Emission tests definition

Emission tests means any evaluations, inspections, observations, or tests designed to measure the quantity, rate, or concentration of emissions, including fuel analyses, analyses of raw materials, intermediate products, final products, or by-products, evaluations of air pollution control equipment, measurements of process parameters, or other factors that may affect emissions.
Sample 1Sample 2Sample 3
Emission tests has the meaning set forth in Section 12.1(b)(iii).
Sample 1Sample 2

Examples of Emission tests in a sentence

  • Emission tests related to this regulation shall be measured in accordance with the requirements of Chapter 3, Section 2(h)(iv).

  • Emission tests also may be required in accordance with 40 CFR Part 60, Appendix A, Methods 1-5 and the procedures specified in OAC rule 3745-17-03.

  • Emission tests or performance tests or both shall be conducted by the owner or operator of a facility and data reduced in accordance with the applicable procedure, limitations, standards, and test methods established by this article.

  • Emission tests shall be conducted under such conditions as the Air Pollution Control Officer shall specify.

  • Emission tests shall be conducted by independent testing consultants who have no conflict of interest and receive no financial benefit from the outcome of the testing.

  • Emission tests shall be conducted in a manner acceptable to and approved by the commissioner.

  • Emission tests were conducted in a stack located downstream of the induced draft fan for the flash drying system.

  • Emission tests shall be conducted according to the experimental procedures described by Environmental Protection Agency (EPA)- 600/8-89-074, Indoor Air Sources: Using Environmental Test Chambers to Characterize Organic Emissions from Indoor Materials and Products and ASTM Guide D5116-90.

  • Emission tests shall be performed on the emission-data vehicle or engine with at least 4,000 miles or 125 hours accumulated after the retrofit to stabilize emissions.

  • Emission tests can also be performed at intervals during the service accumulation test period, and applied in determining the deterioration trend.

Related to Emission tests

  • Emission control system means the electronic engine management controller and any emission related component in the exhaust or evaporative system which supplies an input to or receives an output from this controller.

  • Commissioning Tests means all of the procedures and tests which, in accordance with the Reasonable and Prudent Standard, and in compliance with industry guidelines, practices and standards, are:

  • Percolation test means a subsurface soil test at the depth of a proposed absorption system or similar component of an OWTS to determine the water absorption capability of the soil, the results of which are normally expressed as the rate at which one inch of water is absorbed. The rate is expressed in minutes per inch.

  • Emission Control Strategy means any device, system, or strategy employed with a diesel-fueled CI engine that is intended to reduce emissions. Examples of emission control strategies include, but are not limited to, particulate filters, diesel oxidation catalysts, selective catalytic reduction systems, alternative fuels, fuel additives used in combination with particulate filters, alternative diesel fuels, and combinations of the above.

  • Commissioning test means tests applied to the Generating Facility, after completion of the construction of the Generating Facility, in order to verify that the Generating Facility may be released for Operation.

  • Coverage Tests means each of the Overcollateralization Ratio Test and the Interest Coverage Ratio Test.

  • Stand-Alone Test Environment or "SATE" shall have the meaning set forth in Section 12.2.9.3.2.

  • Emission unit means any article, machine, equipment, operation, or contrivance that emits or has the potential to emit any federally regulated air pollutant.

  • Guarantee Test(s means the test(s) specified in the Technical Specifications to be carried out to ascertain whether the Facilities or a specified part thereof is able to attain the Functional Guarantees specified in the Technical Specifications in accordance with the provisions of GCC Sub-Clause 20.2.1 (Guarantee Test) hereof during/after successful Commissioning followed by Trial - Operation.

  • Phase I Environmental Site Assessment means a Phase I environmental property assessment of the Assets that satisfies the basic assessment requirements set forth under the current ASTM International Standard Practice for Environmental Site Assessments (Designation E1527-13) or any other visual site assessment or review of records, reports or documents.

  • Phase I Environmental Assessment A “Phase I assessment” as described in, and meeting the criteria of, the ASTM, plus a radon and asbestos inspection.

