LOST, STOLEN OR DAMAGED CARDS If the Cardmember loses the Card or if the Card is damaged or stolen or if the PIN became available to any other persons, the Cardmember must immediately inform AEME by telephone. In addition, the Cardmember shall provide AEME with a written notification within 3 days from the date of the occurrence of any of the above listed events, as per applicable laws. All notices pursuant to this article must be sent to the following address: AMEX (Middle East) B.S.C. (c), P.O. Box 5990, Manama, Kingdom of Bahrain. Or facsimile number: (+000) 00 000000. To inform AEME by phone, call the number indicated in the Cardmember Additional Information Leaflet. If AEME is duly informed in the manner described above the Cardmember shall not be liable for any Charges made on his or her Card by any third parties after the Card has been reported lost or stolen. Failure to comply with the provisions of this article will render the Cardmember liable for all Transactions made on his or her lost or stolen Card until the time the Card is reported as lost or stolen to AEME. However, the Cardmember shall at all times be fully liable for all Charges including Cash Withdrawals even if these Charges were made by third parties if these third parties gained possession of the Card or any Supplementary Card or the PIN with the knowledge, permission, approval or other acts of the Cardmember or any Supplementary Cardmember or because of their negligence. If the Card is found after it was reported lost or stolen, the Cardmember may not use or attempt to use the Card at issue and shall immediately inform AEME which will take the appropriate action.
Product Warranty Claims When we receive a valid warranty claim for an HP hardware or software product, HP will either repair the relevant defect or replace the product. If HP is unable to complete the repair or replace the product within a reasonable time, Customer will be entitled to a full refund upon the prompt return of the product to HP (if hardware) or upon written confirmation by Customer that the relevant software product has been destroyed or permanently disabled. HP will pay for shipment of repaired or replaced products to Customer and Customer will be responsible for return shipment of the product to HP.
Compensation for Damage or Loss (1) When investments made by investors of either Contracting Party suffer damage or loss owing to war or other armed conflict, a state of national emergency, revolt, civil disturbances, insurrection, riot or other similar events in the territory of the other Contracting Party, they shall be accorded by the latter Contracting Party, treatment, as regards restitution, indemnification, compensation or other settlement, not less favourable than that the latter Contracting Party accords to its own investors or investors of any third state, whichever is the most favourable.
System Upgrade Facilities and System Deliverability Upgrades Connecting Transmission Owner shall design, procure, construct, install, and own the System Upgrade Facilities and System Deliverability Upgrades described in Appendix A hereto. The responsibility of the Developer for costs related to System Upgrade Facilities and System Deliverability Upgrades shall be determined in accordance with the provisions of Attachment S to the NYISO OATT.
Returns, Damaged or Defective Goods Our policy in relation to Returns, Damaged or Defective Goods shall be as specified in Our standard Terms and Conditions for the supply of Goods and Services. We shall not accept returns for change of mind or if You make a wrong decision unless due to our negligence or incorrect information supplied by Ourselves. Copyright and Trademarks The contents of this Website are at all times the copyright or trademark property of either Ourselves, Our suppliers or linked third parties and You may not distribute, reproduce, display, publish any trademark or other content of this Website for any purpose whatsoever without the prior written approval of Us, Our suppliers or linked third parties (each as applicable). Furthermore You agree to indemnify Us against any claims, costs, damages or losses incurred by Us should You fail to comply with this clause. Advertisers and Linked Sites The display on Our Website of any advertiser or the provision of a link to third party Websites does not constitute Our endorsement of either the advertiser or third party provider or any of their Website content or business practices. As We do not have any control of the content of any third party Websites, access to such Websites is at Your sole risk and We recommend that You thoroughly review the terms and conditions of use and the Privacy policies of any third party Website immediately once You access such a Website. We shall accept no liability in regards to any dealings, promotions or activities between Yourself and advertisers or third party providers. Specifications and Information Specifications and information provided on this Website are given in good faith based on Our knowledge, experience, or information provided to Us by manufacturers and/or suppliers, or derived from sources believed to be accurate at the time the information is received by Us, therefore it is recommended if You have any concerns as to the suitability of Goods or Services provided through this Website in respect of the use of the Goods or Services or their suitability for a particular use that You contact Us or seek external professional opinion. You acknowledge and accept that colours of items displayed on the Website may not reflect the true and actual colour of such items as this may be affected by external influences such as the quality of images supplied to Us for use, or the quality, age or settings on Your monitor. If colour is a major factor in Your decision making We recommend You contact Us before purchase. On-Line Ordering Display on this Website does not guarantee the availability of any particular Good(s) therefore all orders placed through this Website shall be subject to confirmation of acceptance by Us. Orders for Services shall be subject to confirmation of suitable timeframes between You and Ourselves for provision of the Services. Continuous Service Due to the inherent nature of Websites We cannot guarantee uninterrupted or continuous availability of this Website and You accept that the Website may also be unavailable from time to time for maintenance or scheduled upgrades. Where able We shall give You advanced warning of the same. We shall accept no liability in relation to Website downtime whether scheduled or otherwise.
Packet Switching Capability 4.5.1 The packet switching capability network element is defined as the function of routing or forwarding packets, frames, cells or other data units based on address or other routing information contained in the packets, frames, cells or other data units.
DATA LOSS The Company does not accept responsibility for the security of Your account or content. You agree that Your use of the Website or Services is at Your own risk.
OUR RESPONSIBILITY FOR LOSS OR DAMAGE SUFFERED BY YOU 14.1 We are responsible to you for foreseeable loss and damage caused by us. If we fail to comply with this Agreement, we are responsible for loss or damage you suffer that is a foreseeable result of our breaking this Agreement or our failure to use reasonable care and skill, but we are not responsible for any loss or damage that is not foreseeable. Loss or damage is foreseeable if either it is obvious that it will happen, or if, at the time the Agreement is made, both we and you knew it might happen. We are not responsible for any loss or damage you suffer which is a result of you breaking this Agreement or you acting fraudulently.
System defects In the event you become aware of a material defect, malfunction or virus in the System or in an Electronic Service, you will immediately notify us of such defect, malfunction or virus and cease all use of such Electronic Service until you have received permission from us to resume use.
Authorized User Overview and Mini-Bid Process Project Based IT Consulting Services Contracts enable Authorized Users to use a competitive Mini-bid Process to acquire Services on an as-needed basis, for qualified IT Projects. Project Based IT Consulting Services may include, but will not be limited to projects requiring: analysis, data classification, design, development, testing, quality assurance, security and associated training for Information Technology based applications. See section 1.3 Out of Scope Work for a listing of projects expressly excluded from the scope of this Contract. An Authorized User Agreement for Project Based IT Consulting Services will be governed first by the terms and conditions specified in the OGS Centralized Contract and second by terms and conditions added to the Authorized User Statement of Work. Additional terms and conditions shall not conflict with or modify the terms and conditions of the OGS Centralized Contract. NYS Executive Agencies must adhere to all internal processes and approvals including, as required, approval from NYS Office of Information Technology Services. Other Authorized Users must adhere to their own internal processes and approvals. In accordance with Appendix B, section 28, Modification of Contract Terms, an Authorized User may add additional required terms and conditions to this Mini-Bid and resultant Authorized User Agreement only if such terms and conditions (1) are more favorable to the Authorized User and (2) do not conflict with or supersede the OGS Centralized Contract terms and conditions. Examples of additional terms and conditions include: • Expedited delivery timeframe; • Additional incentives, such as discount for expedited payment/Procurement Card use; and • Any additional requirements imposed by the funding source or Federal law.
