Test 1 definition

Test 1. The index value for the current year falls outside the UCL or LCL.
Sample 1Sample 2Sample 3
Test 1 means the application of Moody’s CDOROM Test 1 via Input No. 2.
Sample 1Sample 2Sample 3
Test 1. Reference test to determine FABS and aABS. 3.1.1. The reference values FABS and aABS shall be determined in accordance with the procedure described in Appendix 4 to this annex.
Sample 1Sample 2

Examples of Test 1 in a sentence

  • To be classified as a supporting organization, an organization must meet one of three relationship tests: Test 1: “Operated, supervised, or controlled by” one or more publicly supported organizations, orTest 2: “Supervised or controlled in connection with” one or more publicly supported organizations, orTest 3: “Operated in connection with” one or more publicly supported organizations.

  • The table below identifies the MEGs that are used for Hypothetical Budget Neutrality Test 1.

  • When countable gross nonexempt earned and unearned income exceeds 185 percent of the schedule of living costs (Test 1), as identified at subrule 75.58(2) for the eligible group, eligibility does not exist under any coverage group for which these income tests apply.

  • Test 1: time evolution of the I-front position rI with respect to the Stro¨mgen radius rS (bottom panel) and the analytical solution (top panel).

  • We repeat Test 1 dropping the OTS approximation used in I06 and including now the full RT of diffuse photons produced by hydrogen recombinations.

  • In particular we use the same initial condition of Test 1 changing the original grid with three nested, concentric grids with 643 cells, corresponding to two levels of refinement (with a factor of 2 and 4 increased resolution with respect to the base mesh).

  • In this test we use the same parameters of Test 1, but now the ionizing source has a 105 K blackbody spectrum and we allow the gas temperature to evolve.

  • Test 1: spherically averaged ionized (x) and neutral (1 x) fraction profiles at times t 30 Myr (top panel) and t 500 Myr (bottom panel).

  • For instance, in the classical Stro¨mgren sphere situation with a monochromatic source (see Test 1 below), the regime where the OTS approximation may hold corresponds to regions where the directional flux from the central source is not able to penetrate, i.e. only at the extreme edge of the Stro¨mgren sphere.

  • Each of the three tests is discussed below: Test 1: Commonly Controlled Group‌ Section 71.255(1)(c), Wis.


More Definitions of Test 1

Test 1. The point of impact shall be as defined in paragraphs
Sample 1
Test 1. You do at least three of the following.
Sample 1
Test 1 test to be performed considering the EBITDA of the last twelve (12) consecutive months of said verification date; and
Sample 1

Related to Test 1

  • Test cycle means a sequence of test points each with a defined speed and torque to be followed by the engine under steady state (WHSC) or transient operating conditions (WHTC).

  • Test Fail has the meaning stated in Section 3.4(a).

  • Test Plan means a plan for the Testing of the or Deliverables and other agreed criteria related to the achievement of Milestones as described further in paragraph 4 of Call Off Schedule 4;

  • Test Issue means any variance or non-conformity of the Goods and/or Services or Deliverables from their requirements as set out in the Call Off Contract;

  • Critical Test Concentration or "(CTC)" means the specified effluent dilution at which the Permittee is to conduct a single-concentration Aquatic Toxicity Test.

  • Test Facility means any WRAS suitably accredited test laboratory;

  • Test means such test as is prescribed by the particulars or considered necessary by the Inspecting Officer whether performed or made by the Inspecting Officer or any agency acting under the direction of the Inspecting Officer;

  • Test Pass has the meaning stated in Section 3.4(a).

  • Test Report means a written report issued by The Sequoia Project that documents the outcomes of the Testing Process; that is, the Applicant’s compliance with the Specifications and Test Materials.

  • Test Complete has the meaning stated in Section 3.4(c).

