Control panel. Control panel consisting of: The main switch, safety thermostat button, the display, the group command buttons (buttons), a group of light-emitting diode pointer - ON-OFF Pellet/ +: If pushed for five seconds it switches on the system goes in ON/OFF Pellet If pushed in Menu it increments a parameter’s value. - ON-OFF Wood/ -: If pushed for five seconds it switches on the system goes in ON/OFF Wood If pushed in Menu it decrements a parameter’s value. - SET/Auger: If you keep this button pushed when the system si Off it activates a manual load of the auger. During this procedure you will see “LoAd” on the Display. The manual load procedure ends when you release the button. If pushed in Menu it changes the visualization from parameter’s code to parameter’s value and it permits to save a new setting. -ESC/Menu: This button allows to enter/exit the Menu. If you are changing a setting and you push this button you will exit without saving the new value. In OFF or Extinguishing state you can reset an Alarm visualization by pushing (+) or (-) button, but if the alarm were still there you would visualize it again.
