Daily Emissions definition

Daily Emissions means the amount of SO2 emitted in a calendar day, ex- pressed in pounds per day rounded to the nearest tenth (1⁄10) of a pound, where:Daily emissions = S 3-hour emissions within a calendar day.
Sample 1Sample 2Sample 3
Daily Emissions means the amount of SO2 emitted in a calendar day (expressed in tons per day) as determined in accordance with the matrix contained in Table 1 and utilizing Equation A-02. The following table provides a template for determining daily emissions for the Acid Plant Stack.
Sample 1

Examples of Daily Emissions in a sentence

  • Daily Emissions Limitations (DELs) and other enforceable conditions are required by Rule 2201 to restrict a unit’s maximum daily emissions, to a level at or below the emissions associated with the maximum design capacity.

  • Daily Emissions of SO2 from the CCOB stack shall not exceed those values set forth in the following Table 2b.

  • APPENDICESAppendix A – Glossary of TermsAppendix B – CalEEMod Model Daily Emissions Printouts Appendix C – CalEEMod Model Annual Emissions Printouts Table 1.

  • Therefore, public notice is required for this project.D. Daily Emissions Limits Daily Emissions Limitations (DELs) and other enforceable conditions are required by Section 3.15 to restrict a unit’s maximum daily emissions, to a level at or below the emissions associated with the maximum design capacity.

  • Emissions units for the base year inventory were tons per year, obtained as follows: Non-road Sector UnitsNon-road Engines and Motorized (5*Wkdy + 2*Wknd)/7 = Daily Emissions * 365.25 = Equipment (MOVES2014b) Tons per YearAircraft and Airport (January emissions) * (365.25/31) = Tons per Year Ground Support Equipment Diesel Locomotives 2017 Annual Emissions x Scaling Factors The CAMX model then converts the ton-per-year inventories back to tons per winter weekday and tons per winter weekend day.

  • Next, emissions units were converted to January daily and then ton-per-year emissions using the following equation:(5*Wkdy + 2*Wknd)/7 = Daily Emissions * 365.25 = Tons per Year Output was organized into “SMOKE” format and transferred to the CAMX air dispersion model for analysis of pollutant concentrations.

  • Daily Emissions Limits Daily Emissions Limitations (DELs) and other enforceable conditions are required by Rule 2201 to restrict a unit’s maximum daily emissions, to a level at or below the emissions associated with the maximum design capacity.

  • Table 4.2-4Mass Daily Emissions Thresholds Localized Significance ThresholdsThe local significance thresholds are based on the SCAQMD’s Final Localized Significance Threshold (LST) Methodology (LST Methodology)13 guidance document for short-duration construction activities.

  • Table (3)Maximum Daily Emissions Plant Cumulative Increase: (tons/year):The cumulative increase for new engine S-1 is as shown in Table (4).

  • Table 3Project Operational Emissions Emission SourceMaximum Daily Emissions (lbs/day) Cumulative short-term, construction-related emissions and long-term, operational emissions from the project would not contribute considerably to any potential cumulative air quality impact because short-term construction and long-term operational emissions would not exceed any SCAQMD daily threshold.

Related to Daily Emissions

  • PM10 emissions means PM10 emitted to the ambient air as measured by an applicable reference method, or an equivalent or alternate method, specified in 40 CFR Part 51, Appendix M as of December 8, 1984, or by a test method specified in these regulations or any supplement thereto.

  • Actual emissions means the actual rate of emissions in tpy of any regulated pollutant (for fee calculation) emitted from a Part 71 source over the preceding calendar year. Actual emissions shall be calculated using each emissions unit’s actual operating hours, production rates, in-place control equipment, and types of materials processed, stored, or combusted during the preceding calendar year.

  • Excess emissions - means an emission rate that exceeds any applicable emission limitation or standard allowed by any rule in Sections .0500, .0900, .1200, or .1400 of Subchapter 02D; or by a permit condition; or that exceeds an emission limit established in a permit issued under 15A NCAC 02Q .0700. (Note: Definitions of excess emissions under 02D .1110 and 02D .1111 shall apply where defined by rule.)

  • Evaporative emissions means in the context of this UN GTR the hydrocarbon vapours lost from the fuel system of a motor vehicle during parking and immediately before refuelling of a sealed fuel tank.

  • greenhouse gas emissions means emissions in terms of tonnes of CO2 equivalent of carbon dioxide (CO2), methane (CH4), nitrous oxide (N2O), hydrofluorocarbons (HFCs), perfluorocarbons (PFCs), nitrogen trifluoride (NF3) and sulphur hexafluoride (SF6) determined pursuant to Regulation (EU) No 525/2013 and falling within the scope of this Regulation;

  • Fugitive dust emissions means particulate matter from process operations that does not pass through a process stack or vent and that is generated within plant property boundaries from activities such as: unloading and loading areas, process areas, stockpiles, stock pile working, plant parking lots, and plant roads (including access roads and haul roads).

