Scope of the Project Under this Agreement, the scope of the Project (the “Scope of the Project”) shall mean and include:
SCOPE OF THE WORK The Contractor shall furnish all the materials, perform all of the Work, and do all things required by the Contract Documents.
Reduction in Scope of the Project 16.6.1 If the Concessionaire shall have failed to complete any Construction Works on account of Force Majeure or for reasons solely attributable to the Authority, the Authority may, in its discretion, require the Concessionaire to pay 80% (eighty percent) of the sum saved therefrom, and upon such payment to the Authority, the obligations of the Concessionaire in respect of such works shall be deemed to have been fulfilled. For the avoidance of doubt, it is agreed that in the event such reduction in Scope of the Project causes or will cause a reduction in net after-tax return of the Concessionaire, the Parties shall meet, as soon as reasonably practical, and agree on a full or partial waiver of the aforesaid payment of 80% (eighty per cent) so as to place the Concessionaire in the same financial position as it would have enjoyed had there been no reduction in Scope of the Project. It is further agreed that the liability of the Authority under this Clause 16.6 shall not extend beyond waiver of the aforesaid 80% (eighty per cent). It is also agreed that in the event of a dispute, the Dispute Resolution Procedure shall apply.
Development of the Project 4.1 TSP's obligations in development of the Project: Subject to the terms and conditions of this Agreement, the TSP at its own cost and expense shall observe, comply with, perform, undertake and be responsible:
Construction Development of the Project The Allottee has seen the proposed layout plan/demarcation-cum-zoning/sanctioned plans, / site plan / building plan, specifications, amenities and facilities, etc. depicted in the advertisement / brochure / agreement / website (as the case may be) regarding the Project where the Said Independent Floor for residential usage along with parking is located and has accepted the floor / site plan, Payment Plan and the specifications, amenities, facilities, etc. [annexed along with this Agreement] which has been approved by the competent authority, as represented by the Promoter. The Promoter shall develop the Project in accordance with the bye-laws such as Haryana Building Code, 2017, FAR, density norms, provisions prescribed, approved plans, terms and condition of the license/ allotment as well as registration of RERA, etc. Subject to the terms in this Agreement, the Promoter undertakes to strictly abide by such plans approved by the competent authorities and shall also strictly abide by the provisions and norms prescribed by the relevant State laws and shall not have an option to make any variation/ alteration/ modification in such plans, other than in the manner provided under the Act and Rules made thereunder or as per approvals/instructions/ guidelines of the competent authorities, and any breach of this term by the Promoter shall constitute a material breach of the Agreement.
Development of the Property Except as modified by this Agreement, the Development and the Property will be developed in accordance with all applicable local, state, and federal regulations, including but not limited to the City’s ordinances and the zoning regulations applicable to the Property, and such amendments to City ordinances and regulations that that may be applied to the Development and the Property under Chapter 245, Texas Local Government Code, and good engineering practices (the “Applicable Regulations”). If there is a conflict between the Applicable Regulations and the Development Standards, the Development Standards shall control.
Description of the Project THIS SHOULD BE NO MORE THAN A TWO PARAGRAPH DESCRIPTION THAT PROVIDES A BACKGROUND OF THE PROBLEM, AS WELL AS HOW THE CONTRACTOR INTENDS TO SOLVE THE PROBLEM. KEEP IN MIND THAT THE CONTRACT SHOULD “STAND ON ITS OWN,” I.E. ANYONE SHOULD BE ABLE TO PICK IT UP AND FIGURE OUT WHAT IS GOING ON.)
