SAFETY CAP definition

SAFETY CAP means cap fitted on valve to prevent leaks and withstand pressure of 17 kg/cm2.
SAFETY CAP means a paper tube that is placed over the end of the fuse of an aerial shell to protect it from accidental ignition;
SAFETY CAP means cap fitted on valve to prevent leaks and withstand LPG

Examples of SAFETY CAP in a sentence

  • DISCONNECTED LP TANKS IN STORAGE OR BEING TRANSPORTED MUST HAVE A SAFETY CAP.

  • REMOVE SAFETY CAP FROM LANCET Gently unscrew gray safety cap from the lancet.

  • The certificates shall be issued in the following format to be printed on manufacturer’s stationery: TEST CERTIFICATE FOR SAFETY CAP FOR SC VALVE USED WITH LPG CYLINDERS Manufacturer’s Name & Address: Certificate No. : Date: Purchaser’s Name: Bharat Petroleum Corporation Ltd.

  • KEEP SAFETY KEY WITH YOU OR REPLACE SAFETY KEY AND SAFETY CAP ON LAUNCH ROD.

  • Even though several procurement forms are in regulation, agencies are permitted to modify the forms.35 Solicitation process Human services especially are subject to ever-changing federal and State laws which impact how providers deliver services.

Related to SAFETY CAP

  • Safety zone means the area officially set apart within a roadway for the exclusive use of

  • Normal Minimum Generation means the lowest output level of a generating resource under normal operating conditions.

  • Baseline actual emissions means the rate of emissions, in tons per year, of a regulated NSR pollutant, as determined in accordance with paragraphs (i) through (iv) of this definition.

  • Safety Requirements means Prudent Electrical Practices, CPUC General Order No. 167, Contractor Safety Program Requirements, and all applicable requirements of Law, PG&E, the Utility Distribution Company, the Transmission Provider, Governmental Approvals, the CAISO, CARB, NERC and WECC.

  • Biological safety cabinet means a containment unit suitable for the preparation of low to moderate risk agents where there is a need for protection of the product, personnel, and environment, according to National Sanitation Foundation (NSF) Standard 49.

  • Imminent safety hazard means an imminent and unreasonable risk of death or severe personal injury.

  • Safety Convention means the International Convention for the Safety of Life at Sea, 1974 (a copy of the English text of the articles of which, and of part of the annex to which, is set forth in Schedule 4), as affected by any amendment, other than an amendment objected to by Australia, made under Article VIII of that Convention and, after the date on which the Protocol of 1978 relating to the Safety Convention enters into force for Australia, as also affected by that Protocol;

  • Safety Standards means all laws, union rules and trade or industry custom or codes of any kind whatsoever, in effect from the date of this Agreement through Final Acceptance of the construction work, pertaining to worker safety and accident prevention applicable to the Project and/or the construction work (including, but not limited to, rules, regulations and standards adopted pursuant to the Occupational Safety and Health Act of 1970, as amended from time to time).

  • health and safety file means a file, or other record containing the information in writing required by these Regulations "health and safety plan" means a site, activity or project specific documented plan in accordance with the client's health and safety specification;

  • health and safety specification means a site, activity or project specific document prepared by the client pertaining to all health and safety requirements related to construction work;

  • Environmental, Health, and Safety Requirements means all federal, state, local and foreign statutes, regulations, ordinances and other provisions having the force or effect of law, all judicial and administrative orders and determinations, all contractual obligations and all common law concerning public health and safety, worker health and safety, and pollution or protection of the environment, including without limitation all those relating to the presence, use, production, generation, handling, transportation, treatment, storage, disposal, distribution, labeling, testing, processing, discharge, release, threatened release, control, or cleanup of any hazardous materials, substances or wastes, chemical substances or mixtures, pesticides, pollutants, contaminants, toxic chemicals, petroleum products or byproducts, asbestos, polychlorinated biphenyls, noise or radiation, each as amended and as now or hereafter in effect.

  • Occupational Safety and Health Law means any Legal Requirement designed to provide safe and healthful working conditions and to reduce occupational safety and health hazards, including the Occupational Safety and Health Act, and any program, whether governmental or private (such as those promulgated or sponsored by industry associations and insurance companies), designed to provide safe and healthful working conditions.

