Base liner system definition

Base liner system means the liner system installed on the C&DLF unit's foundation to control the flow of leachate.
Base liner system means the liner system installed on the CCR unit's foundation to control the
Base liner system means the liner system installed on the MSWLF unit's foundation to control the flow of leachate. (6)(5) "Cap system" means a liner system installed over the MSWLF unit to minimize infiltration of precipitation and contain

Examples of Base liner system in a sentence

  • GHD10271 Shellbridge Way Suite 165 Richmond British Columbia V6X 2W8 CanadaT 604 214 0510 F 604 214 0525 W www.ghd.com Figure 1 Base liner system with leak detection layer schematic In the event of primary liner leakage, leachate will be collected and conveyed in sand drainage layer to perforated collection piping.

  • New CCR units and lateral5 expansions shall comply with the following design and construction criteria.6 (b) Base liner system description.

Related to Base liner system

  • Combined sewer system means a system for conveying both sanitary sewage and storm water runoff.

  • Small wireless facility means a wireless facility that meets both of the following qualifications:

  • Micro wireless facility means a small cell facility that is not larger in dimension than 24 inches in length, 15 inches in width, and 12 inches in height and that has an exterior antenna, if any, not longer than 11 inches.

  • MERS(R) System The system of recording transfers of Mortgages electronically maintained by MERS.

  • Wireless facility means equipment at a fixed location that enables wireless communications

  • Customer System means the Customer's computing environment (consisting of hardware, software and/or telecommunications networks or equipment) used by the Customer or the Supplier in connection with this Contract which is owned by or licensed to the Customer by a third party and which interfaces with the Supplier System or which is necessary for the Customer to receive the Services;

  • Supplier System means the information and communications technology system used by the Supplier in performing the Services including the Software, the Equipment and related cabling (but excluding the Customer System);

  • Interconnection Facilities means the Transmission Owner Interconnection Facilities and the Customer Interconnection Facilities.

  • Communications Equipment means the communications equipment of the Licensee and its affiliates, including, without limitation, cabinets, racks, electronic equipment and other similar equipment.

  • Customer Systems means the Customer's information technology infrastructure, including computers, software, hardware, databases, electronic systems (including database management systems), and networks, whether operated by Customer or through the use of third-party services.

  • Customer Interconnection Facilities means all facilities and equipment owned and/or controlled, operated and maintained by Interconnection Customer on Interconnection Customer’s side of the Point of Interconnection identified in the appropriate appendices to the Interconnection Service Agreement and to the Interconnection Construction Service Agreement, including any modifications, additions, or upgrades made to such facilities and equipment, that are necessary to physically and electrically interconnect the Customer Facility with the Transmission System.

  • Signaling System 7 (SS7) means a signaling protocol used by the CCS Network.

  • Trunk Line means the coaxial/optic fiber cable network and other allied equipment such as receiver nodes, amplifiers, splitters etc. owned and installed by the multi-system operator or its associate companies for the purpose of transmitting Cable TV Signal to various LCOs till the receiving end of various LCOs, including the LCO, to enable them to re-transmit the Cable TV Signal to respective subscribers; All other words and expressions used in this interconnection agreement but not defined, and defined in the Act and rules and regulations made thereunder or the CTN Act and the rules and regulations made thereunder, shall have the meanings respectively assigned to them in those Acts or the rules or regulations, as the case may be.

  • Network Load means the load that a Network Customer designates for Network Integration Transmission Service under Tariff, Part III. The Network Customer’s Network Load shall include all load (including losses) served by the output of any Network Resources designated by the Network Customer. A Network Customer may elect to designate less than its total load as Network Load but may not designate only part of the load at a discrete Point of Delivery. Where an Eligible Customer has elected not to designate a particular load at discrete points of delivery as Network Load, the Eligible Customer is responsible for making separate arrangements under Tariff, Part II for any Point-To-Point Transmission Service that may be necessary for such non-designated load.

  • Telecommunications Equipment means equipment, other than Customer Premises Equipment, used by a Carrier to provide Telecommunications Services, and include software integral to such equipment, including upgrades.

  • Continuous parameter monitoring system (CPMS means all of the equipment necessary to meet the data acquisition and availability requirements of the Prevention of Significant Deterioration program, to monitor process and control device operational parameters (for example, control device secondary voltages and electric currents) and other information (for example, gas flow rate, O2 or CO2 concentrations), and to record average operational parameter value(s) on a continuous basis.

  • Bandwidth means a distributor’s defined tolerance used to flag data for further scrutiny at the stage in the VEE process where a current reading is compared to a reading from an equivalent historical billing period. For example, a 30 percent bandwidth means a current reading that is either 30 percent lower or 30 percent higher than the measurement from an equivalent historical billing period will be identified by the VEE process as requiring further scrutiny and verification;

  • Connectivity means the provision of a Permanent Separated Bicycle Lane system that reflects desired routes between all major origins and destinations in the city.

  • Beam monitoring system means a system designed and installed in the radiation head to detect and measure the radiation present in the useful beam.

  • Attachment Facilities means the facilities necessary to physically connect a Customer Facility to the Transmission System or interconnected distribution facilities.

  • Building system means plans, specifications and documentation for a system of manufactured factory-built structures or buildings or for a type or a system of building components, including but not limited to: structural, electrical, mechanical, fire protection, or plumbing systems, and including such variations thereof as are specifically permitted by regulation, and which variations are submitted as part of the building system or amendment thereof.

  • Sewer System means pipelines or conduits, pumping stations, force mains, vehicles, vessels, conveyances, injection wells, and all other constructions, devices, and appliances appurtenant thereto used for conducting sewage or industrial waste or other wastes to a point of ultimate disposal or disposal to any water of the state. To the extent that they are not subject to section 402 of the federal Water Pollution Control Act, ditches, pipes, and drains that serve only to collect, channel, direct, and convey nonpoint runoff from precipitation are not considered as sewer systems for the purposes of this part of this division.

  • Plumbing system means water supply distribution and disposal piping on the premises, including appliances and equipment attached thereto, between their connection points to a public or private system.

  • Stand Alone System Upgrade Facilities means System Upgrade Facilities that a Developer may construct without affecting day-to-day operations of the New York State Transmission System during their construction. NYISO, the Connecting Transmission Owner and the Developer must agree as to what constitutes Stand Alone System Upgrade Facilities and identify them in Appendix A to this Agreement.

  • Electrical Interconnection Facilities means the equipment and facilities required to safely and reliably interconnect a Facility to the transmission system of the Transmitting Utility, including the collection system between each Bloom System, transformers and all switching, metering, communications, control and safety equipment, including the facilities described in any applicable Interconnection Agreement.

  • Signaling System 7 (SS7 means a signaling protocol used by the CCS Network.