  • Emission Rate for a given pollutant means the number of pounds of that pollutant emitted per million British thermal units of heat input (lb/mmBTU), measured in accordance with this Consent Decree.

  • Processes with Significant Environmental Aspects means the Equipment which, during regular operation or if not properly operated or maintained, may cause or are likely to cause an adverse effect.

  • Collateral Quality Tests means the Collateral Quality Tests set out in the Investment Management Agreement being each of the following:

  • Emissions means the total emissions in tCO2 equivalent for a target period; “EU ETS Directive” means Directive 2003/87/EC of the European Parliament and of the Council establishing a scheme for greenhouse gas emissions allowance trading within the Community and amending Council Directive 96/61/EC, as amended from time to time;1

  • Materials of Environmental Concern any gasoline or petroleum (including crude oil or any fraction thereof) or petroleum products or any hazardous or toxic substances, materials or wastes, defined or regulated as such in or under any Environmental Law, including asbestos, polychlorinated biphenyls and urea-formaldehyde insulation.

  • Operating Environment means, collectively, the platform, environment and conditions on, in or under which the Software is intended to be installed and operate, as set forth in the Statement of Work, including such structural, functional and other features, conditions and components as hardware, operating software and system architecture and configuration.

  • Adverse Environmental Condition means (i) the existence or the continuation of the existence, of an Environmental Contamination (including, without limitation, a sudden or non-sudden accidental or non-accidental Environmental Contamination), of, or exposure to, any substance, chemical, material, pollutant, Hazardous Substance, odor or audible noise or other release or emission in, into or onto the environment (including without limitation, the air, ground, water or any surface) at, in, by, from or related to any Equipment, (ii) the environmental aspect of the transportation, storage, treatment or disposal of materials in connection with the operation of any Equipment, or (iii) the violation, or alleged violation, of any Environmental Law, permits or licenses of, by or from any governmental authority, agency or court relating to environmental matters connected with any of the Equipment.

  • COVID-19 test means a viral test for SARS-CoV-2 that is:

  • Generally applicable environmental radiation standards means standards issued by the U.S. Environmental Protection Agency (EPA) under the authority of the Atomic Energy Act of 1954, as amended, that impose limits on radiation exposures or levels, or concentrations or quantities of radioactive material, in the general environment outside the boundaries of locations under the control of persons possessing or using radioactive material.

  • Penetration Testing means security testing in which assessors mimic real-world attacks to identify methods for circumventing the security features of an application, system, or network. (NIST SP 800-115)

  • Environmental Conditions means the presence in the environment, including the soil, groundwater, surface water or ambient air, of any Hazardous Material at a level which exceeds any applicable standard or threshold under any Environmental Law or otherwise requires investigation or remediation (including, without limitation, investigation, study, health or risk assessment, monitoring, removal, treatment or transport) under any applicable Environmental Laws.

  • Initial Environmental Examination or “IEE” means the initial environmental examination for the Project, including any update thereto, prepared and submitted by the Borrower and cleared by ADB;

  • Coverage Test means each of the Class A/B Par Value Test, the Class A/B Interest Coverage Test, the Class C Par Value Test, the Class C Interest Coverage Test, the Class D Par Value Test, the Class D Interest Coverage Test, the Class E Par Value Test and the Class E Interest Coverage Test.

  • Drug use test means a scientifically substantiated method to test for the presence of illegal or performance-enhancing drugs or the metabolites thereof in a person’s urine.

  • Collateral Quality Test A test satisfied as of the Effective Date and any other date thereafter on which such test is required to be determined hereunder if, in the aggregate, the Collateral Obligations owned (or in relation to a proposed purchase of a Collateral Obligation, both owned and proposed to be owned) by the Issuer satisfy each of the tests set forth below (or, after the Effective Date, if any such test is not satisfied at the time of reinvestment, the level of compliance with such test is maintained or improved as described in the Investment Criteria):