Backfilling of trenches Sample Clauses

Backfilling of trenches. C2.1.11.1 Backfill compacted to 93 % (100 % for sand) of MDD (areas subject to traffic loads) using material (a) From the excavated trench material m³ 25 (b) From other excavations on Site m³ 10 (c) From approved borrow areas m³ 10 SECTION NO. 2 BILL NO. 2
AutoNDA by SimpleDocs
Backfilling of trenches. When the cable has been laid, inspected and approved and the sand bed cover as specified in the clause on "Sandbed for cables" has been installed, the trench shall be backfilled with soil containing not more than 40% rock or shale which shall be able to pass through a 100 mm sieve and which is approved by the engineer. Where more than 40%, but less than 70% rock occurs, the Contractor shall replace the rock with imported soil. However, should more than 70% rock occur then all the backfilling material shall be imported.

Related to Backfilling of trenches

  • Felling of trees The Authority shall assist the Concessionaire in obtaining the Applicable Permits for felling of trees to be identified by the Authority for this purpose if and only if such trees cause a material adverse effect on the construction, operation or maintenance of the Bus Terminal. The cost of such felling shall be borne by the Authority, and in the event of any delay in felling thereof for reasons beyond the control of the Concessionaire, it shall be excused for failure to perform any of its obligations hereunder if such failure is a direct consequence of delay in the felling of trees. For the avoidance of doubt, the Parties hereto agree that the felled trees shall be deemed to be owned by the Authority and shall be disposed in such manner and subject to such conditions as the Authority may in its sole discretion deem appropriate.

  • SCHEDULING OF THE WORK The number of working days stipulated for this Contract is 5. These working days shall be consecutive. The Contractor is not required to submit a schedule for this project. Liquidated damages will be assessed beyond the number of working days specified above as well as the completion date as noted in this tender form and agreement. The Contractor must advise the Engineer 48 hours in advance of work starting.

  • Vaccination and Inoculation (a) The Employer agrees to take all reasonable precautions, including in-service seminars, to limit the spread of infectious diseases among employees.

  • Staging In addition to the staging categories listed in paragraph 1 of Annex 2-A, this Schedule contains staging categories 20-A, 20-B, PR-1 and PR-130:

  • Provisioning of Line Sharing and Splitter Space 3.2.1 BellSouth will provide ONS with access to the High Frequency Spectrum as follows:

  • Scope of Interconnection Service 1.3.1 The NYISO will provide Energy Resource Interconnection Service to Interconnection Customer at the Point of Interconnection.

  • Provisioning of High Frequency Spectrum and Splitter Space 3.2.1 BellSouth will provide <<customer_name>> with access to the High Frequency Spectrum as follows:

  • Filling of Positions All eligible employees under Section 3 who have made a timely interest bid, and meet the minimum qualifications, shall be given consideration and may be appointed to the opening prior to the consideration of other non-interest bidding applicants and prior to filling the vacancy through other means. The Appointing Authority shall not be arbitrary, capricious, or discriminatory and must have a legitimate business reason to reject all of the interest bidders. Seniority of the interest bidders shall not be a factor in appointing employees from among the interest bidders. All interest bidders shall be notified orally or in writing, which may include electronic mailing, as to the status (either under consideration, acceptance, or rejection) of their interest bid in a timely manner. If the vacancy is not filled by an employee under this Section, then it shall be filled in the following order:

  • Sealing and Marking of Tenders 2.17.1 The Tenderer shall seal the original and each copy of the tender in separate envelopes, duly marking the envelopes as “ORIGINAL” and “COPY.” The envelopes shall then be sealed in an outer envelope.

  • Points of Interconnection and Trunk Types 2.1 Point(s) of Interconnection.

Time is Money Join Law Insider Premium to draft better contracts faster.