  • Baseline actual emissions means the rate of emissions, in tons per year, of a regulated NSR pollutant, as determined in accordance with paragraphs (i) through (iv) of this definition.

  • Nominal tomographic section thickness means the full width at half-maximum of the sensitivity profile taken at the center of the cross-sectional volume over which x-ray transmission data are collected.

  • Predictive emissions monitoring system or "PEMS" means all of the equipment necessary to monitor process and control device operational parameters (for example, control device secondary voltages and electric currents) and other information (for example, gas flow rate, O2 or CO2 concentrations), and calculate and record the mass emissions rate (for example, pounds per hour) on a continuous basis.

  • Fugitive emissions means those emissions which could not reasonably pass through a stack, chimney, vent, or other functionally equivalent opening.

  • Sewage treatment plant means any arrangement of devices and structures used for treating sewage.

  • Projected actual emissions means the maximum annual rate, in tons per year, at which an existing emissions unit is projected to emit a regulated NSR pollutant in any one of the 5 years (12-month period) following the date the unit resumes regular operation after the project, or in any one of the 10 years following that date, if the project involves increasing the emissions unit’s design capacity or its potential to emit that regulated NSR pollutant, and full utilization of the unit would result in a significant emissions increase, or a significant net emissions increase at the major stationary source.

  • Emissions means the total emissions in tCO2 equivalent for a target period; “EU ETS Directive” means Directive 2003/87/EC of the European Parliament and of the Council establishing a scheme for greenhouse gas emissions allowance trading within the Community and amending Council Directive 96/61/EC, as amended from time to time;1

  • Particulate matter emissions (PM) means the mass of any particulate material from the vehicle exhaust quantified according to the dilution, sampling and measurement methods as specified in this UN GTR.

  • Production, Use or Storage of Nuclear Material means the production, manufacture, enrichment, conditioning, processing, reprocessing, use, storage, handling and disposal of Nuclear Material.

  • Exhaust emissions means the emission of gaseous, solid and liquid compounds from the tailpipe.

  • Secondary emissions means emissions which occur as a result of the construction or operation of a major stationary source or major modification, but do not come from the major stationary source or major modification itself. For the purposes of this chapter, “secondary emissions” must be specific, well-defined, and quantifiable, and must impact the same general areas as the stationary source modification which causes the secondary emissions. “Secondary emissions” includes emissions from any offsite support facility which would not be constructed or increase its emissions except as a result of the construction or operation of the major stationary source or major modification. “Secondary emissions” does not include any emissions which come directly from a mobile source, such as emissions from the tailpipe of a motor vehicle, from a train, or from a vessel.

  • Line-voltage regulation means the difference between the no-load and the load line potentials expressed as a percent of the load line potential. It is calculated using the following equation:

  • emissions of substances not controlled by emission limits means emissions of substances to air, water or land from the activities, either from the emission points specified in schedule 3 or from other localised or diffuse sources, which are not controlled by an emission limit.

  • Low-level radioactive waste or “waste” means radioactive material that consists of or contains class A, B, or C radioactive waste as defined by 10 C.F.R. 61.55, as in effect on January 26, 1983, but does not include waste or material that is any of the following:

  • Day-ahead System Energy Price means the System Energy Price resulting from the Day- ahead Energy Market.

  • Market Participant Energy Injection means transactions in the Day-ahead Energy Market and Real-time Energy Market, including but not limited to Day-ahead generation schedules, real- time generation output, Increment Offers, internal bilateral transactions and import transactions, as further described in the PJM Manuals.

  • Visible emissions means any emissions, which are visually detectable without the aid of instruments, coming from RACM or asbestos-containing waste material, or from any asbestos milling, manufacturing, or fabricating operation. This does not include condensed, uncombined water vapor.

  • Pump spray means a packaging system in which the product ingredients within the container are not under pressure and in which the product is expelled only while a pumping action is applied to a button, trigger or other actuator.

  • Explosives or munitions emergency response means all immediate response activities by an explosives and munitions emergency response specialist to control, mitigate, or eliminate the actual or potential threat encountered during an explosives or munitions emergency. An explosives or munitions emergency response may include in-place render-safe procedures, treatment or destruction of the explosives or munitions and/or transporting those items to another location to be rendered safe, treated, or destroyed. Any reasonable delay in the completion of an explosives or munitions emergency response caused by a necessary, unforeseen, or uncontrollable circumstance will not terminate the explosives or munitions emergency. Explosives and munitions emergency responses can occur on either public or private lands and are not limited to responses at RCRA facilities.

  • Applicable Wages means the basic straight time wages for all hours worked, including: