Additional Requirements and Exceptions For Spousal Consent Sample Clauses

Additional Requirements and Exceptions For Spousal Consent. Notwithstanding subparagraph (7) above, a Spouse’s consent will not be required if there is no Spouse, if the Spouse cannot be located, or if there are other circumstances (as set forth in the Code or Regulations) which preclude the necessity of such Spouse’s consent. Any consent by a Participant’s Spouse (or establishment that consent cannot be obtained) will be effective only with respect to such Spouse. A consent that permits designations by the Participant without any requirement of further Spousal consent must acknowledge that the Spouse has the right to limit consent to a specific Beneficiary, and a specific form of benefit where applicable, and that the Spouse voluntarily elects to relinquish either or both of such rights. A revocation of a prior election may be made by a Participant without the Spouse’s consent at any time before benefits begin. No Spouse’s consent obtained under subparagraph (7) will be valid unless the Participant has received notice as provided in subparagraph (4) above.
AutoNDA by SimpleDocs

Related to Additional Requirements and Exceptions For Spousal Consent

  • Additional Requirements for Sleeping Rooms The Contractor shall provide departing Attendees a secured area for storing belongings.

  • Certain State Law Requirements for Contracts The contents of this Section are required by Texas Law and are included by County regardless of content. For purposes of Sections 2252.152, 2271.002, and 2274.002, Texas Government Code, as amended, C&T hereby verifies that C&T and any parent company, wholly owned subsidiary, majority-owned subsidiary, and affiliate: a. Unless affirmatively declared by the United States government to be excluded from its federal sanctions regime relating to Sudan or Iran or any federal sanctions regime relating to a foreign terrorist organization, is not identified on a list prepared and maintained by the Texas Comptroller of Public Accounts under Sections 806.051, 807.051, or 2252.153 of the Texas Government Code. b. If employing ten (10) or more full-time employees and this Agreement has a value of

  • CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “ (1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “ (1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.

  • Reservations and Exceptions 1. Articles 3, 4, 6 and 12 shall not apply to: (a) Any existing non-conforming measure that is maintained by: (i) With respect to Japan: (A) The central government or a prefecture, as set out in its Schedule in Annex I; or (B) A local government other than prefectures; (ii) With respect to the Republic of Peru: (A) The central government or a regional government, as set out in its Schedule in Annex I; or (B) A local government (b) The continuation or prompt renewal of any non-conforming measure referred to in subparagraph (a); or (c) An amendment or modification to any non-conforming measure referred to in subparagraph (a), provided that the amendment or modification does not decrease the conformity of the measure as it existed immediately before the amendment or modification, with Articles 3, 4, 6 and 12. 2. Articles 3, 4, 6 and 12 shall not apply to any measure that a Contracting Party adopts or maintains with respect to sectors, sub-sectors and activities set out in its Schedule in Annex II. 3. Neither Contracting Party shall, under any measure adopted after the date of entry into force of this Agreement and covered by its Schedule in Annex II, require an investor of the other Contracting Party, by reason of its nationality, to sell or otherwise dispose of an investment that exists at the time the measure becomes effective. 4. In cases where a Contracting Party makes an amendment or a modification to any existing non-conforming measure set out in its Schedule in Annex I or where a Contracting Party adopts any new or more restrictive measure with respect to sectors, sub-sectors or activities set out in its Schedule in Annex II after the entry into force of this Agreement, the Contracting Party shall, prior to the implementation of the amendment or modification or the new or more restrictive measure, or in exceptional circumstances, as soon as possible thereafter: (a) Notify the other Contracting Party of detailed information on such amendment, modification or measure; and (b) Hold, upon request by the other Contracting Party, consultations in good-faith with that other Contracting Party. 5. Each Contracting Party shall endeavour, where appropriate, to reduce or eliminate the reservations specified in its Schedules in Annexes I and II respectively. 6. Articles 3, 4, 6 and 12 shall not apply to any measure covered by the exceptions to, or derogations from, obligations under Articles 3 and 4 of the TRIPS Agreement, as specifically provided in Articles 3 through 5 of the TRIPS Agreement. 7. Articles 3, 4, 6 and 12 shall not apply to any measure that a Contracting Party adopts or maintains with respect to government procurement.

  • Compliance with Federal and State Work Authorization and Immigration Laws The Contractor and all subcontractors, suppliers and consultants must comply with all federal and state work authorization and immigration laws, and must certify compliance using the form set forth in Section 7 (“Georgia Security and Immigration Compliance Act Affidavits”). The required certificates must be filed with the Owner and copied maintained by the Contractor as of the beginning date of this contract and each subcontract, supplier contract, or consultant contract, and upon final payment to the subcontractor or consultant. State officials, including officials of the Georgia Department of Audits and Accounts, officials of the Owner, retain the right to inspect and audit the Project Site and employment records of the Contractor, subcontractors and consultants without notice during normal working hours until Final Completion, and as otherwise specified by law and by Rules and Regulations of the Georgia Department of Audits and Accounts.

  • Attachment C, Standard State Provisions for Contracts and Grants Attachment C is hereby deleted in its entirety and replaced by the Attachment C December 15, 2017 attached to this Amendment. Child Support (Applicable to natural persons only; not applicable to corporations, partnerships or LLCs). Contractor is under no obligation to pay child support or is in good standing with respect to or in full compliance with a plan to pay any and all child support payable under a support order as of the date of this amendment.

  • Certain Notifications and Required Actions After the date of this Agreement, the Company shall promptly advise the Representative in writing of: (i) the receipt of any comments of, or requests for additional or supplemental information from, the Commission; (ii) the time and date of any filing of any post-effective amendment to the Registration Statement or any amendment or supplement to any preliminary prospectus, the Time of Sale Prospectus, the Prospectus or the Exchange Act Registration Statement; (iii) the time and date that any post-effective amendment to the Registration Statement becomes effective; and (iv) the issuance by the Commission of any stop order suspending the effectiveness of the Registration Statement or any post-effective amendment thereto or any amendment or supplement to any preliminary prospectus, the Time of Sale Prospectus, the Prospectus or the Exchange Act Registration Statement or of any order preventing or suspending the use of any preliminary prospectus, the Time of Sale Prospectus, or the Prospectus, or of any proceedings to remove, suspend or terminate from listing or quotation the Units from any securities exchange upon which they are listed for trading or included or designated for quotation, or of the threatening or initiation of any proceedings for any of such purposes. If, at any time, the Commission shall enter any such stop order, the Company will use its best efforts to obtain the lifting of such order at the earliest possible moment. Additionally, the Company agrees that it shall comply in all material respects with all applicable provisions of Rule 424(b), Rule 433 and Rule 430A under the Securities Act and will use its reasonable efforts to confirm that any filings made by the Company under Rule 424(b) or Rule 433 were received in a timely manner by the Commission.

  • Limitations and Exceptions Members shall confine limitations or exceptions to exclusive rights to certain special cases which do not conflict with a normal exploitation of the work and do not unreasonably prejudice the legitimate interests of the right holder.

  • Please see the current Washtenaw Community College catalog for up-to-date program requirements Conditions & Requirements

  • Notice Requirements and Commencement of Leave (1) An employee who requests parental leave for the adoption or caring of a child shall be required to provide proof of adoption or birth of the child. (2) An employee shall provide written notice, at least four (4) weeks in advance, of the intended commencement date of the maternity and/or parental leave. (In the case of adoption of a child, the employee shall provide as much notice as possible.) (3) The Employer may require a pregnant employee to commence maternity leave where the duties of the employee cannot reasonably be performed because of the pregnancy. In such cases the employee's previously scheduled leave period will not be affected. (4) An employee on maternity leave or parental leave shall provide four (4) weeks' notice prior to the date the employee intends to return to work. (5) An employee who wishes to return to work within six (6) weeks following the actual date of the birth may be required to provide a certificate from a medical practitioner stating the employee is able to return to work. (6) Where a pregnant employee gives birth before requesting maternity leave or before commencing maternity leave, her maternity leave will be deemed to have started on the date she gave birth.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!