  • COVID-19 test means a viral test for SARS-CoV-2 that is:

  • RDDS test Means one query sent to a particular “IP address” of one of the servers of one of the RDDS services. Queries shall be about existing objects in the Registry System and the responses must contain the corresponding information otherwise the query will be considered unanswered. Queries with an RTT 5 times higher than the corresponding SLR will be considered as unanswered. The possible results to an RDDS test are: a number in milliseconds corresponding to the RTT or undefined/unanswered.

  • S&P CDO Monitor Test A test that will be satisfied on any date of determination (following receipt, at any time on or after the S&P CDO Monitor Election Date, by the Issuer and the Collateral Administrator of the Class Break-even Default Rates for each S&P CDO Monitor input file (in accordance with the definition of “Class Break-even Default Rate”)) if, after giving effect to a proposed sale or purchase of an additional Collateral Obligation, the Class Default Differential of the Highest Ranking Class of the Proposed Portfolio is positive. The S&P CDO Monitor Test will be considered to be improved if the Class Default Differential of the Proposed Portfolio that is not positive is greater than the corresponding Class Default Differential of the Current Portfolio.

  • 2 Wire Analog Voice Grade Loop or “Analog 2W” provides an effective 2-wire channel with 2-wire interfaces at each end that is suitable for the transport of analog Voice Grade (nominal 300 to 3000 Hz) signals and loop-start signaling. This Loop type is more fully described in Verizon Technical Reference (TR)-72565, as revised from time-to-time. If “Customer-Specified Signaling” is requested, the Loop will operate with one of the following signaling types that may be specified when the Loop is ordered: loop-start, ground-start, loop- reverse-battery, and no signaling. Customer specified signaling is more fully described in Verizon TR-72570, as revised from time-to- time. Verizon will not build new facilities.

  • Test Well means a well constructed for the purpose of obtaining information needed to design a well prior to its construction. Test wells are cased and can be converted to observation or monitoring wells and under certain circumstances to production wells

  • Test Strategy means a strategy for the conduct of Testing as described further in paragraph 3 of Call Off Schedule 5 (Testing);

  • Test Date means, with respect to any Start Date, the last day of the most recent fiscal quarter of the Borrower ended immediately prior to such Start Date.

  • Drug test means a test designed to detect the illegal use of a controlled substance.

  • DNS test Means one non-­‐recursive DNS query sent to a particular “IP address” (via UDP or TCP). If DNSSEC is offered in the queried DNS zone, for a query to be considered answered, the signatures must be positively verified against a corresponding DS record published in the parent zone or, if the parent is not signed, against a statically configured Trust Anchor. The answer to the query must contain the corresponding information from the Registry System, otherwise the query will be considered unanswered. A query with a “DNS resolution RTT” 5 times higher than the corresponding SLR, will be considered unanswered. The possible results to a DNS test are: a number in milliseconds corresponding to the “DNS resolution RTT” or, undefined/unanswered.

  • Acceptance Test Document means a document, which defines procedures for testing the functioning of installed system. The document will be finalized with the contractor within 7 days of issuance of the Letter of Award.

  • Screening Test Technician (STT) means anyone who instructs and assists individuals in the alcohol testing process and operates an ASD.

  • Cannabis testing facility means an entity registered by

  • Baseline means the “Initial Small Business Lending Baseline” set forth on the Initial Supplemental Report (as defined in the Definitive Agreement), subject to adjustment pursuant to Section 3(a).

  • Accrual Components As specified in the Preliminary Statement.

  • MSAA Indicator Technical Specifications document means, as the context requires, either or both of the document entitled “Multi-Sector Service Accountability Agreement (MSAA) 2019-20 Indicator Technical Specifications November 5, 2018 Version 1.3” and the document entitled “Multi-Sector Service Accountability Agreement (MSAA) 2019-20 Target and Corridor-Setting Guidelines” as they may be amended or replaced from time to time;

  • Vehicle measuring attitude means the position of the vehicle as defined by the co-ordinates of fiducial marks in the three-dimensional reference system.