BLANKET INSULATION definition

BLANKET INSULATION. Glass fiber manufactured by Xxxxx Corning or Manville or Mineral Wool Manufactured by U.S. gypsum conforming to Federal Specifications HH-I-521F. All insulation materials must be certified to meet the requirements of Sec. 2-5311 (a) and installed to meet the requirements of Section 2-5311(b) of the BUILDING ENERGY EFFICIENCY STANDARDS. 1986 edition as published by the California Energy Commission. ACCESSORY MATERIALS: Miscellaneous Fastenings, Accessories: As acceptable to insulation manufacturer. INSTALLATION: Install insulation in accordance with manufacturer's recommendations, securely anchored, complete with all required fastenings and accessories. Vapor barrier: Orient to warm side of areas to be insulated. Joints: Butt tightly to form a continuous insulated layer free of voids or open space. Initials ------ Page 30 Initials ------ Do not install insulation until building is sufficiently enclosed or protected against absorption of moisture by the insulation, and do not install insulation unless supporting framing and surrounding construction is thoroughly dry. 07900 SEALANTS GENERAL: Seal exterior and interior joints to provide acoustical integrity. MATERIALS:

Examples of BLANKET INSULATION in a sentence

  • FINISHES NEW 5/8" FIRE BLOC GYP.BOARD SOUND INSULATION TYPE X WALL BOARD (EXTRA LAYER) NEW 20 GUAGE 3-5/8" METAL STUDS @ 16" O.C. W/ 3.5 SOUND BLANKET INSULATION BETWEEN (TYPICAL) NEW 3-5/8" CONT.

  • SROs will establish a trusting channel of communication with students, parents, and teachers and establish regular feedback opportunities.

  • THERMAL AND MOISTURE PROTECTION 136 12-7.01 INSULATION (GENERAL) 136 12-7.02 BATT AND BLANKET INSULATION 137 12-7.03 SINGLE PLY THERMOPLASTIC POLYOLEFIN (TPO) MEMBRANE ROOFING SYSTEM 139 12-7.04 THROUGH-PENETRATION FIRESTOPPING 143 12-7.05 CLAY TILE ROOFING 144 12-7.06 SHEET METAL FLASHING 145 12-7.07 ROOF SPECIALTIES 148 12-7.08 SEALANTS AND CAULKING 150 SECTION 12-8.

  • THE SCOPE OF THE WORK INCLUDES THE REMOVAL OF CONTAMINATED BLOWN-IN AND BLANKET INSULATION LOCATED WITHIN THE ATTIC SPACES OF THE STONE BUILDING.

  • THERMAL AND MOISTURE PROTECTION 110 7.01 INSULATION (GENERAL) 110 7.02 BATT AND BLANKET INSULATION.

  • THERMAL AND MOISTURE PROTECTION 141 12-7.01 WATER REPELLENT COATING 141 12-7.02 INSULATION (GENERAL) 141 12-7.03 BATT AND BLANKET INSULATION 142 12-7.04 THROUGH-PENETRATION FIRESTOPPING 144 12-7.05 METAL ROOFING 145 12-7.06 SHEET METAL FLASHING 149 12-7.07 SEALANTS AND CAULKING 151 SECTION 12-8.

  • THERMAL AND MOISTURE PROTECTION 106 12-7.01 WATER REPELLENT COATING 106 12-7.02 INSULATION (GENERAL) 106 12-7.03 BATT AND BLANKET INSULATION 107 12-7.04 RIGID WALL INSULATION 108 12-7.05 METAL ROOFING 109 12-7.06 SHEET METAL FLASHING 112 12-7.07 SEALANTS AND CAULKING 114 SECTION 12-8.

  • THE APPROXIMATE LIMITS OF THE BLANKET INSULATION ARE SHOWN IN THE ATTIC PLAN AND IS TYPICALLY LOCATED WITHIN THE RAFTERS OF THE CATHEDRAL CEILING AREAS.

  • THERMAL AND MOISTURE PROTECTION 73 12-7.01 WATER REPELLENT COATING 73 12-7.02 INSULATION (GENERAL) 74 12-7.03 BATT AND BLANKET INSULATION 75 12-7.04 PREFINISHED METAL SOFFIT AND SIDING 76 12-7.05 METAL ROOFING 79 12-7.06 SHEET METAL FLASHING 82 12-7.07 SKYLIGHTS 84 12-7.08 JOINT SEALANT 85 12-7.09 SEALANTS AND CAULKING 86 SECTION 12-8.

  • INSULATED WITH 2.2" THICK (R-6) FIBERGLASS BLANKET INSULATION WITH FOIL JACKETING UNLESS OTHERWISE NOTED.

