We use cookies on our site to analyze traffic, enhance your experience, and provide you with tailored content.

For more information visit our privacy policy.

Equipment leaks definition

Equipment leaks means leaks from pumps, compressors, pressure relief devices, sampling connection systems, open-ended valves or lines, valves, connectors, agitators, accumulator vessels, and instrumentation systems.
Equipment leaks means leaks from pumps, compressors, pressure relief devices, sampling connection systems, open ended valves or lines, valves, connectors, agitators, accumulator vessels, and instrumentation systems in hazardous air pollutant service.
Equipment leaks means leaks from pumps, compressors, pressure relief devices, sampling connection systems, open-ended valves or lines, valves, connectors, agitators, accumulator vessels, and instrumentation systems.means the definition as “EPA reference method” as set forth in subrule 20.2.

Examples of Equipment leaks in a sentence

  • Equipment leaks from various components, including connectors, flanges, compressors, open ended lines, pump seals, and valves.

  • ExxonMobil shall test the PMA Process Unit for Equipment leaks in accordance with 40 CFR 60, Subpart GGG (ARM 17.8.340 and 40 CFR 60, Subpart GGG).

  • Equipment leaks also may be defined on the basis of visual observation of certain types of equipment.

  • One (1) EIQ should be completed for each of the following types of fugitive emissions sources or emissions points: Equipment leaks.

  • Section 63.640 is amended by revising paragraph (p)(2) to read as follows:§ 63.640 Applicability and designation of affected source.* * * * *(p) * * *(2) Equipment leaks that are also subject to the provisions of 40 CFR part 60, subpart GGGa, are required to comply only with the provisions specified in 40 CFR part 60, subpart GGGa, except that pressure relief devices in organic HAP service mustonly comply with the requirements in§ 63.648(j).* * * * *■ 3.

  • C Equipment leaks from valves, pump seals, flanges, compressors, sampling connections, open-ended lines, etc.;C Releases from building ventilation systems, such as a roof fan in an open room;C Evaporative losses from solvent cleaning tanks, surface impoundments, and spills; andC Emissions from any other fugitive or non-point sources.

  • Equipment leaks at existing and new PVC area sources are subject to the same standards and compliance requirements as major sources, as discussed in sections IV.E.2 and IV.F.2 of this preamble.

  • Equipment leaks from various equipment components, including connectors, flanges, pump seals, valves, separators, pressure relief devices, open end valves or lines, piping, etc.

  • Equipment leaks from transmission compressor stations were separated into two distinct categories because of differences in leakage characteristics: 1) station components including all sources associated with the station inlet and outlet pipelines, meter runs, dehydrators, and other piping located outside of the compressor building; and 2) compressor-related components including all sources physically connected or immediately adjacent to the compressors.

  • Equipment leaks from various equipment components, including connectors, flanges, pump seals, valves, pressure relief devices, and open end valves.

Related to Equipment leaks

  • Ancillary equipment means any device including, but not limited to, such devices as piping, fittings, flanges, valves, and pumps, that is used to distribute, meter, or control the flow of hazardous waste from its point of generation to a storage or treatment tank(s), between hazardous waste storage and treatment tanks to a point of disposal onsite, or to a point of shipment for disposal off-site.

  • Customer Equipment means hardware, software, systems, cabling and facilities provided by you and used in conjunction with the Equipment that we supply to you in order to receive the Services;

  • Aircraft means any machine that can derive support in the atmosphere from the reactions of the air other than the reactions of the air against the earth’s surface;

  • X-ray equipment means an x-ray system, subsystem, or component thereof. Types of x-ray equipment are as follows:

  • Original equipment manufacturer means a company that manufactures products that it has designed from purchased components and sells those products under the company's brand name.

  • Stand Alone System Upgrade Facilities means System Upgrade Facilities that a Developer may construct without affecting day-to-day operations of the New York State Transmission System during their construction. NYISO, the Connecting Transmission Owner and the Developer must agree as to what constitutes Stand Alone System Upgrade Facilities and identify them in Appendix A to this Agreement.