conditions.

  • Surveys, Permits, and Regulations The Owner shall furnish all surveys unless otherwise specified. Permits and licenses of a temporary nature necessary for the prosecution of the Work shall be obtained and paid for by the Contractor. Permits, licenses, and easements for permanent structures or permanent changes in existing facilities shall be obtained and paid for by the Owner unless otherwise specified. The Contractor and its Subcontractors must pay any municipal or county occupational licenses, taxes, or fees, if any. The Contractor shall give all notices and comply with all laws, ordinances, rules, and regulations bearing on the conduct of the Work. If the Contractor observes that the drawings or specifications are at variance with any such laws, ordinances, rules or regulations, he shall promptly notify the Owner in writing, and any necessary changes shall be adjusted as provided in the Contract for changes in the Work. If the Contractor performs any Work knowing it to be contrary to such laws, ordinances, rules or regulations without such notice to the Owner, he shall bear all costs arising therefrom. Nothing in this paragraph shall be construed to impose design responsibility on the Contractor except as noted in the Contract Documents.

  • Enterprise Information Management Standards Grantee shall conform to HHS standards for data management as described by the policies of the HHS Office of Data, Analytics, and Performance. These include, but are not limited to, standards for documentation and communication of data models, metadata, and other data definition methods that are required by HHS for ongoing data governance, strategic portfolio analysis, interoperability planning, and valuation of HHS System data assets.

  • Fire Regulations All Exhibitors must comply with the regulations of the local authority and applicable law as they relate to the design and construction of Exhibition stands, and the use of suitably fireproofed materials.

  • ROAD GRADE AND ALIGNMENT STANDARDS Purchaser shall follow these standards for road grade and alignment except as designed:  Grade and alignment must have smooth continuity, without abrupt changes in direction.  Maximum grades may not exceed 18 percent favorable and 12 percent adverse.  Minimum curve radius is 60 feet at centerline.  Maximum grade change for sag vertical curves is 5% in 100 feet.  Maximum grade change for crest vertical curves is 4% in 100 feet.

  • Procurement Regulations The contract shall be governed by the applicable provisions of the Mississippi Public Procurement Review Board Office of Personal Service Contract Review Rules and Regulations, a copy of which is available at 000 Xxxxx Xxxx Xxxxxx, Xxxxx 000X, Xxxxxxx, Xxxxxxxxxxx 00000 for inspection, or downloadable at xxxx://xxx.XXX.xx.xxx.

  • Compliance with Laws and Regulations A. The Parties shall comply with all applicable laws and regulations including, but not limited to, safety; security; export control; environmental; and suspension and debarment laws and regulations. Access by a Partner to NASA facilities or property, or to a NASA Information Technology (IT) system or application, is contingent upon compliance with NASA security and safety policies and guidelines including, but not limited to, standards on badging, credentials, and facility and IT system/application access.

  • Consistency with Federal Laws and Regulations This Agreement shall incorporate by reference Section 22.9 of the CAISO Tariff as if the references to the CAISO Tariff were referring to this Agreement.

Time is Money Join Law Insider Premium to draft better contracts faster.