Capital Metro Point of Contact (POC) Sample Clauses

Capital Metro Point of Contact (POC). Capital Metro has multiple operation facilities and, as a result, the PSA is prevented from directly supervising daily operation of all security personnel. In situations such as this, Capital Metro’s Public Safety Management personnel will be appointed as POCs to oversee and direct daily activity for some (not all) facilities or as needed. The Capital Metro POC will rely on the account manager or rover supervisor to direct and supervise the daily activities of the security personnel. When an issue arises that can’t be resolved, the account manager or security personnel may seek the direction of the Capital Metro POC.
AutoNDA by SimpleDocs

Related to Capital Metro Point of Contact (POC)

  • Single Point of Contact When a problem is experienced, regardless of the severity, the BellSouth Network Management Center (NMC) will observe traffic anomalies and begin monitoring the situation. Controls will be appropriately applied to insure the sanity of BellSouth's network; and, in the event that a switch or facility node is lost, the NMC will attempt to circumvent the failure using available reroutes. BellSouth's NMC will remain in control of the restoration efforts until the problem has been identified as being a long-term outage. At that time, the NMC will contact BellSouth's Emergency Control Center (ECC) and relinquish control of the recovery efforts. Even though the ECC may take charge of the situation, the NMC will continue to monitor the circumstances and restore traffic as soon as damaged network elements are revitalized. The telephone number for the BellSouth Network Management Center in Atlanta, as published in Telcordia’s National Network Management Directory, is 000-000-0000.

  • Primary Point of Contact Except as otherwise provided in this Agreement, CLEC shall be the primary point of contact for all CLEC Customers.

  • Point of Contact (09/17) Contractor shall be the sole point of contact for the City with regard to this Contract and the System.

  • Contact Point 1. Each Party shall designate a contact point to facilitate communications between the Parties on any matter covered by this Agreement.

  • Contact Points 1. Each Party shall designate a contact point to facilitate communications between the Parties on any matter covered by this Agreement. 2. Upon request of the other Party, the contact point shall identify the office or official responsible for the matter and assist, as necessary, in facilitating communication with the requesting Party. Contact points shall work jointly to develop agendas and make other preparations for the Free Trade Commission meetings and follow-up on the Free Trade Commission's decisions as appropriate; provide administrative support to the Panels established under Chapter 15 (Dispute Settlement) and address any other matter entrusted by the Free Trade Commission.

  • Establishment of Point of Interconnection The point where the electric energy first leaves the wires or facilities owned by the Cooperative and enters the wires or facilities provided by DG Owner/Operator is the "Point of Interconnection." Cooperative and DG Owner/Operator agree to interconnect the Facilities at the Point of Interconnection in accordance with the Cooperative's Rules and Regulations and DG Manual relating to interconnection of Distributed Generation (the "Rules") and as described in the attached Exhibit A. The interconnection equipment installed by the customer ("Interconnection Facilities") shall be in accordance with the Rules as well.

  • Energy Resource Interconnection Service (ER Interconnection Service).

  • Network Resource Interconnection Service 4.1.2.1 The Product

  • Point of Interconnection The Point of Interconnection shall be as identified on the one-line diagram attached as Schedule B to this ISA.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!