Employment and Training Administration The ratio of trainees to journeymen on the job site shall not be greater than permitted under the plan approved by the Employment and Training Administration. Every trainee must be paid at not less than the rate specified in the approved program for the trainee's level of progress, expressed as a percentage of the journeyman hourly rate specified in the applicable wage determination. Trainees shall be paid fringe benefits in accordance with the provisions of the trainee program. If the trainee program does not mention fringe benefits, trainees shall be paid the full amount of fringe benefits listed on the wage determination unless the Administrator of the Wage and Hour Division determines that there is an apprenticeship program associated with the corresponding journeyman wage rate on the wage determination which provides for less than full fringe benefits for apprentices. Any employee listed on the payroll at a trainee rate who is not registered and participating in a training plan approved by the Employment and Training Administration shall be paid not less than the applicable wage rate on the wage determination for the classification of work actually performed. In addition, any trainee performing work on the job site in excess of the ratio permitted under the registered program shall be paid not less than the applicable wage rate on the wage determination for the work actually performed. In the event the Employment and Training Administration withdraws approval of a training program, the contractor will no longer be permitted to utilize trainees at less than the applicable predetermined rate for the work performed until an acceptable program is approved.
Training and Education SECTION 1 – Law Enforcement Supervisors’ Training
Apprenticeship Requirements The Contractor shall comply with Section 230.1(A), California Code of Regulations as required by the Department of Industrial Relations, Division of Apprenticeship Standards by submitting DAS Form to the Joint Apprenticeship Committee of the craft or trade in the area of the site.
Employment of Apprentices 1. Where either the prime AGREEMENT or the subagreement exceeds thirty thousand dollars ($30,000), the CONSULTANT and any subconsultants under him or her shall comply with all applicable requirements of Labor Code §§ 1777.5, 1777.6 and 1777.7 in the employment of apprentices. 2. CONSULTANTs and subconsultants are required to comply with all Labor Code requirements regarding the employment of apprentices, including mandatory ratios of journey level to apprentice workers. Prior to commencement of work, CONSULTANT and subconsultants are advised to contact the DIR Division of Apprenticeship Standards website at xxxxx://xxx.xxx.xx.xxx/das/, for additional information regarding the employment of apprentices and for the specific journey-to- apprentice ratios for the AGREEMENT work. The CONSULTANT is responsible for all subconsultants’ compliance with these requirements. Penalties are specified in Labor Code §1777.7.
APPRENTICES 6.36.1 The Contractor acknowledges and agrees that, if this Contract involves a dollar amount greater than or a number of working days greater than that specified in Labor Code Section 1777.5, this Contract is governed by the provisions of Labor Code Section 1777.5. It shall be the responsibility of the Contractor to ensure compliance with this Article and with Labor Code Section 1777.5 for all apprenticeable occupations. 6.36.2 Pursuant to Labor Code Section 1777.5 if that Section applies to this Contract as indicated above, the Contractor and any subcontractors under him employing workers in any apprenticeable craft or trade in performing any work under this Contract shall apply to the applicable joint apprenticeship committee for a certificate approving the Contractor or subcontractor under the applicable apprenticeship standards and fixing the ratio of apprentices to journeymen employed in performing the work. 6.36.3 Pursuant to Labor Code Section 1777.5 if that Section applies to this Contract as indicated above, he Contractor and any subcontractor under him may be required to make contributions to the apprenticeship program. 6.36.4 The Contractor and all subcontractors under him shall comply with Labor Code Section 1777.6 which Section forbids certain discriminatory practices in the employment of apprentices.
Industrial Relations Training Leave Union Delegate/Employee Representative shall have access to industrial relations training in accordance with Appendix E hereof.
Training and Orientation (a) No employee shall be required to work on any job or operate any piece of equipment until he/she has received proper training and instruction. (b) The Employer shall provide sufficient and adequate training and/or orientation to any employee working in a new or unfamiliar work area or position.
Apprentice Wages (a) Apprentices’ rates of pay are set out in Appendix B which includes the description of the calculations.
Apprenticeship 7.01 At such time, the parties agree to a training program, it is agreed to contact the California Nevada JATC to establish such program.
TRAINING AND RELATED MATTERS The parties recognise that in order to increase the efficiency and productivity of the company a significant commitment to structured training and skill development is required. Accordingly the parties commit themselves to: a) The parties to this Agreement recognise the importance of the apprenticeship system to the construction industry. It is agreed that every employer party to this Agreement who employs five (5) or more tradespersons in any one classification shall undertake to employ at least one (1) apprentice or make arrangements to host an apprentice from an agreed group apprenticeship scheme. Where an employer does not currently have an apprentice as per this provision, reasonable time shall be allowed to enable the employer to comply with this clause. Further, the parties are committed to a strong ratio of apprentices in the industry. Apprenticeship levels on a specific project may be discussed at the Project Pre-Commencement Conference (refer Clause 16). b) Providing employees with the opportunity to acquire additional skills within relevant career path structures through appropriate structured training based on nationally endorsed (i.e. Construction Training Australia endorsed) competency standards and curriculum; c) Actively encouraging employees to seek formal recognition of their skills (i.e. recognition of prior learning); and d) Using training providers accredited and acceptable to the parties. The CFMEU, MBAV and other employer associations are legitimately engaged in providing training to industry and it is hereby agreed that all parties will properly recognise and accept the validity of nationally accredited training as provided by the other parties. e) The parties will consult on the development of training programs which are consistent with the following: • Training provided will be consistent with the company’s business requirements, relevant to the work of the employees, consistent with the skills development of each employee and with applicable national competency standards. • Training may be taken either on or off the job with all reasonable steps being taken to conduct training in normal working hours. • If an approved training activity is undertaken during ordinary working hours, the employee/s concerned shall not suffer any loss of pay. • Approved training activities undertaken outside of ordinary hours will be paid at single time or will, at the employee’s option, be taken as time off in lieu of payment. Provided that the scheduling of time off must be consistent with the needs of the business and be by agreement with the company. • Training costs of courses approved by the company will be met by the company. • The company will not be asked to meet the costs of training undertaken by employees which was not approved by the company. • Leave of absence granted pursuant to this clause shall count as service for all purposes of the award and this agreement. • Accredited members of the union will be allowed up to 5 days per year, without loss of pay, to attend trade union educational courses conducted or approved by the union. (see appendix H) f) The parties to this Agreement recognise the importance of the role that Apprentices/Trainees fulfill within the industry and, more importantly, a role that they will fulfill as trades persons following the conclusion of the indentures. To this end the Victorian Building Industry Consultative Committee will investigate ways of enhancing employment prospects for Apprentice/Trainees. In addition it is agreed that, where appropriate, employers will use their best endeavours to employ Apprentices/Trainees in order to ensure appropriate trade persons levels for the future.