Ventilation holes check Sample Clauses

Ventilation holes check. An approved wheel shall not reduce the brake efficiency in comparison with a manufacturer’s replacement wheel. The heat transfer from the brakes into steel wheels is regarded as being more severe than that with of light alloy wheels. In the case where the vehicle manufacturer’s replacement wheel is designed for a defined air circulation from the brake through the wheel ventilation holes (for example by "windmilling" effect) and where the area of the ventilation holes, in a pattern part replacement wheel, is smaller than the corresponding vehicle manufacturer’s replacement wheel, a comparison test shall be carried out to evaluate the brake efficiency. The test shall follow the requirements of Regulation Xx. 00, Xxxxxxxx 0, xxxxxxxxx 1.5. Type I - Fade test procedure. The criterion is the brake temperature. The maximum temperature measured (discs, drum) using the vehicle manufacturer’s replacement wheel must not be exceeded with the wheel to be approved. Any hubcaps normally fitted are to be taken into account.
AutoNDA by SimpleDocs

Related to Ventilation holes check

  • Ventilation Where noxious or poisonous gases may accumulate, the City shall provide proper protection and ventilation. Proper lighting and ventilation shall be provided for all enclosed working spaces. All work in enclosed and confined spaces shall be performed in accordance with applicable Federal, State and local regulations. Spray painting shall be done only by qualified painters.

  • Heating The Hirer shall ensure that no unauthorised heating appliances shall be used on the premises when open to the public without the consent of the management committee. Portable Liquefied Propane Gas (LPG) heating appliances shall not be used.

  • Plumbing fixtures and appliances shall be used only for the purposes for which designed, and no sweepings, rubbish, rags or other unsuitable material shall be thrown or deposited therein. Damage resulting to any such fixtures or appliances from misuse by a tenant or its agents, employees or invitees, shall be paid by such tenant.

  • HVAC A. Heating, ventilating and air conditioning equipment will be provided with sufficient capacity to accommodate a maximum population density of one (1) person per one hundred fifty (150) square feet of useable floor area served, and a combined lighting and standard electrical load of 3.0 xxxxx per square foot of useable floor area. In the event Tenant introduces into the Premises personnel or equipment which overloads the system’s ability to adequately perform its proper functions, Landlord shall so notify Tenant in writing and supplementary system(s) may be required and installed by Landlord at Tenant’s expense, if within fifteen (15) days Tenant has not modified its use so as not to cause such overload. Operating criteria of the basic system shall not be less than the following:

  • Electrical Provide drawings for the following systems:

  • Insulation In exterior walls? Yes No Unknown In ceiling/attic? Yes No Unknown In any other areas? Yes No Where? Comments:

  • Elevators Landlord shall provide passenger elevator service during normal business hours to Tenant in common with Landlord and all other tenants. Landlord shall provide limited passenger service at other times, except in case of an emergency.

  • Cheating Cheating is prohibited, and will result in immediate action and termination without compensation.

  • Illumination The Engineer shall refer to TxDOT’s Highway Illumination Manual and other deemed necessary State approved manuals for design of continuous lighting and safety lighting for all conventional, high-mast, and underpass lighting. The Engineer shall include safety lighting as part of each design on each flashing beacon and traffic signal. The Engineer shall provide a preliminary layout for initial review and approval by the State. The Engineer shall prepare circuit wiring diagrams showing the number of luminaries on each circuit, electrical conductors, length of runs, service pole assemblies. Underpass lighting must be used on all structures within each project. The Engineer shall integrate existing illumination within the project limits into the proposed design. The Engineer shall coordinate with the State to determine the location of proposed high- mast, conventional, and underpass lighting.

  • Air Conditioning If the Apartment has been provided with a ledge for split air conditioning system with suitable provision for keeping outdoor units of the AC system and also the route to take refrigerant piping, which the Allottee shall have to strictly follow while installing AC units

Time is Money Join Law Insider Premium to draft better contracts faster.