In-Scope Projects Project Based Information Technology (IT) Consulting Services required by an Authorized User must be obtained via a Mini-Bid process under this Contract. The Authorized User shall issue a Mini-Bid with a SOW for the required Project Based IT Consulting Services. A Mini-Bid may include, but will not be limited to, projects requiring: analysis, data classification, design, development, testing, quality assurance, security and associated customized training for IT based applications. Additional examples of in-scope projects include, but are not limited to: Technical architecture advisory services; Business analysis for project development; Proprietary software application development/customization, programming and integration; Data information management (including data migration, data conversion, data manipulation, data integration); Project management project support services - including, but not limited to; project management, project quality assurance and control, and Independent Verification & Validation (IV&V); Disaster recovery/business continuity and testing; Quality assurance; Continuity of operations planning (COOP); Data categorization; and Open-source software implementation. Out-of-Scope Work There are service offerings expressly excluded from the scope of these contracts. In many instances, such services and/or offerings are (or will be) covered by another OGS Centralized Contract. Examples include: Staff augmentation services; Time and material services; Web hosting; Automated network monitoring or any other service provided principally through an automated process; Hardware maintenance and support; Software maintenance and support; Ongoing maintenance and support; Services priced on a per asset basis; Services priced on a contingency basis; Equipment maintenance; Prepackaged training courses; E-Learning; Managed services; Acquisition of equipment (hardware) Acquisition of software, either Commercial off-the-shelf (COTS) software or pre-existing software; Acquisition of non-consulting services, such as network provisioning, voice services (local, long- distance), or video bridging; Cloud based or “As a Service” offerings, including but not limited to SaaS, IaaS, PaaS, and XaaS; Any offering that is a combination of equipment, hardware, software, cloud or “as a service offerings”; and Consulting or other installation work which is considered Public Works is excluded from purchase under the scope of this Contract. Historically, the New York State Bureau of Public Works has maintained that installation, maintenance and repair of equipment attached to any wall, ceiling or floor or affixed by hard wiring or plumbing is public work. In contrast, installation of a piece of equipment which is portable or a “plug-in” free-standing unit would not be considered public work. Thus, this Contract does not authorize installation where the equipment becomes a permanent part of the building structure, or is otherwise incorporated into the fabric of the building (i.e. installation on a wall, ceiling or floor in a fixed location, or affixed by hard- wiring or plumbing). See Appendix A, Clause 6, Wage and Hours Provisions. For questions about whether a proposed work constitutes public work, please contact the New York State Department of Labor’s Bureau of Public Work District Office in a specific area. A listing of district offices and contact information is available at xxxx://xxx.xxxxx.xx.xxx/workerprotection/publicwork/PWContactUs.shtm. Definitions Additional definitions applicable to this Contract can be found in Appendix B. Term Definition Authorized User Agreement The document resulting from the transactional Mini-Bid process, which sets forth the specifics regarding the services to be provided by the Contractor to the Authorized User, under the Project Based Information Technology Consulting Contract. Best Value The basis for awarding all service and technology contracts to the offerer that optimizes quality, cost and efficiency, among responsive and responsible offerers. Such basis shall be, wherever possible, quantifiable (State Finance Law §163 (1) (j)). Billing Contact The name, phone number, e-mail, and billing address a customer uses on a xxxx for contact information. Consultant Disclosure Legislation Chapter 10 of the Laws of 2006 amends State Finance Law § 8 and § 163 by requiring: that the Office of the State Comptroller (OSC) include in the Consulting Services Report it compiles annually on contracts issued by state agencies for consulting services during the previous fiscal year. xxxx://xxx.xxx.xxxxx.xx.xx/agencies/guide/MyWebHelp/Content/XI/18/C.htm Deliverables All services or products created during the performance or provision of Services hereunder or identified as a “Deliverable” in an applicable Mini-Bid. A Deliverable is a building block of an overall project. For the purposes of this Solicitation and the resulting Contract, a deliverable shall not be set forth as a status report, meeting attendance, a block of staff hours, or an invoice submission. Fixed Price Authorized User Agreement An agreement pursuant to the Centralized Contract that provides for a fix cost for a defined project. Government Contract A contract let by a Federal, State, or Local governmental body within the continental United States. Government Entity An entity at the federal, state, county, city or provincial level. Joint Venture A contractual agreement joining together two or more business enterprises for the purpose of performing on a State Contract. Knowledge Transfer The transfer of knowledge from the Contractor to the Authorized User. Knowledge Transfer can include full written system documentation including all system changes, training classes, manuals and other items. Depending on the scope of the transaction, there may or may not be a deliverable cost associated. All materials will be the property of the Authorized User unless specifically negotiated during the award process. May Denotes the permissive in a contract clause or specification. Refers to items or information that the State has deemed are worthy of obtaining, but not required or obligatory. Also see “Should”. Mini-Bid A type of Bid Document used by the Authorized User to obtain Services under the Project Based IT Consulting Services Contracts. Not To Exceed Rates (NTE) Refers to the New York State contract price set forth in Appendix D. Amounts proposed by the Contractor at the transactional level shall not exceed the hourly rates provided under this Contract (which will be defined values in US Dollars). Prime Contractor For the purposes of Technical qualifications, the business entity with whom a government entity directly has a contract. Project Based IT Consulting Services An OGS Centralized Contract which will provide a set of standardized terms and conditions, guidelines, processes, and templates for the development, distribution and award of specific deliverable-based and fixed-price Information Technology projects. Project Plan A formal, approved document used to guide both project execution and project control. The primary uses of the project plan are to document planning assumptions and decisions, facilitate communication among stakeholders, and document approved scope, cost, and schedule baselines. Retainage A portion of the Authorized User and Contractor fixed-price agreement amount that is held back by the Authorized User until the deliverable or project is satisfactorily finished. Should Denotes the permissive in a contract clause or specification. Refers to items or information that the State has deemed are worthy of obtaining, but not required or obligatory. Also see “May”. Term Definition Solicitation A non-competitive periodic recruitment solicitation (“Solicitation”) for vendors that provide Project Based Information Technology Consulting Services. Vendor An enterprise that sells goods or services. Vendor Submission The complete response to this Solicitation submitted by a Vendor to provide, as applicable , the Product and services described in the Solicitation
of the Project III. 2 – Performance obligations
Completion of the Project The Contracting Party shall complete the construction, equipping and furnishing of the Improvements in accordance with the Plans and submit to the Board a Certificate of Completion on or before November 1, 2016.