Related to BLANKET INSULATION

  • Solid insulator means the insulating coating of wiring harnesses, provided in order to cover and prevent the high voltage live parts from any direct contact.

  • Perfluoroalkyl and polyfluoroalkyl substances or “PFAS” means a class of fluorinated organic chemicals containing at least one fully fluorinated carbon atom.

  • High global warming potential hydrofluorocarbons means any hydrofluorocarbons in a particular end use for which EPA’s Significant New Alternatives Policy (SNAP) program has identified other acceptable alternatives that have lower global warming potential. The SNAP list of alternatives is found at 40 CFR Part 82 subpart G with supplemental tables of alternatives available at (http://www.epa.gov/snap/).

  • Crawling bug insecticide means any insecticide product that is designed for use against ants, cockroaches, or other household crawling arthropods, including, but not limited to, mites, silverfish or spiders. “Crawling Bug Insecticide” does not include products designed to be used exclusively on humans or animals, or any house dust mite product. For the purposes of this definition only:

  • Diesel means a distillate oil which can be used as fuel for the operation of a compression ignition engine and which has an approximate boiling temperature of between 150 °C to 400 °C;

  • Boiler means an enclosed fossil or other fuel-fired combustion device used to produce heat and to transfer heat to recirculating water, steam, or other medium.

  • Floodproofing means any combination of structural and nonstructural additions, changes, or adjustments to structures which reduce or eliminate flood damage to real estate or improved real property, water and sanitation facilities, structures, and their contents.

  • Fluid means material or substance which flows or moves whether in a semisolid, liquid, sludge, gas, or any other form or state.

  • Impulsive sound means either a single pressure peak or a single burst (multiple pressure peaks) that has a duration of less than one second.

  • Flammable means a chemical that falls into one of the following categories:

  • Hydraulic lift tank means a tank holding hydraulic fluid for a closed-loop mechanical system that uses compressed air or hydraulic fluid to operate lifts, elevators, and other similar devices.

  • Encapsulation means the application of an encapsulant.

  • Polystyrene foam adhesive means an aerosol adhesive designed to bond polystyrene foam to substrates.

  • Plasma arc incinerator means any enclosed device using a high intensity electrical discharge or arc as a source of heat followed by an afterburner using controlled flame combustion and which is not listed as an industrial furnace.

  • Diameter means the diameter of the stem of a tree measured outside the bark at a specified point of measurement.

  • Explosive means a chemical compound, device, or mixture:

  • combustible waste means non-biodegradable, non- recyclable, non-reusable, non-hazardous solid waste having minimum calorific value exceeding 1500 kcal/kg and excluding chlorinated materials like plastic, wood pulp, etc.;

  • Flying bug insecticide means any insecticide product that is designed for use against flying insects or other flying arthropods, including but not limited to flies, mosquitoes, moths, or gnats. “Flying Bug Insecticide” does not include “wasp and hornet insecticide,” products that are designed to be used exclusively on humans or animals, or any moth-proofing product. For the purposes of this definition only, “moth-proofing product” means a product whose label, packaging, or accompanying literature indicates that the product is designed to protect fabrics from damage by moths, but does not indicate that the product is suitable for use against flying insects or other flying arthropods.

  • Explosives (1) means solid, liquid or gaseous substances or mixtures of substances which, in their application as primary, booster, or main charges in warheads, demolition and other applications, are required to detonate.

  • Chemical substance means a substance intended to be used as a precursor in the manufacture of a controlled substance or any other chemical intended to be used in the manufacture of a controlled substance. Intent under this subsection may be demonstrated by the substance's use, quantity, manner of storage, or proximity to other precursors or to manufacturing equipment.

  • Low-level radioactive waste or “waste” means radioactive material that consists of or contains class A, B, or C radioactive waste as defined by 10 C.F.R. 61.55, as in effect on January 26, 1983, but does not include waste or material that is any of the following:

  • Incinerator means any enclosed device that:

  • explosive actuated fastening device means a tool that is activated by an explosive charge and that is used for driving bolts, nails and similar objects for the purpose of providing fixing;

  • Fluoroscopic imaging assembly means a subsystem in which X-ray photons produce a visual image. It includes the image receptor(s) such as the image intensifier and spot-film device, electrical interlocks, if any, and structural material providing linkage between the image receptor and diagnostic source assembly.

  • Polystyrene foam means blown polystyrene and expanded and

  • Tank means an enclosed space which is formed by the permanent structure of a ship and which is designed for the carriage of liquid in bulk.