  • Health and Safety Laws means any Laws pertaining to safety and health in the workplace, including the Occupational Safety and Health Act, 29 U.S.C. 651 et seq. (“OSHA”), and the Toxic Substances Control Act, 15 U.S.C. 2601, et seq. (“TSCA”).

  • emission limit value means the mass, expressed in terms of certain specific parameters, concentration and/or level of an emission, which may not be exceeded during one or more periods of time;

  • Environmental, Health and Safety Liabilities means any cost, damages, expense, liability, obligation or other responsibility arising from or under Environmental Law or Occupational Safety and Health Law and consisting of or relating to:

  • Imminent danger to the health and safety of the public means the existence of any condition or practice, or any violation of a permit or other requirement of this chapter in a surface coal mining and reclamation operation, which condition, practice, or violation could reasonably be expected to cause substantial physical harm to persons outside the permit area before such condition, practice, or violation can be abated. A reasonable expectation of death or serious injury before abatement exists if a rational person, subjected to the same conditions or practices giving rise to the peril, would not expose the person's self to the danger during the time necessary for abatement.

  • Environmental, Health and Safety Laws means the Comprehensive Environmental Response, Compensation and Liability Act of 1980, the Resource Conservation and Recovery Act of 1976, and the Occupational Safety and Health Act of 1970, each as amended, together with all other laws (including rules, regulations, codes, plans, injunctions, judgments, orders, decrees, rulings, and charges thereunder) of federal, state, local, and foreign governments (and all agencies thereof) concerning pollution or protection of the environment, public health and safety, or employee health and safety, including laws relating to emissions, discharges, releases, or threatened releases of pollutants, contaminants, or chemical, industrial, hazardous, or toxic materials or wastes into ambient air, surface water, ground water, or lands or otherwise relating to the manufacture, processing, distribution, use, treatment, storage, disposal, transport, or handling of pollutants, contaminants, or chemical, industrial, hazardous, or toxic materials or wastes.

  • Flying bug insecticide means any insecticide product that is designed for use against flying insects or other flying arthropods, including but not limited to flies, mosquitoes, moths, or gnats. Flying bug insecticide does not include wasp and hornet insecticide, products that are designed to be used exclusively on humans or animals, or any moth-proofing product. For the purposes of this definition only, moth-proofing product means a product whose label, packaging, or accompanying literature indicates that the product is designed to protect fabrics from damage by moths, but does not indicate that the product is suitable for use against flying insects or other flying arthropods.

  • safety standard means the Code of Practice for the Wiring of Premises SANS 10142-1 incorporated in the Regulations;

  • Safety compliance facility means a licensee that is a commercial entity that receives marihuana from a marihuana facility or registered primary caregiver, tests it for contaminants and for tetrahydrocannabinol and other cannabinoids, returns the test results, and may return the marihuana to the marihuana facility.

  • Contract Minimum Investment Requirement means, with respect to the Project, investment by the Company and any Sponsor Affiliates of at least $4,000,000 in Economic Development Property subject (non-exempt) to ad valorem taxation (in the absence of this Fee Agreement).

  • Sustainability Structuring Agent means X.X. Xxxxxx Securities LLC, in its capacity as sustainability structuring agent hereunder.

  • Environmental, Health or Safety Requirements of Law means all Requirements of Law derived from or relating to foreign, federal, state and local laws or regulations relating to or addressing pollution or protection of the environment, or protection of worker health or safety, including, but not limited to, the Comprehensive Environmental Response, Compensation and Liability Act, 42 U.S.C. § 9601 et seq., the Occupational Safety and Health Act of 1970, 29 U.S.C. § 651 et seq., and the Resource Conservation and Recovery Act of 1976, 42 U.S.C. § 6901 et seq., in each case including any amendments thereto, any successor statutes, and any regulations or guidance promulgated thereunder, and any state or local equivalent thereof.

  • Safety Management System has the meaning given to it in the ISM Code.

  • Minimum Generation Emergency means an Emergency declared by the Office of the Interconnection in which the Office of the Interconnection anticipates requesting one or more generating resources to operate at or below Normal Minimum Generation, in order to manage, alleviate, or end the Emergency.

  • Normal Maximum Generation means the highest output level of a generating resource under normal operating conditions.