Capacity Multiplier Sample Clauses

Capacity Multiplier. The capacity multiplier shall be the greater of 1 or the multiplier arrived at by applying the following formula: M(1) = 1 + [0.6[BTUH/33-1]]
AutoNDA by SimpleDocs
Capacity Multiplier. M1 The Capacity Multiplier, M1, is an adjusting multiplier to the Minimum Cooling Charge to account for an installed cooling capacity greater than the Design Criteria of 36 BTU/Hr-Sq Ft of Floor Area in accordance with Exhibit C. M1 shall be the greater of 1 or the multiplier derived by applying the following formula: M1 = 1 + 0.69 x [(BTU/36) - 1]

Related to Capacity Multiplier

  • Maximum Leverage Permit, as of any fiscal quarter end, the ratio of (a) Adjusted Portfolio Equity as of such fiscal quarter end to (b) Funded Debt as of such fiscal quarter end, to be less than 5.00 to 1.00.

  • Adjustment of Minimum Quarterly Distribution and Target Distribution Levels (a) The Minimum Quarterly Distribution, First Target Distribution, Second Target Distribution, Third Target Distribution, Common Unit Arrearages and Cumulative Common Unit Arrearages shall be proportionately adjusted in the event of any distribution, combination or subdivision (whether effected by a distribution payable in Units or otherwise) of Units or other Partnership Securities in accordance with Section 5.10. In the event of a distribution of Available Cash that is deemed to be from Capital Surplus, the then applicable Minimum Quarterly Distribution, First Target Distribution, Second Target Distribution and Third Target Distribution, shall be adjusted proportionately downward to equal the product obtained by multiplying the otherwise applicable Minimum Quarterly Distribution, First Target Distribution, Second Target Distribution and Third Target Distribution, as the case may be, by a fraction of which the numerator is the Unrecovered Capital of the Common Units immediately after giving effect to such distribution and of which the denominator is the Unrecovered Capital of the Common Units immediately prior to giving effect to such distribution.

  • Maximum or Minimum Interest Rate If specified on the face hereof, this Note may have either or both of a Maximum Interest Rate or a Minimum Interest Rate. If a Maximum Interest Rate is so designated, the interest rate for a Floating Rate Note cannot ever exceed such Maximum Interest Rate and in the event that the interest rate on any Interest Reset Date would exceed such Maximum Interest Rate (as if no Maximum Interest Rate were in effect) then the interest rate on such Interest Reset Date shall be the Maximum Interest Rate. If a Minimum Interest Rate is so designated, the interest rate for a Floating Rate Note cannot ever be less than such Minimum Interest Rate and in the event that the interest rate on any Interest Reset Date would be less than such Minimum Interest Rate (as if no Minimum Interest Rate were in effect) then the interest rate on such Interest Reset Date shall be the Minimum Interest Rate. Notwithstanding anything to the contrary contained herein, the interest rate on a Floating Rate Note shall not exceed the maximum interest rate permitted by applicable law.

  • Performance Measure The number of Performance Shares earned at the end of the three-year Performance Period will vary depending on the degree to which cumulative adjusted earnings per share performance goals for the Performance Period, as established by the Committee, are met.

  • Measurement Period (b) In this Agreement, unless the contrary intention appears, a reference to:

  • Maximum Senior Leverage Ratio Borrower and its Subsidiaries on a consolidated basis shall have, at the end of each Fiscal Quarter set forth below, a Senior Leverage Ratio as of the last day of such Fiscal Quarter and for the 12-month period then ended of not more than the following:

  • Maximum Leverage Ratio As of the last day of each fiscal quarter, the Borrower shall not permit the ratio (the "Leverage Ratio") of (i) Consolidated Funded Indebtedness to (ii) EBITDA of the Borrower and its Subsidiaries, as at the end of and for the period of four consecutive fiscal quarters ending on such day, to be greater than (i) 2.00 to 1.00.

  • Calculation Dates The interest rate applicable to each Interest Reset Period will be determined by the Calculation Agent on or prior to the Calculation Date (as defined below), except with respect to LIBOR, which will be determined on the particular Interest Determination Date. Upon request of the Holder of a Floating Rate Note, the Calculation Agent will disclose the interest rate then in effect and, if determined, the interest rate that will become effective as a result of a determination made for the next succeeding Interest Reset Date with respect to such Floating Rate Note. The “Calculation Date”, if applicable, pertaining to any Interest Determination Date will be the earlier of: (1) the tenth calendar day after the particular Interest Determination Date or, if such day is not a Business Day, the next succeeding Business Day; or (2) the Business Day immediately preceding the applicable Interest Payment Date or the Maturity Date, as the case may be.

  • Performance Period For purposes of this Agreement, the term “Performance Period” shall be the period commencing on January 29, 2018 and ending on January 29, 2021.

  • Maximum Total Leverage Ratio Permit the Total Leverage Ratio as of the end of any fiscal quarter ending on or after September 30, 2006, to be greater than the ratio set forth below opposite the fiscal quarter end: Fiscal Quarter Ending Ratio on or prior to December 31, 2008 6.50 to 1.0 thereafter but on or prior to December 31, 2010 6.00 to 1.0 after December 31, 2010 5.50 to 1.0

Time is Money Join Law Insider Premium to draft better contracts faster.